Opens in a new tab

TCAN1043DMTRQ1

Automotive CAN FD transceiver, 5Mbps, +/-58V fault prot, bus wake, INH, VSON-14, -55-125C

12734

Effective Inventory

Image for reference only

Manufacturer Part:

TCAN1043DMTRQ1

Package:

VSON-14 / DMT (4.5 x 3.0 x 1.0 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The TCAN1043DMTRQ1 from Texas Instruments is an AEC-Q100 Grade 1 qualified CAN FD transceiver supporting data rates up to 5 Mbps. It features CAN bus wake-up, standby and sleep modes with INH output, VIO level shifting for 3.3V MCU interfacing, and +/-58V bus fault protection in a VSON-14 (4.5x3mm) package.

Key Specifications

Type CAN FD Transceiver (Automotive)
Standard ISO 11898-2:2016
Data Rate Up to 5 Mbps (CAN FD)
Supply Voltage VCC 4.5V – 5.5V
Logic Voltage VIO 2.8V – 5.5V
Bus Fault Protection +/-58V
Common-Mode Range -30V to +30V
Modes Normal, Standby, Sleep
Wake-Up CAN bus remote + local WAKE pin
INH Output Yes (controls external voltage regulator)
Standby Current < 15 uA
ESD Protection +/-8 kV IEC 61000-4-2 on bus
Package VSON-14 (DMT, 4.5 x 3 mm)
Operating Temp -55 to 125 C (AEC-Q100 Grade 1)

Features

  • AEC-Q100 Grade 1 qualified for automotive applications (-55 to 125 C)
  • CAN FD data rates up to 5 Mbps with short symmetrical propagation delays
  • VIO level shifting supports 2.8V to 5.5V for direct 3.3V MCU connection
  • Sleep mode with INH output for system-level power management
  • CAN bus remote wake-up and local WAKE pin for flexible wake sources
  • +/-58V bus fault protection for 24V truck/industrial systems
  • +/-8 kV IEC ESD protection on bus pins without external components
  • Typical loop delay of 110 ns for enhanced timing margin

Applications

  • Automotive ECU CAN FD communication
  • 12V/24V truck and heavy vehicle CAN (J1939)
  • Battery management system CAN networks
  • Gateway and diagnostic CAN interfaces
  • Low-power automotive body electronics
Product Introduction: TCAN1043DMTRQ1 Product Introduction

The TCAN1043DMTRQ1 from Texas Instruments is an AEC-Q100 Grade 1 qualified high-speed CAN FD transceiver supporting data rates up to 5 Mbps. It features three operating modes: Normal, Standby, and Sleep. In Sleep mode, VCC and VIO can be powered down while the device monitors the CAN bus via an internal low-power receiver; when a wake-up pattern is detected on the bus or via the local WAKE pin, the INH output drives high to enable the external voltage regulator, initiating node start-up. A separate VIO pin supports 2.8V to 5.5V logic levels, enabling direct 3.3V MCU interfacing without level translation.

Working Principle: TCAN1043DMTRQ1 Working Principle

The TCAN1043DMTRQ1 converts between MCU logic levels (VIO-referenced) and CAN bus differential signal levels. In Normal mode, it operates as a standard CAN transceiver with optimized symmetric bus outputs for minimal EMI. In Standby mode, the driver is disabled and a low-power receiver monitors the bus for a valid wake-up pattern; RXD asserts low when a wake-up is detected. In Sleep mode, all internal circuitry is powered down except the wake detection logic, drawing less than 15 uA. The INH pin is an open-drain output that drives an external voltage regulator enable pin; it is active in Normal and Standby modes, and deasserted in Sleep mode until a wake event occurs. The VIO terminal provides internal logic level translation, allowing TXD, RXD, and STB pins to operate at 3.3V while VCC is 5V.

Pin Description: TCAN1043DMTRQ1 Pin Definition and Functions
Pin Name Type Function
1 TXD Input Transmit data from MCU (VIO-referenced)
2 GND Ground Ground
3 VCC Power 5V transceiver supply
4 RXD Output Receive data to MCU (VIO-referenced)
5 VIO Power Logic I/O supply (2.8-5.5V)
6 CANL I/O CAN bus low-side line
7 CANH I/O CAN bus high-side line
8 STB Input Standby/sleep mode control (VIO-referenced)
9 EN Input Enable control (VIO-referenced)
10 INH Output Inhibit output (controls external regulator)
11 nERR Output Error flag output (VIO-referenced)
12 WAKE Input Local wake-up input
13 SPLIT Output Common-mode stabilization output
14 GND Ground Ground (exposed pad)
Application Scenarios: In which products and applications is TCAN1043DMTRQ1 used
  • Automotive CAN: ECU CAN FD networks up to 5 Mbps with system-level power management
  • Truck J1939: +/-58V fault protection for 24V heavy vehicle systems
  • Low-power nodes: Sleep mode with bus/local wake for always-on battery systems
  • Battery management: INH-controlled regulator for BMS CAN communication
  • 3.3V MCU interface: VIO pin enables direct connection without level shifters
Alternative Models: What chips are recommended as replacements for TCAN1043DMTRQ1
Manufacturer Part Number Package Notes
NXP TJA1463AT SOIC-14 CAN FD, 5Mbps, bus wake, +/-58V
TI TCAN1044DMTRQ1 VSON-14 Enhanced, CAN FD, similar features
Infineon TLE9251VSJ SOIC-14 CAN FD, 5Mbps, bus wake
Microchip MCP2562FD-E/SN SOIC-8 CAN FD, 8Mbps, VIO pin

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1