Opens in a new tab

LM5117PMHX/NOPB

65V sync buck controller, 200/480kHz, HTSSOP-20

3800

Effective Inventory

Image for reference only

Manufacturer Part:

LM5117PMHX/NOPB

Package:

20-Pin HTSSOP (6.5 x 4.4 x 1.0 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The LM5117PMHX/NOPB is a TI 65V synchronous buck DC-DC controller with 200/480kHz switching, synchronous rectification, soft start, and frequency control. Packaged in 20-HTSSOP, -40C to +125C.

Key Specifications

Vin 5.5V to 65V
Topology Buck (step-down)
Fsw 200kHz / 480kHz
Output Transistor Driver
Synch Rect Yes
Package 20-HTSSOP

Features

  • 5.5V to 65V wide input range
  • Synchronous buck controller
  • 200kHz or 480kHz switching
  • Synchronous rectification
  • Soft start and frequency control
  • Current mode control
  • -40C to +125C operation

Applications

  • 48V telecom POL
  • 12V/24V industrial bus
  • Automotive front-end supply
  • LED driver pre-regulator
Product Introduction: LM5117PMHX/NOPB Product Introduction

The LM5117PMHX/NOPB is a Texas Instruments 65V synchronous step-down (buck) DC-DC controller in a 20-pin HTSSOP package. As a controller (not a converter), it drives external N-channel MOSFETs for the high-side and low-side switches, allowing designers to optimize the power stage for specific output current and efficiency requirements. The 5.5V to 65V input range supports telecom 48V, automotive 12V/24V, and industrial bus rails. The selectable 200kHz or 480kHz switching frequency allows trade-offs between efficiency (lower frequency) and solution size (higher frequency). The synchronous rectification eliminates the Schottky diode conduction loss, improving efficiency especially at low output voltages. The current mode control provides cycle-by-cycle current limiting and simplified loop compensation. The soft start eliminates inrush current during startup, and the frequency control pin allows synchronization to an external clock or frequency dithering for EMI reduction.

Working Principle: LM5117PMHX/NOPB Working Principle

The LM5117 uses peak current mode control for the buck converter. The error amplifier compares the FB pin voltage against an internal reference, and the resulting COMP voltage sets the peak inductor current threshold. The high-side MOSFET turns on at the beginning of each switching cycle, ramping up the inductor current. When the current sense signal reaches the COMP threshold, the high-side MOSFET turns off and the low-side synchronous MOSFET turns on. The cycle repeats at the next clock edge. The current mode control provides cycle-by-cycle overcurrent protection and simplifies loop compensation. The adaptive dead-time control inserts a non-overlap delay between high-side and low-side transitions to prevent shoot-through current.

Pin Description: LM5117PMHX/NOPB Pin Definition and Functions
Pin Mnemonic Description
1 VIN Input supply (5.5-65V)
2 EN Enable
3 SS Soft start capacitor
4 FB Feedback (0.8V ref)
5 COMP Error amplifier output
6-10 Control Frequency, sync, current sense
11-15 Gate Drive HDRV, LDRV, BOOT, SW
16-20 GND/VCC Ground and bias supply
Application Scenarios: In which products and applications is LM5117PMHX/NOPB used
  • 48V telecom bus to 12V POL with external MOSFETs for 10A output
  • Automotive 12V battery to 3.3V with 65V transient protection and 125C operation
  • Industrial 24V to 5V synchronous buck with frequency sync for EMI control
  • LED driver pre-regulator with 480kHz for compact solution
Alternative Models: What chips are recommended as replacements for LM5117PMHX/NOPB
Model Manufacturer Key Difference
LM5116 TI 80V input, similar controller
LM5117PMX/NOPB TI TSSOP-20, non-power pad
LM5145 TI 65V, 1MHz, PMBus
MP3910 MPS Similar 60V controller

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1