Opens in a new tab

AT45DB081E-SSHN-T

8Mbit DataFlash, Dual-SPI 85MHz, 2x256B buffers, SOIC-8

6234

Effective Inventory

Image for reference only

Manufacturer Part:

AT45DB081E-SSHN-T

Package:

SOIC-8 (5.3 x 8 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The AT45DB081E-SSHN-T from Microchip Technology is an 8Mbit (1MB) DataFlash serial Flash memory with a dual-SPI interface and two 256-byte SRAM buffers. Operating at up to 85MHz clock with page program and buffer read-modify-write capabilities, it targets data logging and code storage in SOIC-8 package.

Key Specifications

Density 8 Mbit (1 MB)
Organization 4096 pages x 256 bytes
Interface SPI (up to 85MHz) / Dual-SPI
Supply Voltage 2.3V to 3.6V
SRAM Buffers 2 x 256 bytes
Page Program Time 2.5 ms (typical)
Data Retention 20 years
Program/Erase Cycles 100,000 per page
Package SOIC-8 (0.208″ wide)
Operating Temperature -40°C to +85°C

Features

  • Dual-SPI interface for 2x data throughput compared to standard SPI
  • Two 256-byte SRAM buffers for read-modify-write operations
  • Flexible page erase with individual page, block, or sector granularity
  • Page program with built-in erase cycle (simplifies write operations)
  • Deep power-down mode with 7μA typical current
  • Hardware and software write protection

Applications

  • Data logging and event recording in industrial systems
  • Firmware and code storage for embedded processors
  • Audio and voice storage in consumer devices
  • Parameter and calibration data storage
  • Secure data storage with write protection
Product Introduction: AT45DB081E-SSHN-T Product Introduction

The AT45DB081E-SSHN-T from Microchip Technology is an 8Mbit (1 megabyte) DataFlash serial Flash memory optimized for data logging, firmware storage, and general-purpose non-volatile storage applications. Unlike standard SPI Flash memories, the DataFlash architecture integrates two 256-byte SRAM buffers that enable read-modify-write operations without external RAM, simplifying data logging applications. The device supports standard SPI (up to 85MHz) and Dual-SPI (2-bit) interfaces for high-throughput data transfer, with flexible page erase granularity including individual page (256 bytes), block (2KB), sector (64KB), and full-chip erase options.

Working Principle: AT45DB081E-SSHN-T Working Principle

The AT45DB081E operates using a unique buffer-based DataFlash architecture. (1) The SPI interface receives commands, addresses, and data through the SI pin (and optionally SO pin in Dual-SPI mode) synchronized to the SCK clock, with CS active-low chip select. (2) The two 256-byte SRAM buffers (Buffer 1 and Buffer 2) serve as intermediate storage for Flash page operations. A Main Memory Page Program via Buffer operation loads data into a buffer and then transfers it to the Flash array in a single command sequence, performing the erase and program cycle automatically. (3) The Flash array is organized as 4096 pages of 256 bytes each, with pages further grouped into blocks (8 pages) and sectors (256 pages). Read operations can access the Flash array directly or through either buffer, with continuous read capability across page boundaries.

Pin Description: AT45DB081E-SSHN-T Pin Definition and Functions
Pin Name Function
1 SI SPI data input (MOSI)
2 SO SPI data output (MISO) / Dual-SPI I/O1
3 WP Hardware write protect (active low)
4 VSS Ground
5 SI/SIO0 SPI input / Dual-SPI I/O0
6 SCK SPI clock
7 RESET Hardware reset (active low)
8 VCC Power supply (2.3-3.6V)
Application Scenarios: In which products and applications is AT45DB081E-SSHN-T used
  • Industrial data logging with continuous write using dual-buffer ping-pong operation
  • Firmware and boot code storage with Dual-SPI high-speed read access
  • Audio and voice recording applications with sequential page storage
  • Parameter and calibration storage with flexible write protection
  • Medical device event recording with SRAM buffer for atomic writes
Alternative Models: What chips are recommended as replacements for AT45DB081E-SSHN-T
Model Manufacturer Key Difference
AT45DB161E-SSHN-T Microchip 16Mbit, same package/pinout
AT45DB041E-SSHN-T Microchip 4Mbit, smaller capacity
SST25VF080B-50-4I-S2AF Microchip 8Mbit SPI Flash, standard architecture
MX25L8006EM1I-12G Macronix 8Mbit SPI Flash, SOIC-8
W25Q80DVSNIG Winbond 8Mbit SPI Flash, SOIC-8

Recommend Parts

IRFS4310ZTRLPBF

IRFS4310ZTRLPBF – 100V N-Channel HEXFET Power MOSFET, 7 mΩ RDS(on), D2PAK (TO-263AB)

Brand: infineon

Package: D2PAK (TO-263AB)

IN STOCK: 11137pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MSASJ105BB5475MFNA01

4.7uF 6.3V X5R MLCC, 0402, Taiyo Yuden

Brand: gigadevice

Package: 0402 (1005 Metric, 1.0 x 0.5 x 0.5 mm)

IN STOCK: 9701pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRF3415PBF

150V N-channel power MOSFET, 43A, 41mΩ RDS(on), TO-220AB package

Brand: infineon

Package: TO-220AB

IN STOCK: 2940pcs

Cargo cycle: 3-7 Days

The minimum order is 1

105017-1001

USB Type-C receptacle connector, 24-pin, SMD

Brand: Amphenol

Package: SMD (8.9 x 7.3 x 3.2 mm, right angle)

IN STOCK: 5335pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRLB3034PBF

IRLB3034PBF – 40V N-Channel StrongIRFET Power MOSFET (Logic Level), 1.7 mΩ (max) @ 10V; 2.0 mΩ @ 4.5V RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 9724pcs

Cargo cycle: 3-7 Days

The minimum order is 1

XC6SLX75-2FGG484I

Spartan-6 LX75 FPGA, 74637 logic cells, 132 DSP, 3096KB BRAM, 408 I/O, FBGA-484 23x23mm, -2 speed, industrial -40~100C, AMD Xilinx

Brand: xilinx

Package: FGG484 (484-ball fine-pitch BGA, 23x23mm body, 1.0mm ball pitch, 22×22 ball array, 6 I/O banks, lead-free)

IN STOCK: 890pcs

Cargo cycle: 3-7 Days

The minimum order is 1