Opens in a new tab

TPS7333QDR

500mA LDO, 3.3V fixed, 44mV Vdo, RESET 200ms, EN pin, SOIC-8

833

Effective Inventory

Image for reference only

Manufacturer Part:

TPS7333QDR

Package:

SOIC-8 (4.9 x 3.91 x 1.58mm, 1.27mm pitch)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TPS7333QDR is a 500mA low-dropout (LDO) regulator from Texas Instruments with fixed 3.3V output, integrated delayed reset (200ms), enable pin, and very low quiescent current in an SOIC-8 package.

Key Specifications

Output Voltage 3.3V fixed (±2% over line, load, temperature)
Output Current 500mA max
Input Voltage Range 3.77V to 10V
Dropout Voltage 44mV typical @ 100mA, 235mV @ 500mA
Quiescent Current 340µA typical (independent of load)
Sleep Mode Current 0.5µA max (EN = HIGH)
PSRR 51dB ~ 49dB @ 120Hz
Reset Output Open-drain, active-low, 200ms delay
Reset Threshold Output drops below ~2.93V (89% of VOUT)
Enable Pin (EN) Active-low (LOW = enabled, HIGH = sleep)
Line Regulation 6mV typical (4.3V to 10V)
Load Regulation 21mV typical (5mA to 500mA)
Output Capacitor 4.7µF minimum (ESR 0.3Ω to 22Ω)
Operating Temperature -40°C to +125°C
Package SOIC-8 (4.9 x 3.9mm)

Features

  • Fixed 3.3V output with ±2% accuracy
  • Ultra-low dropout: 44mV at 100mA
  • Quiescent current independent of load (340µA)
  • 0.5µA sleep mode current
  • Integrated precision voltage supervisor with delayed reset
  • 200ms reset timeout after output recovers
  • Enable pin for sleep/wake control
  • PMOS pass element (low dropout, constant Iq)
  • Over-current and over-temperature protection
  • Reverse polarity protection

Applications

  • Microcontroller power with integrated reset
  • DSP and FPGA core/IO power
  • Battery-powered portable equipment
  • Post-regulator for switching supplies
  • Power management for microprocessor systems
Product Introduction: TPS7333QDR Product Introduction

The TPS7333QDR from Texas Instruments is a 500mA low-dropout voltage regulator with a fixed 3.3V output and an integrated precision supply-voltage supervisor that generates a delayed active-low reset signal. The PMOS pass element provides exceptionally low dropout voltage (44mV at 100mA) and quiescent current that remains constant at 340µA regardless of load current—from no load to full 500mA load. This is a significant advantage over PNP-based LDOs whose quiescent current increases with load. The integrated reset function monitors the output voltage; if it drops below approximately 89% of the nominal value, the open-drain RESET output goes LOW. When the output recovers, RESET remains LOW for an additional 200ms (typical) before going HIGH, ensuring the microprocessor has stable power before exiting reset. The enable pin (active-low) allows the regulator to be placed in a 0.5µA sleep mode. The QDR suffix denotes the SOIC-8 package with tape-and-reel packaging, rated for the extended -40°C to 125°C temperature range.

Working Principle: TPS7333QDR Working Principle

The TPS7333QDR uses a PMOS pass transistor between VIN and VOUT, controlled by an error amplifier that compares a fraction of the output voltage against an internal bandgap reference. When the output voltage drops below 3.3V, the error amplifier drives the PMOS gate more negative (relative to VIN), increasing the pass transistor’s channel width and allowing more current to flow to the load. When the output rises above 3.3V, the error amplifier reduces the gate drive, limiting current flow. The PMOS pass element is key to the LDO’s performance: unlike PNP transistors that require significant base current (which adds to quiescent current and varies with load), the PMOS gate draws only leakage current, so Iq stays at 340µA regardless of whether the load is 0mA or 500mA. The dropout voltage is simply ID × RDS(on) of the PMOS, which is very low (0.44Ω typical at 25°C, giving 44mV at 100mA). The reset circuit continuously monitors the output voltage through the SENSE pin. When VOUT drops below the reset threshold (approximately 2.93V for the 3.3V version), RESET goes LOW. When VOUT recovers above the threshold, an internal timer starts; after 200ms, RESET goes HIGH (open-drain releases). The EN pin controls sleep mode: when EN is HIGH, the PMOS pass element is turned off and Iq drops to 0.5µA.

Pin Description: TPS7333QDR Pin Definition and Functions
Pin Name Type Description
1 GND Power Ground
2 EN Input Enable (active-low; LOW=on, HIGH=sleep/0.5µA)
3 IN Input Input supply (3.77V to 10V)
4 IN Input Input supply (connect both IN pins)
5 OUT Output Regulated 3.3V output
6 OUT Output Regulated 3.3V output (connect both OUT pins)
7 SENSE Input Voltage sense for regulation (connect to OUT)
8 RESET Output Reset output (open-drain, active-low, 200ms delay)

TPS7333QDR uses the 8-SOIC (D) package with LDO regulator pinout: Pin 1 = GND, Pin 2 = EN (Enable, active-high), Pin 3 = IN, Pin 4 = IN, Pin 5 = NC, Pin 6 = NC, Pin 7 = SENSE/FB (3.3V fixed output senses at this pin), Pin 8 = OUT. Two IN pins must both be connected to the input supply for proper current distribution. The EN pin has a precision threshold — pull above 2V to enable, below 0.5V to disable. The SENSE pin (Pin 7) should be connected directly at the load for accurate voltage regulation (remote sensing). A 10µF ceramic output capacitor provides stability with less than 50mV output noise.

Application Scenarios: In which products and applications is TPS7333QDR used
  • MCU Power+Reset: Single IC provides 3.3V rail and reset signal; RESET connects to MCU /RST pin, eliminating external supervisor IC
  • Battery Device: 340µA constant Iq extends battery life; EN pin enables 0.5µA sleep mode during standby
  • Post-SMPS Regulator: Low 44mV dropout after 3.3V switching supply leaves minimal headroom; PSRR >49dB attenuates switcher ripple
  • Hot-Plug: RESET stays LOW for 200ms after output stabilizes, preventing MCU from executing during power-up transients
  • Brownout Detect: RESET asserts when 3.3V rail drops below 2.93V; MCU enters reset before SRAM data corrupts
Alternative Models: What chips are recommended as replacements for TPS7333QDR
Model Manufacturer Key Difference Package Specs
TPS7333QP TI Same in PDIP-8 through-hole package – –
TPS7333QPW TI Same in TSSOP-20 (1.2mm height) – –
TPS73033DBVR TI 200mA, SOT-23-5, no reset, smaller – –
TPS70933DBVR TI 150mA, 1µA Iq, EN pin, SOT-23-5, no reset – –
AMS1117-3.3 Advanced Monolithic 800mA, higher dropout (1.1V), no reset, SOT-223 – –

TPS7333QDR is a 3.3V/500mA LDO from TI in SOIC-8 with PG output. The TPS7333QPWPR provides the same in TSSOP-20. The TPS7A4700 offers ultralow noise 1A LDO for RF applications. The LM1117MP-3.3 provides 800mA in smaller SOT-223. The TPS73633DBVR offers 400mA with 75mV dropout in SOT-23-5. The MCP1826T-3302E/DC provides 1A with anyCAP stability from Microchip. For higher current, TPS7A7001 offers 1A adjustable ultralow noise in VSON-10.

Recommend Parts

IRFS4310ZTRLPBF

IRFS4310ZTRLPBF – 100V N-Channel HEXFET Power MOSFET, 7 mΩ RDS(on), D2PAK (TO-263AB)

Brand: infineon

Package: D2PAK (TO-263AB)

IN STOCK: 11137pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MSASJ105BB5475MFNA01

4.7uF 6.3V X5R MLCC, 0402, Taiyo Yuden

Brand: gigadevice

Package: 0402 (1005 Metric, 1.0 x 0.5 x 0.5 mm)

IN STOCK: 9701pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRF3415PBF

150V N-channel power MOSFET, 43A, 41mΩ RDS(on), TO-220AB package

Brand: infineon

Package: TO-220AB

IN STOCK: 2940pcs

Cargo cycle: 3-7 Days

The minimum order is 1

105017-1001

USB Type-C receptacle connector, 24-pin, SMD

Brand: Amphenol

Package: SMD (8.9 x 7.3 x 3.2 mm, right angle)

IN STOCK: 5335pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRLB3034PBF

IRLB3034PBF – 40V N-Channel StrongIRFET Power MOSFET (Logic Level), 1.7 mΩ (max) @ 10V; 2.0 mΩ @ 4.5V RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 9724pcs

Cargo cycle: 3-7 Days

The minimum order is 1

XC6SLX75-2FGG484I

Spartan-6 LX75 FPGA, 74637 logic cells, 132 DSP, 3096KB BRAM, 408 I/O, FBGA-484 23x23mm, -2 speed, industrial -40~100C, AMD Xilinx

Brand: xilinx

Package: FGG484 (484-ball fine-pitch BGA, 23x23mm body, 1.0mm ball pitch, 22×22 ball array, 6 I/O banks, lead-free)

IN STOCK: 890pcs

Cargo cycle: 3-7 Days

The minimum order is 1