Opens in a new tab

LM3940ISX-3.3

1A LDO, 5V-to-3.3V, 500mV dropout, TO-263-3

6904

Effective Inventory

Image for reference only

Manufacturer Part:

LM3940ISX-3.3

Package:

DDPAK/TO-263-3 (10.2 x 8.4 x 4.4 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The LM3940ISX-3.3 from Texas Instruments is a 1A low-dropout regulator specifically designed for 5V to 3.3V conversion in a DDPAK/TO-263-3 surface-mount package. With 500mV typical dropout, 4.5-5.5V input range, and built-in thermal and short-circuit protection, it provides a simple single-component 3.3V supply from a 5V rail.

Key Specifications

Output Voltage 3.3V fixed
Output Current 1A
Input Voltage Range 4.5V to 5.5V (7.5V abs max)
Dropout Voltage 500mV typical @ 1A; 1V max @ 1A
Output Accuracy +/-3% over temperature
Quiescent Current 10-15 mA typical @ 1A
Line Regulation 50 mV max
Load Regulation 50 mV max
Minimum Output Capacitor 33uF (ESR critical, see ESR chart)
Thermal Shutdown Yes (internal)
Short-Circuit Protection Yes (internal current limit)
Operating Temperature -40 to +125 C (junction)
Package DDPAK/TO-263-3 (10.2 x 8.4 mm)
Status Active

Features

  • Purpose-designed for 5V to 3.3V conversion
  • 1A output current with true low dropout
  • Only one external component (33uF output capacitor)
  • Built-in thermal shutdown protection
  • Short-circuit current limiting
  • Output voltage specified over full temperature range
  • TO-263/DDPAK surface-mount package for efficient thermal dissipation

Applications

  • 5V to 3.3V logic level conversion
  • Desktop and laptop computer 3.3V rails
  • Mixed 5V/3.3V system power supplies
  • Industrial controller 3.3V regulation from 5V bus
Product Introduction: LM3940ISX-3.3 Product Introduction

The LM3940ISX-3.3 from Texas Instruments is a 1A low-dropout linear regulator purpose-designed for converting a 5V supply to 3.3V in a DDPAK/TO-263-3 surface-mount package. The ISX denotes the TO-263-3 (DDPAK) package with tape and reel (500 pcs/reel), -3.3 denotes the 3.3V fixed output. Unlike general-purpose LDOs with wide input ranges, the LM3940 is optimized specifically for the 4.5-5.5V input to 3.3V output use case, with a guaranteed minimum input voltage of 4.5V. The 500mV typical dropout at 1A means the device maintains 3.3V regulation down to approximately 3.8V input. The regulator requires only a single 33uF output capacitor as external component, though the capacitor ESR must be within a specified stability window (typically 0.1-10 Ohms at 1A). The TO-263/DDPAK package provides excellent thermal dissipation when soldered to a copper plane on the PCB, often eliminating the need for a separate heatsink at moderate ambient temperatures. Internal thermal shutdown and short-circuit current limiting provide robustness. Also available in SOT-223 (LM3940IMP-3.3) and TO-220 packages.

Working Principle: LM3940ISX-3.3 Working Principle

The LM3940ISX-3.3 operates as a series-pass linear regulator: (1) Pass Element: An internal PNP transistor (or PNP-NPN composite) is connected between VIN and VOUT. The error amplifier drives the base of the pass transistor to maintain VOUT at 3.3V. The PNP structure enables the low dropout voltage (500mV) because the base can be driven lower than VOUT by the error amplifier, unlike NPN-based regulators that require at least 1.5-2V headroom. (2) Voltage Regulation: The error amplifier compares a fraction of VOUT (via an internal resistor divider) with an internal bandgap reference. If VOUT drops below 3.3V, the amplifier increases the pass transistor drive current, reducing VCE and raising VOUT. If VOUT rises above 3.3V, the amplifier reduces drive current. (3) Dropout Behavior: When VIN approaches 3.3V + Vdropout, the pass transistor saturates and can no longer regulate. The output then tracks VIN minus the saturation voltage drop. At 1A load, this dropout is typically 500mV. (4) Stability: The output capacitor and its ESR create a zero in the loop transfer function that is essential for stability. The ESR must be in a specific range (typically 0.1-10 Ohms at full load) to ensure adequate phase margin. Solid tantalum capacitors are recommended for their stable ESR over temperature.

Pin Description: LM3940ISX-3.3 Pin Definition and Functions
Pin Name Type Description
1 VIN Power Input voltage (4.5-5.5V)
2 GND Power Ground (tab and pin)
3 VOUT Power Regulated 3.3V output
Tab GND Power Ground / thermal pad (connected to pin 2)
Application Scenarios: In which products and applications is LM3940ISX-3.3 used
  • 5V to 3.3V logic supply conversion at 1A with only a 33uF tantalum output capacitor and TO-263 copper plane heatsink
  • Laptop computer 3.3V rail from 5V system supply with guaranteed regulation down to 4.5V input
  • Industrial controller 3.3V MCU supply from 5V bus with thermal shutdown protection and short-circuit current limiting
  • Embedded system 5V/3.3V dual-rail design using LM3940 for the 3.3V rail with 500mV dropout headroom
Alternative Models: What chips are recommended as replacements for LM3940ISX-3.3
Model Manufacturer Vout Iout Notes
LM3940IMP-3.3 TI 3.3V 1A SOT-223 package
AMS1117-3.3 Advanced Monolithic 3.3V 1A Popular, 1.1V dropout
LD1117S33CTR STMicro 3.3V 800mA Similar, TO-263
TLV1117LV33DCYR TI 3.3V 1A Lower Iq, SOT-223

Recommend Parts

IRFS4310ZTRLPBF

IRFS4310ZTRLPBF – 100V N-Channel HEXFET Power MOSFET, 7 mΩ RDS(on), D2PAK (TO-263AB)

Brand: infineon

Package: D2PAK (TO-263AB)

IN STOCK: 11137pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MSASJ105BB5475MFNA01

4.7uF 6.3V X5R MLCC, 0402, Taiyo Yuden

Brand: gigadevice

Package: 0402 (1005 Metric, 1.0 x 0.5 x 0.5 mm)

IN STOCK: 9701pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRF3415PBF

150V N-channel power MOSFET, 43A, 41mΩ RDS(on), TO-220AB package

Brand: infineon

Package: TO-220AB

IN STOCK: 2940pcs

Cargo cycle: 3-7 Days

The minimum order is 1

105017-1001

USB Type-C receptacle connector, 24-pin, SMD

Brand: Amphenol

Package: SMD (8.9 x 7.3 x 3.2 mm, right angle)

IN STOCK: 5335pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRLB3034PBF

IRLB3034PBF – 40V N-Channel StrongIRFET Power MOSFET (Logic Level), 1.7 mΩ (max) @ 10V; 2.0 mΩ @ 4.5V RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 9724pcs

Cargo cycle: 3-7 Days

The minimum order is 1

XC6SLX75-2FGG484I

Spartan-6 LX75 FPGA, 74637 logic cells, 132 DSP, 3096KB BRAM, 408 I/O, FBGA-484 23x23mm, -2 speed, industrial -40~100C, AMD Xilinx

Brand: xilinx

Package: FGG484 (484-ball fine-pitch BGA, 23x23mm body, 1.0mm ball pitch, 22×22 ball array, 6 I/O banks, lead-free)

IN STOCK: 890pcs

Cargo cycle: 3-7 Days

The minimum order is 1