Opens in a new tab

Home » Integrated Circuits ICs » LMV358IDR

LMV358IDR

Dual rail-to-rail op-amp, 1MHz, 2.7-5.5V, SOIC-8

40000

Effective Inventory

Image for reference only

Manufacturer Part:

LMV358IDR

Package:

SOIC-8 (4.9 x 3.9 x 1.58 mm)

Brand:

Product Categories:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The LMV358IDR from Texas Instruments is a dual general-purpose rail-to-rail output op-amp with 1MHz GBW, 2.7V-5.5V supply, and 210uA supply current in SOIC-8 package.

Key Specifications

Channels 2 (dual)
Supply Voltage 2.7 V to 5.5 V (single or dual supply)
Gain-Bandwidth Product 1 MHz
Slew Rate 0.8 V/us
Input Offset Voltage 1.7 mV typical / 7 mV max
Input Bias Current 12 nA typical
Input Common-Mode Range Ground to VDD – 1.2V
Output Swing Rail-to-rail (within 30mV of rails)
Supply Current (per amplifier) 105 uA typical
Output Drive Current 60 mA short circuit
CMRR 75 dB typical
Package SOIC-8 (IDR suffix)
Operating Temperature -40 to +85 C

Features

  • Rail-to-rail output swings within 30mV of supply rails
  • 2.7V minimum supply for low-voltage operation
  • 1MHz GBW for moderate-speed signal processing
  • 210uA total supply current for both amplifiers
  • Input common-mode range includes ground

Applications

  • Portable and battery-powered signal conditioning
  • Low-voltage active filter design
  • Sensor amplifier and transducer interface
  • Audio preamplifier and buffer
  • General-purpose low-voltage analog circuits
Product Introduction: LMV358IDR Product Introduction

The LMV358IDR from Texas Instruments is a dual general-purpose rail-to-rail output operational amplifier in SOIC-8 package. The device operates from 2.7V to 5.5V supply with 1MHz gain-bandwidth product, 0.8V/us slew rate, and 210uA total supply current for both amplifiers. The rail-to-rail output swings within 30mV of the supply rails, maximizing dynamic range in low-voltage applications. The input common-mode range extends from ground to VDD-1.2V, allowing single-supply operation with ground-referenced signals. The IDR suffix denotes SOIC-8 package with tape and reel.

Working Principle: LMV358IDR Working Principle

The LMV358IDR operates as a dual rail-to-rail output operational amplifier. (1) The input stage uses a PNP differential pair that allows the input common-mode range to extend to ground (0V), critical for single-supply applications where the input signal may be at or near ground. The upper limit of the common-mode range is VDD – 1.2V, set by the bias circuit. The 1.7mV typical input offset voltage is adequate for most general-purpose applications. (2) The output stage uses a common-emitter (Class AB) configuration that allows the output to swing within 30mV of both supply rails under light load. This is significantly better than standard LM358 op-amps that can only swing to within 1.5V of VDD. The rail-to-rail output maximizes the usable signal range in low-voltage (3.3V/5V) systems where every millivolt of dynamic range matters. (3) The 1MHz gain-bandwidth product and 0.8V/us slew rate determine the maximum frequency and amplitude the amplifier can handle without distortion. For a unity-gain buffer, the -3dB bandwidth is 1MHz. For a gain-of-10 amplifier, the bandwidth is 100kHz. The maximum undistorted sine wave amplitude at frequency f is: VOUT(max) = SR / (2 x pi x f), where SR is the slew rate. At 100kHz, the maximum undistorted output amplitude is approximately 1.27V peak.

Pin Description: LMV358IDR Pin Definition and Functions
Pin Name Function
1 1OUT Amplifier 1 output
2 1IN- Amplifier 1 inverting input
3 1IN+ Amplifier 1 non-inverting input
4 GND Negative supply / ground
5 2IN+ Amplifier 2 non-inverting input
6 2IN- Amplifier 2 inverting input
7 2OUT Amplifier 2 output
8 V+ Positive supply (2.7-5.5V)
Application Scenarios: In which products and applications is LMV358IDR used
  • Portable and battery-powered signal conditioning with rail-to-rail output
  • Low-voltage active filter design at 1MHz GBW
  • Sensor amplifier and transducer interface with ground-referenced input
  • Audio preamplifier and buffer in 3.3V/5V systems
  • General-purpose low-voltage analog circuits with 210uA IQ
Alternative Models: What chips are recommended as replacements for LMV358IDR
Model Manufacturer Key Difference
LMV358MFX TI Same, Micro8 package
MCP6002-I/SN Microchip 1MHz, R-R, SOIC-8
TLV2462CDR TI 6.4MHz, R-R I/O, low power
OPA2314AIDR TI 3MHz, R-R I/O, precision
NJMU358M NJR 1MHz, R-R output, DIP-8

Recommend Parts

BC857BS

Dual PNP transistor, -45V, -100mA, SOT363, Nexperia

Brand: NXP

Package: SOT363 (SC-88, 2.1 x 1.25 x 0.95 mm)

IN STOCK: 8813pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM1200ARZ-RL7

Dual-channel digital isolator based on ADI iCoupler technology, 2/0 direction, SOIC-8 narrow body, 1Mbps (A grade), 2.7-5.5V dual supply, 2500Vrms isolation, >25kV/us CMTI, -40C to +105C.

Package: SOIC-8 Narrow (5.06 x 3.99 x 1.75mm)

IN STOCK: 12476pcs

Cargo cycle: 3-7 Days

The minimum order is 1

PIC32MX795F512L-80I/PT

MIPS32 MCU, 80MHz, 512KB Flash, Ethernet, dual CAN, USB OTG, 100-TQFP

Brand: MICROCHIP

Package: 100-TQFP (14.0 x 14.0 x 1.0 mm)

IN STOCK: 5670pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IS61WV25616BLL-10TLI

4Mbit async SRAM, 256Kx16, 10ns, 3.3V, 44-TSOP-II Industrial

Brand: Issi

Package: 44-TSOP II

IN STOCK: 7802pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AT45DB081E-SHN-T

8Mbit DataFlash, dual-SPI 85MHz, 2x264B SRAM buffers, USON-8 (4x3mm), page-based ECC

Brand: Renesas

Package: USON-8 (4 x 3 x 0.6mm, 0.8mm pitch)

IN STOCK: 4500pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TIP35C

NPN power transistor, 100V VCEO, 25A Ic, 125W, TO-247, low saturation voltage, STMicroelectronics

Brand: ST

Package: TO-247 (through-hole, 3-pin)

IN STOCK: 11500pcs

Cargo cycle: 3-7 Days

The minimum order is 1