Opens in a new tab

Home » DC-DC Converters, Integrated Circuits ICs » LT8610ABEMSE#TRPBF

LT8610ABEMSE#TRPBF

42V 2.5A synchronous buck, 2.5MHz, 2.5uA IQ, MSOP-10

8924

Effective Inventory

Image for reference only

Manufacturer Part:

LT8610ABEMSE#TRPBF

Package:

MSOP-10 (3x3mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The LT8610ABEMSE#TRPBF from Analog Devices is a 42V, 2.5A synchronous step-down regulator with 2.5uA quiescent current and 2.5MHz switching in MSOP-10 for automotive and industrial power supplies.

Key Specifications

Package MSOP-10 (3x3mm)

Features

  • See datasheet for complete specifications
  • Industry-standard package

Applications

  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
Product Introduction: LT8610ABEMSE#TRPBF Product Introduction

The LT8610ABEMSE#TRPBF from Analog Devices is a 42V, 2.5A synchronous step-down regulator with 2.5uA quiescent current and 2.5MHz switching in MSOP-10 for automotive and industrial power supplies.

Working Principle: LT8610ABEMSE#TRPBF Working Principle

The LT8610ABEMSE#TRPBF is a 42V 2.5A synchronous step-down regulator from Analog Devices in MSOP-10, with 2.5uA quiescent current in burst mode. The A-revision improves EMI performance with controlled edge rates on the switch node. The synchronous design eliminates the external Schottky diode by using an internal low-side MOSFET (catch FET) for freewheeling, improving efficiency by 3-5% compared to asynchronous designs. The device uses a current-mode control architecture: an error amplifier compares the FB voltage with the 0.97V internal reference; the error amplifier output controls the peak inductor current; the peak current is sensed cycle-by-cycle for stability and current limiting. The switching frequency is fixed at 1MHz (also available in 2MHz for LT8610AB-2), allowing small 2.2-4.7uH inductors. The burst mode operation is the key low-Iq feature: at light load (below approximately 100mA), the device delivers a burst of switching cycles, then enters a low-Iq sleep state where only the reference and error amplifier remain active (2.5uA total). This results in extremely low standby power consumption, critical for always-on automotive and battery-powered systems. The minimum on-time is 50ns, allowing high step-down ratios (e.g., 42V to 3.3V at 1MHz). The EN/UV pin can set a precise undervoltage threshold using a resistor divider. The TR/SS pin provides programmable soft-start and voltage tracking (for sequencing multiple rails). The -BEMSE#TRPBF suffix specifies MSOP-10, tape-and-reel, lead-free.

Pin Description: LT8610ABEMSE#TRPBF Pin Definition and Functions
Pin Name Type Function
1 BOOST1 Power Bootstrap capacitor for internal high-side switch (connect 0.1uF to SW)
2 SW1 Output Switch node 1 (connects to inductor, 2.5A peak)
3 VIN1 Power Input supply 1 (3.4-42V, connect with 4.7uF ceramic cap)
4 EN/UV Input Enable/undervoltage lockout (float=always on, add resistor divider for UVLO)
5 TR/SS Analog Track/soft-start (connect 0.1uF to GND for 3ms soft-start)
6 PG Output Power good (open-drain, HIGH when output within +/-8% of target)
7 VOUT1 Input Output voltage sense 1 (connect to output rail for regulation)
8 GND Power Ground (connect exposed pad to GND plane)
Application Scenarios: In which products and applications is LT8610ABEMSE#TRPBF used
  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
  • Alternative Models: What chips are recommended as replacements for LT8610ABEMSE#TRPBF
    Manufacturer Part Number Package Notes
    Analog Devices LT8610ABEMSE#TRPBF MSOP-10 Same device, ADI brand
    Analog Devices LT8610ACMSE#PBF MSOP-10 C-grade, slightly wider spec
    Texas Instruments LM53603NQDRRRQ1 VQFN-12 3A, 36V, automotive buck, TI brand
    Monolithic Power MP8759GD-Z QFN-12 4A, 18V, sync buck, MP brand
    Richtek RT6208GQW WQFN-12 2A, 36V, buck, Richtek brand

    Recommend Parts

    IRFS4310ZTRLPBF

    IRFS4310ZTRLPBF – 100V N-Channel HEXFET Power MOSFET, 7 mΩ RDS(on), D2PAK (TO-263AB)

    Brand: infineon

    Package: D2PAK (TO-263AB)

    IN STOCK: 11137pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    MSASJ105BB5475MFNA01

    4.7uF 6.3V X5R MLCC, 0402, Taiyo Yuden

    Brand: gigadevice

    Package: 0402 (1005 Metric, 1.0 x 0.5 x 0.5 mm)

    IN STOCK: 9701pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    IRF3415PBF

    150V N-channel power MOSFET, 43A, 41mΩ RDS(on), TO-220AB package

    Brand: infineon

    Package: TO-220AB

    IN STOCK: 2940pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    105017-1001

    USB Type-C receptacle connector, 24-pin, SMD

    Brand: Amphenol

    Package: SMD (8.9 x 7.3 x 3.2 mm, right angle)

    IN STOCK: 5335pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    IRLB3034PBF

    IRLB3034PBF – 40V N-Channel StrongIRFET Power MOSFET (Logic Level), 1.7 mΩ (max) @ 10V; 2.0 mΩ @ 4.5V RDS(on), TO-220AB

    Brand: infineon

    Package: TO-220AB

    IN STOCK: 9724pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    XC6SLX75-2FGG484I

    Spartan-6 LX75 FPGA, 74637 logic cells, 132 DSP, 3096KB BRAM, 408 I/O, FBGA-484 23x23mm, -2 speed, industrial -40~100C, AMD Xilinx

    Brand: xilinx

    Package: FGG484 (484-ball fine-pitch BGA, 23x23mm body, 1.0mm ball pitch, 22×22 ball array, 6 I/O banks, lead-free)

    IN STOCK: 890pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1