Opens in a new tab

TPS62745DSST

Ultra-low Iq buck converter, 350nA, 300mA, pin-selectable VOUT, WSON-8

11167

Effective Inventory

Image for reference only

Manufacturer Part:

TPS62745DSST

Package:

WSON-8 (2.0×2.0mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The TPS62745DSST from Texas Instruments is an ultra-low quiescent current buck converter with 350nA Iq and up to 95% efficiency. Operating from 2.2-5.5V input, it delivers 300mA output at programmable voltages. It is the ideal power converter for energy-harvesting and long-life battery IoT devices. Packaged in WSON-8 (2x2mm).

Key Specifications

Topology Buck (step-down) DC-DC
Input Voltage 2.2V to 5.5V
Output Current 300mA
Quiescent Current (Iq) 350nA (operating)
Efficiency Up to 95%
Output Voltage 1.2V to 3.3V (pin-selectable, 100mV steps)
Switching Frequency 2MHz
Package WSON-8 (2.0×2.0mm)
Operating Temperature -40 to +85 C

Features

  • 350nA operating quiescent current
  • Pin-selectable output voltage (no feedback resistors)
  • 300mA output current
  • Up to 95% efficiency at 10mA load
  • 2MHz switching for tiny inductor
  • Pass-through mode for lowest dropout

Applications

  • Energy harvesting power conversion
  • BLE and IoT sensor nodes
  • Long-life coin cell applications
  • Wearable electronics
Product Introduction: TPS62745DSST Product Introduction

The TPS62745DSST from Texas Instruments is an ultra-low quiescent current step-down converter designed for battery-powered IoT and energy-harvesting applications. With only 350nA operating quiescent current, it draws virtually no power during idle periods, extending coin-cell battery life from months to years. The output voltage is pin-selectable from 1.2V to 3.3V in 100mV steps using the VSEL pins, eliminating feedback resistors and their leakage current. The converter achieves up to 95% efficiency even at 10mA load, a remarkable feat that traditional buck converters cannot match at light loads. The 2MHz switching frequency allows use of a tiny 1uH inductor in a 2x2mm footprint. A pass-through mode connects input directly to output with only 40mOhm resistance when the output is close to the target, achieving near-zero dropout for maximum energy extraction from batteries.

Working Principle: TPS62745DSST Working Principle

The TPS62745DSST uses a hysteretic control scheme optimized for ultra-low quiescent current. In discontinuous conduction mode (DCM), the converter delivers a fixed energy packet on each switching cycle, then enters a low-power sleep state. The output voltage is monitored by a nano-power comparator; when VOUT drops below the lower threshold, a new switching cycle begins. This pulse-frequency modulation (PFM) approach maintains high efficiency at light loads because the switching frequency decreases with load current. At 350nA Iq, the converter’s own power consumption is negligible: a CR2032 coin cell (225mAh) would last over 73 years at 350nA drain. The VSEL pins (4 pins) select the output voltage by connecting to VDD or GND in binary combinations, covering 1.2V to 3.3V in 100mV steps. The pass-through mode activates when VIN is close to the target VOUT, bypassing the converter entirely with a 40mOhm MOSFET switch.

Pin Description: TPS62745DSST Pin Definition and Functions
Pin Name Function
1 SW Switch node (connect to inductor)
2 VIN Input supply (2.2-5.5V)
3 GND Ground (exposed pad)
4 VSEL0 Voltage select bit 0 (connect to VDD or GND)
5 VSEL1 Voltage select bit 1
6 VSEL2 Voltage select bit 2
7 VSEL3 Voltage select bit 3
8 VOUT Output voltage (connect to output capacitor)
Application Scenarios: In which products and applications is TPS62745DSST used
  • Energy harvesting converter with 350nA Iq for solar/thermoelectric powered IoT
  • BLE sensor node with coin cell battery life extended by 95% efficiency at 10mA
  • Wearable electronics with 2x2mm footprint and pin-selectable 1.8-3.3V output
  • CR2032-powered remote sensor with years of battery life at microamp average current
Alternative Models: What chips are recommended as replacements for TPS62745DSST
Model Manufacturer Key Difference
TPS62746 TI Same but fixed 3.3V output, fewer VSEL pins
MAX20361 ADI 250nA Iq, Buck+LDO, energy harvesting optimized
BD70528 ROHM 400nA Iq, Buck+Charger, NB-IoT optimized
LTC3337 ADI 300nA Iq, nanopower buck, energy harvesting

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1