Opens in a new tab

LMR33630ADDAR

3A 36V buck, 400kHz, 22uA IQ, HSOIC-8

9800

Effective Inventory

Image for reference only

Manufacturer Part:

LMR33630ADDAR

Package:

8-Pin HSOIC (5.0 x 4.0 x 1.5 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The LMR33630ADDAR is a Texas Instruments 3A 36V synchronous buck converter with 400kHz switching, 22uA IQ, and internal compensation. HSOIC-8 package. -40C to +125C.

Key Specifications

Input Voltage 4 V to 36 V
Output Current 3 A
Frequency 400 kHz
IQ 22 uA
RDS(on) HS 100 mohm
Package HSOIC-8

Features

  • 4V to 36V input range
  • 3A continuous output current
  • 400kHz fixed switching
  • 22uA quiescent current
  • Internal compensation
  • PFM/PWM mode for light-load efficiency
  • Thermal shutdown and OCP

Applications

  • Industrial 24V bus POL
  • Automotive 12V/24V systems
  • Factory automation power
  • Motor driver logic supply
Product Introduction: LMR33630ADDAR Product Introduction

The LMR33630ADDAR is a Texas Instruments 3A 36V step-down converter in an HSOIC-8 package, designed for industrial and automotive power conversion from 12V/24V bus rails. The 4V to 36V input range accommodates the full automotive input range including cold-crank and load-dump transients with external suppression. The 22uA quiescent current in PFM mode maximizes light-load efficiency for always-on housekeeping supplies. The 400kHz fixed switching frequency balances efficiency and solution size, with internal compensation eliminating external R-C networks. The integrated 100mohm high-side and 55mohm low-side MOSFETs provide 3A continuous output with good efficiency. Current-mode control ensures fast transient response and cycle-by-cycle peak current limiting. The device transitions seamlessly between PWM mode (heavy load) and PFM mode (light load) for high efficiency across the full load range. Hiccup-mode overcurrent protection and thermal shutdown handle fault conditions. The HSOIC-8 package with exposed thermal pad provides good power dissipation capability. Packaged in HSOIC-8 rated for -40C to +125C.

Working Principle: LMR33630ADDAR Working Principle

The LMR33630 uses peak current-mode PWM control with an integrated high-side NMOS and low-side NMOS synchronous rectifier. During each 400kHz switching period, the high-side MOSFET turns on, ramping up the inductor current until the peak current reaches the error amplifier commanded level. The high-side MOSFET then turns off and the low-side MOSFET turns on, allowing inductor current to ramp down through the synchronous rectifier. The error amplifier compares the FB pin voltage (via external resistor divider) with the 1V internal reference, adjusting the peak current command to maintain output regulation. At light loads, the device enters PFM skip mode where switching pulses are issued only when the output drops below the regulation threshold, reducing effective switching frequency and minimizing switching losses. Internal slope compensation prevents sub-harmonic oscillation at duty cycles above 50%. The bootstrap capacitor (CB) on the BOOT pin provides gate drive for the high-side NMOS.

Pin Description: LMR33630ADDAR Pin Definition and Functions
Pin Mnemonic Description
1 BOOT Bootstrap capacitor
2 VIN Input supply (4-36V)
3 EN Enable (active high)
4 FB Feedback (1V reference)
5 NC No connect
6 GND Ground (exposed pad)
7 SW Switch node
8 NC No connect
Application Scenarios: In which products and applications is LMR33630ADDAR used
  • Industrial 24V bus to 5V/3.3V POL converter with 3A output and 22uA standby
  • Automotive 12V to 5V supply with 36V transient tolerance and internal compensation
  • Factory automation 24V to 3.3V logic supply with PFM light-load efficiency
  • Motor driver 5V logic supply from 24V rail with thermal shutdown protection
Alternative Models: What chips are recommended as replacements for LMR33630ADDAR
Model Manufacturer Key Difference
LMR33620ADDAR TI 2A version
LMR33630BDDAR TI 1.2MHz, smaller inductor
LM43603 TI Similar 36V, 3A
MAX17503 Maxim Similar 36V buck

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1