Opens in a new tab

TPS61230DRCR

5A sync boost, 2.3-5.5V in, 2.5-5.5V out, 2MHz, 96% eff, VSON-10

3375

Effective Inventory

Image for reference only

Manufacturer Part:

TPS61230DRCR

Package:

VSON-10 (3.0 x 3.0 x 0.9 mm, DRC package)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The TPS61230DRCR from Texas Instruments is a 5A switch high-efficiency synchronous boost converter with 2.3-5.5V input and 2.5-5.5V adjustable output, operating at 2MHz in a 3x3mm VSON package.

Key Specifications

Topology Synchronous Boost
Input Voltage 2.3V to 5.5V
Output Voltage 2.5V to 5.5V (adjustable)
Switch Current 5A (integrated)
Output Current 2.1A (3.3V to 5V conversion)
Switching Frequency 2MHz (quasi-constant on-time)
Efficiency Up to 96%
Quiescent Current 30uA (typ, PFM mode)
Shutdown Current 1.5uA (typ, load disconnected)
Package VSON-10 (3.0 x 3.0 x 0.9mm)
Operating Temperature -40 to +85 C

Features

  • 5A integrated switch for high output current
  • 2.1A output from 3.3V to 5V
  • Synchronous rectification for high efficiency
  • Power save mode for light-load efficiency
  • True load disconnect during shutdown
  • Adjustable EN threshold with hysteresis
  • Output overvoltage protection
  • Programmable soft-start
  • Power-good output

Applications

  • Single-cell Li-Ion to 5V USB power
  • Power banks and backup batteries
  • USB OTG power supply
  • Tablet and portable device power
Product Introduction: TPS61230DRCR Product Introduction

The TPS61230DRCR from Texas Instruments is a high-efficiency synchronous boost converter with an integrated 5A switch, optimized for single-cell Li-Ion battery or 3.3V rail to 5V USB power conversion. The device can deliver up to 2.1A output current when converting from 3.3V input to 5V output, making it suitable for USB OTG, power bank, and portable device applications. The synchronous rectification eliminates the external Schottky diode, reducing component count and improving efficiency up to 96%. The quasi-constant on-time valley current mode control provides fast transient response and stable operation across the input/output voltage range. The 2MHz switching frequency allows the use of small external inductors (1.0uH typical) and capacitors, minimizing solution size. At light loads, the device automatically enters power save mode (PFM) to maintain high efficiency with only 30uA quiescent current. In shutdown mode, the load is completely disconnected from the input with only 1.5uA input current, preserving battery life. The EN pin features an adjustable threshold with programmable hysteresis, allowing custom power-on/power-off voltage levels for battery monitoring. Output overvoltage protection, programmable soft-start, and a power-good indicator provide comprehensive system protection. The compact 3x3mm VSON-10 package minimizes board space.

Working Principle: TPS61230DRCR Working Principle

The TPS61230DRCR operates as a synchronous boost converter using quasi-constant on-time valley current mode control. Key subsystems include: (1) Quasi-Constant On-Time Control – the high-side switch on-time is approximately constant (adjusted by input/output voltage ratio); the off-time is modulated to regulate the output; this control scheme provides fast transient response and eliminates the need for external loop compensation; (2) Valley Current Mode – the low-side switch current is sensed at the valley (before turn-on); when the valley current falls below the error amplifier output threshold, the next on-time begins; this provides inherent current limiting and cycle-by-cycle protection; (3) Synchronous Rectification – an integrated low-side NMOS replaces the external Schottky diode; during the off-time, the low-side MOSFET conducts the inductor current to the output with lower voltage drop than a diode, improving efficiency; (4) Power Save Mode – at light loads, the device enters PFM mode where switching pulses are spaced apart to reduce switching losses; the output voltage ripple increases slightly in PFM mode; (5) Load Disconnect – in shutdown, both high-side and low-side MOSFETs are off, disconnecting the output from the input; this prevents battery drain when the device is disabled; (6) Adjustable EN Threshold – the EN pin connects to an internal comparator; external resistors from VIN to EN and EN to GND set the enable threshold voltage and hysteresis for custom battery undervoltage lockout.

Pin Description: TPS61230DRCR Pin Definition and Functions
Pin Name Function
1 VIN Input supply (2.3V to 5.5V)
2 EN Enable (adjustable threshold with external resistors)
3 FB Output voltage feedback (resistor divider)
4 SS Soft-start (connect capacitor to GND)
5 PG Power-good output (open-drain)
6-7 GND Ground (connect to thermal pad)
8-9 SW Switch node (connect to inductor)
10 VOUT Output voltage (connect output capacitor)
Application Scenarios: In which products and applications is TPS61230DRCR used
  • USB power bank: 3.7V Li-Ion to 5V/2A USB output for charging smartphones
  • USB OTG: 3.3V system rail to 5V/500mA for USB On-The-Go host power
  • Tablet auxiliary: boost 3.3V to 5V for USB peripheral power at 2A
  • Industrial backup: 3.6V backup battery to 5V for system holdup during power fail
Alternative Models: What chips are recommended as replacements for TPS61230DRCR
Manufacturer Part Number Package Notes
TI TPS61232DRCR VSON-10 Fixed 5V output version
TI TPS61231DRCR VSON-10 Adjustable with output discharge
Monolithic Power MP3425DN-LF-Z QFN-14 4.5-22V/3A boost
ADI LTC3426EDE#PBF DFN-10 3A sync boost, 2MHz

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1