Opens in a new tab

TLA2024IRUGT

12-bit 4ch delta-sigma ADC, PGA x1-16, I2C, int ref, X2QFN 2×1.5mm, T/R

1380

Effective Inventory

Image for reference only

Manufacturer Part:

TLA2024IRUGT

Package:

10-X2QFN (2.05 x 1.55 x 0.35 mm, 0.5mm pitch, leadless)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

The TLA2024IRUGT from Texas Instruments is a 12-bit 4-channel delta-sigma ADC with I2C interface in a 10-pin X2QFN package (2.0 x 1.5 mm). It features a flexible input multiplexer (4 single-ended or 2 differential), programmable gain amplifier (1x/2x/4x/8x to x16), internal voltage reference, internal oscillator, 128 SPS to 3.3 kSPS data rate, 150 uA supply current, 2V to 5.5V supply range, and 3 pin-selectable I2C addresses. Single-shot or continuous conversion. 0.9 mW typical power consumption. Operating temperature -40C to +85C. Tape-and-reel packaging.

Product Introduction: TLA2024IRUGT Product Introduction

The TLA2024IRUGT from Texas Instruments is an ultra-small, cost-optimized 12-bit delta-sigma ADC with 4-channel input multiplexer and programmable gain amplifier in a 10-pin X2QFN package measuring just 2.0 x 1.5 mm. It is the highest-channel-density variant of the TLA202x family, offering 4 single-ended or 2 differential input channels at only 0.75 mm2 per channel.

The TLA2024 features a flexible input multiplexer that can be configured as four single-ended inputs (AIN0-GND, AIN1-GND, AIN2-GND, AIN3-GND) or two differential input pairs (AIN0-AIN1, AIN2-AIN3). The multiplexer is software-configurable via the I2C interface, allowing sequential scanning of multiple input channels.

The integrated programmable gain amplifier (PGA) provides gain settings of x1, x2, x4, x8, and x16 (note: some sources list up to x16 while others list x8 maximum). At maximum PGA gain, the input range is reduced to +/-256 mV (at x8) or +/-128 mV (at x16), enabling direct measurement of small signals from current sense resistors, thermocouples, and bridge sensors without external amplification. The PGA has input ranges from +/-6.144V (x1) down to +/-256 mV (x8).

The device integrates a voltage reference, oscillator, and I2C interface. The internal 2.048V reference provides the ADC full-scale reference. The I2C interface supports standard mode and fast mode, with three pin-selectable addresses.

The TLA2024 provides 12-bit resolution with programmable data rates from 128 SPS to 3.3 kSPS. The delta-sigma architecture provides inherent anti-aliasing and good noise performance. INL is 1 LSB typical, and full-scale error is 0.05% FSR typical. No missing codes are guaranteed to 12 bits.

The 0.9 mW typical power consumption and single-shot conversion mode make the TLA2024 suitable for power-constrained applications. In single-shot mode, the device automatically powers down after each conversion, reducing average current to microamps at low sampling rates.

The X2QFN package has a land pattern of only 3 mm2, making it the industry’s smallest 4-channel 12-bit ADC. This enables placement directly at sensor nodes in space-constrained systems.

The TLA2024 shares the same datasheet (SBAS975) with the TLA2021 and TLA2022. The key differences are: TLA2021 = 1-channel, no PGA; TLA2022 = 1-channel with PGA; TLA2024 = 4-channel with PGA and MUX.

Working Principle: TLA2024IRUGT Working Principle

**Delta-Sigma ADC with PGA and MUX:** The input signal first passes through the analog multiplexer, which selects one of four single-ended or two differential input configurations. The selected signal is then amplified by the PGA, digitized by the delta-sigma modulator, and filtered by the SINC digital decimation filter to produce a 12-bit output word.

**Input Multiplexer:** The 4:1 (single-ended) or 2:1 (differential) multiplexer is controlled by the MUX[2:0] bits in the configuration register. Channel switching requires a settling time before the conversion result is valid, typically one conversion cycle.

**PGA Operation:** The PGA amplifies the input signal before the modulator. At x1 gain, the full-scale input range is +/-6.144V (well beyond VDD, but limited by absolute maximum ratings to VDD+0.3V). At x2: +/-4.096V. At x4: +/-2.048V. At x8: +/-1.024V (some sources: +/-256mV). Higher gain reduces the input range but improves the effective resolution for small signals. The PGA input common-mode range must be within GND-0.1V to VDD+0.1V.

**Conversion and Data Format:** The 12-bit conversion result is output in 16-bit two’s complement format, left-justified. At PGA = x1, 1 LSB = 187.5 uV (6.144V / 32768). At PGA = x8, 1 LSB = 23.4 uV (1.024V / 32768, if 12-bit effective).

**I2C Protocol:** Write to the 16-bit configuration register to set MUX, PGA, mode, and data rate. Read 2 bytes (16 bits) for conversion result. The OS bit starts a single-shot conversion when written as 1. The ALERT/RDY pin can signal conversion completion or out-of-range conditions.

Pin Description: TLA2024IRUGT Pin Definition and Functions
Pin Name Type Description
A1 AIN0 I Analog input 0; positive input for differential pair 0; single-ended input 0; 0 to VDD range; MUX selectable
A2 AIN1 I Analog input 1; negative input for differential pair 0; single-ended input 1; 0 to VDD range; MUX selectable
B1 GND G Ground; connect to PCB ground plane
B2 ADDR I I2C address select; GND = 0x48; VDD = 0x49; SDA = 0x4A; must be tied to defined state
C1 SDA I/O I2C data; open-drain; requires external pull-up (4.7kOhm typical); fast-mode compatible
C2 SCL I I2C clock; requires external pull-up (4.7kOhm typical); up to 400kHz
D1 ALERT/RDY O Alert/Ready output; active-low open-drain; conversion complete or comparator threshold exceeded; connect pull-up if used
D2 VDD P Supply voltage; 2V to 5.5V; decouple with 0.1uF ceramic to GND
Application Scenarios: In which products and applications is TLA2024IRUGT used
Application Description
Multi-Sensor System Monitor Monitor 4 system voltages simultaneously (battery, 3.3V rail, 5V rail, 12V rail); resistor dividers scale voltages to 2.048V range; MUX sequences through channels; I2C reports to system controller; single X2QFN replaces 4 discrete comparators
Current Sensing with Shunt Resistor Measure voltage across current sense resistor using differential input pair; PGA x8 amplifies millivolt-level shunt voltage; 12-bit resolution provides 23uV LSB at x8; monitor 2 current channels with 2 differential pairs
Portable Instrument Front-End Measure 4 sensor channels in handheld instrument; ultra-small X2QFN fits in pen-sized housing; 150uA current draw preserves battery; single-shot mode at 10 SPS reduces average current to microamps; I2C interface to low-power MCU
Alternative Models: What chips are recommended as replacements for TLA2024IRUGT
Model Manufacturer Compatibility Key Difference
TLA2021IRUGT TI 1-Channel No PGA 12-bit 1-channel; no PGA; same X2QFN-10; lower cost for single-channel applications; use when only 1 input needed and no small-signal amplification
TLA2022IRUGT TI 1-Channel With PGA 12-bit 1-channel with PGA; same X2QFN-10; use when only 1 input but PGA needed for small-signal measurement
ADS1115IDGSR TI Higher Performance Alternative 16-bit 4-channel ADC; PGA x1-x8; I2C; VSSOP-10; higher resolution; larger package; TI-sourced; use when 12-bit is insufficient

Recommend Parts

RK73B2ATTD100J

10Ohm +/-5% 0.125W thick film resistor, 0805, +/-200 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0805 (2012 Metric) 2.0 x 1.25 x 0.55 mm

IN STOCK: 26435pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPL5010DDCR

Nano-power watchdog timer with power good, SOT-23-6

Brand: TI

Package: SOT-23-6 (2.9 x 1.6 x 1.1 mm, DDC package)

IN STOCK: 12122pcs

Cargo cycle: 3-7 Days

The minimum order is 1

NCP302045MNTWG

45V 5A programmable overcurrent protection switch, 50mΩ Ron, -60V reverse polarity, DFN-8

Brand: ON

Package: DFN-8 (3x3mm, 0.65mm pitch)

IN STOCK: 4759pcs

Cargo cycle: 3-7 Days

The minimum order is 1

WS2811

3-channel LED driver IC with built-in oscillator, SOP-8

Brand: Worldsemi

Package: SOP-8 (5.2 x 4.0 mm)

IN STOCK: 7374pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AD9912ABCPZ

1GSPS direct digital synthesizer with 14-bit DAC, LFCSP-64

Brand: ADI

Package: LFCSP-64 (9.0 x 9.0 mm, BCPZ package)

IN STOCK: 3719pcs

Cargo cycle: 3-7 Days

The minimum order is 1