Opens in a new tab

LPS22HBTR

Piezo pressure sensor, 260-1260hPa, +/-0.1hPa, I2C/SPI, HCLGA-10

5086

Effective Inventory

Image for reference only

Manufacturer Part:

LPS22HBTR

Package:

HCLGA-10 (2.5 x 2.5 x 0.73 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The LPS22HBTR from STMicroelectronics is an ultra-compact piezoresistive pressure sensor with I2C/SPI output in a 10-pin HCLGA (2.5 x 2.5 x 0.73mm) package. With 260-1260 hPa measurement range, 24-bit resolution, +/-1 hPa relative accuracy, and 12.5uA current consumption, it is designed for barometric pressure and altitude measurement in mobile and wearable devices.

Key Specifications

Sensor Type Piezoresistive absolute pressure
Pressure Range 260 to 1260 hPa
Relative Accuracy +/-0.1 hPa (typical @ 25C, 900-1100hPa)
Absolute Accuracy +/-1 hPa (900-1100hPa, 0-60C)
Resolution 24-bit (0.00025 hPa LSB)
Output Data Rate 1Hz to 75Hz (configurable)
Supply Voltage 1.7V to 3.6V
Supply Current 12.5 uA @ 50Hz ODR; 3 uA @ 1Hz
Power-Down Current 0.5 uA
Interface I2C (up to 1MHz) / SPI (up to 10MHz)
I2C Address 0x5C (SDO=GND) / 0x5D (SDO=VDD)
Temperature Sensor Embedded (+/-2C accuracy)
FIFO 32-slot embedded FIFO
Embedded Functions Low-pass filter, DRDY, FIFO flags
Operating Temperature -40 to +85 C
Package HCLGA-10 (2.5 x 2.5 x 0.73 mm)
Status Active

Features

  • Ultra-compact 2.5 x 2.5 x 0.73mm HCLGA package
  • +/-0.1 hPa relative accuracy for floor-level altitude
  • 24-bit pressure data output
  • Ultra-low 12.5uA current at 50Hz ODR
  • Both I2C and SPI digital interfaces
  • Embedded 32-slot FIFO with multiple modes
  • Embedded temperature sensor
  • Programmable ODR from 1Hz to 75Hz
  • 0.5uA power-down current

Applications

  • Barometric pressure measurement
  • Altitude/floor detection in indoor navigation
  • Weather forecasting
  • Wearable fitness trackers
Product Introduction: LPS22HBTR Product Introduction

The LPS22HBTR from STMicroelectronics is an ultra-compact piezoresistive absolute pressure sensor in a 10-pin HCLGA (holeless ceramic land grid array) package measuring only 2.5 x 2.5 x 0.73mm. The TR denotes tape and reel packaging. The device measures absolute pressure from 260 to 1260 hPa with 24-bit resolution and outstanding +/-0.1 hPa relative accuracy at 25C over the 900-1100 hPa range, enabling floor-level altitude detection in indoor navigation applications. The sensor consists of a MEMS piezoresistive pressure sensing element and an ASIC with signal conditioning, A/D conversion, and digital interface. The ASIC provides temperature compensation, first-level offset calibration, and programmable ODR (1-75Hz). An embedded 32-slot FIFO can store pressure and temperature data in bypass, FIFO, continuous, or watermark modes, reducing host processor read frequency. The embedded temperature sensor provides +/-2C accuracy for additional system temperature monitoring. Both I2C (up to 1MHz) and SPI (up to 10MHz) interfaces are supported. The ultra-low 12.5uA current consumption at 50Hz ODR and 0.5uA power-down mode make it ideal for battery-powered wearables.

Working Principle: LPS22HBTR Working Principle

The LPS22HBTR operates through three subsystems: (1) MEMS Sensing Element: A silicon membrane with embedded piezoresistive elements forms a Wheatstone bridge. Atmospheric pressure deflects the membrane, changing the piezoresistor values and producing a differential voltage proportional to the applied pressure. The membrane is designed to measure absolute pressure relative to a vacuum reference cavity sealed during manufacturing. (2) Signal Conditioning ASIC: The bridge output is amplified by a programmable gain amplifier (PGA), converted to digital by a 24-bit sigma-delta ADC, and processed by a digital filter. Factory-calibrated offset and temperature coefficients are stored in on-chip non-volatile memory and applied in real-time to compensate for process variation and temperature drift. The compensated pressure data is available in hPa units (1 LSB = 1/4096 hPa). (3) Digital Interface: Pressure and temperature data are accessed through I2C or SPI registers. A configurable ODR selects the update rate (1-75Hz). The FIFO accumulates data samples to reduce host polling frequency. The DRDY signal indicates when new data is available. A hardware low-pass filter reduces noise at lower ODRs.

Pin Description: LPS22HBTR Pin Definition and Functions
Pin Name Type Description
1 VDD_IO Power IO supply (1.7-3.6V)
2 SDA/SDI I/O I2C data / SPI MOSI
3 SCL/SPC Input I2C clock / SPI clock
4 SA0/SDO I/O I2C address select / SPI MISO
5 CS Input SPI chip select (I2C mode: tie to VDD)
6 DRDY Output Data ready interrupt
7 INT_DRDY Output Programmable interrupt
8-9 Reserved – Connect to GND
10 GND Power Ground
– VDD Power Analog supply (1.7-3.6V, bottom pad)
Application Scenarios: In which products and applications is LPS22HBTR used
  • Indoor navigation floor detection using +/-0.1hPa relative accuracy to resolve 1-meter altitude changes from barometric pressure readings at 50Hz ODR
  • Wearable fitness tracker barometric altimeter with 12.5uA current, 2.5×2.5mm footprint, and I2C interface to the MCU
  • Weather station barometric pressure sensor with 24-bit resolution, 32-slot FIFO, and SPI interface at 10MHz for high-speed data logging
  • Drone altitude hold using absolute pressure measurement at 75Hz ODR with DRDY interrupt-driven data acquisition
Alternative Models: What chips are recommended as replacements for LPS22HBTR
Model Manufacturer Accuracy Current Notes
LPS22DFTR ST +/-0.1hPa 3.5uA Newer, lower power
LPS27HHWTR ST +/-0.1hPa 18uA Water-resistant package
BMP388 Bosch +/-0.08hPa 2.8uA Competitive accuracy
DPS310 Infineon +/-0.06hPa 3.5uA Higher accuracy option

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1