Opens in a new tab

IFX9201SG

AEC-Q100 4-half-bridge motor driver, 6A/bridge, 5.5-35V, SPI+PWM, DSO-28

5470

Effective Inventory

Image for reference only

Manufacturer Part:

IFX9201SG

Package:

DSO-28 (10.3 x 7.5 x 2.35 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The IFX9201SG is an Infineon integrated 4-half-bridge motor driver IC capable of driving two DC motors or one stepper motor. It features 6A per half-bridge output current, operates from 5.5V to 35V, and includes SPI interface for configuration and diagnostics. The device is AEC-Q100 qualified for automotive applications.

Key Specifications

Supply Voltage 5.5V to 35V
Configuration 4 half-bridges
Output Current (per half-bridge) 6A peak, 3A RMS
On Resistance (HS+LS) 200mΩ typical
Interface PWM + SPI (16-bit)
Operating Temperature -40°C to +150°C
Qualification AEC-Q100

Features

  • AEC-Q100 qualified for automotive applications
  • 4 independent half-bridge outputs
  • 6A peak output current per half-bridge
  • 16-bit SPI for control and diagnostics
  • PWM mode with independent IN/IN control
  • Over-temperature, over-current, and short-circuit protection
  • Open-load detection
  • Cross-current protection

Applications

  • Automotive DC motor control
  • Stepper motor drives
  • Door lock and window lift actuators
  • Seat adjustment motors
  • HVAC flap actuators
Product Introduction: IFX9201SG Product Introduction

The IFX9201SG is an Infineon AEC-Q100 qualified integrated 4-half-bridge motor driver IC. Operating from 5.5V to 35V, it delivers up to 6A peak per half-bridge with 200mΩ total on-resistance. The device supports both SPI and PWM control interfaces, providing flexibility for automotive DC and stepper motor applications. Comprehensive diagnostics and protection include over-temperature, over-current, short-circuit, open-load detection, and cross-current protection.

Working Principle: IFX9201SG Working Principle

The IFX9201SG integrates four half-bridge power stages, each consisting of a high-side and low-side N-channel MOSFET pair. The SPI interface allows individual bridge configuration, diagnostic register readout, and fault reporting. In PWM mode, the IN1-IN4 pins directly control the bridge outputs. Each half-bridge can be independently configured as high-side, low-side, or half-bridge mode. The current sense amplifier provides proportional output current measurement. Protection circuits continuously monitor for over-temperature, over-current, and short-circuit conditions, automatically disabling the affected bridge when a fault is detected.

Pin Description: IFX9201SG Pin Definition and Functions
Pin Mnemonic Description
1 VS Supply voltage (5.5-35V)
2-3 OUT1/OUT2 Half-bridge 1/2 output
4-5 OUT3/OUT4 Half-bridge 3/4 output
6 GND Ground
7-8 IN1/IN2 PWM input 1/2
9-10 IN3/IN4 PWM input 3/4
11-16 SPI SPI interface pins
17-18 EN/DIAG Enable / diagnostic output
19-28 VCC/IS Logic supply and current sense
Application Scenarios: In which products and applications is IFX9201SG used
  • Automotive door lock and window lift dual DC motor control
  • Seat adjustment with 2 DC motors via SPI configuration
  • HVAC flap actuator bipolar stepper motor drive
  • Automotive mirror adjust with independent half-bridge control
  • Industrial small motor driver with SPI diagnostics
Alternative Models: What chips are recommended as replacements for IFX9201SG
Model Manufacturer Key Difference
TLE9201SG Infineon Similar, higher voltage rating
VNH5050ATR-E ST Single full-bridge, 30A
DRV8873 TI Dual H-bridge, 10A
L298N ST Dual H-bridge, 2A, through-hole
NCV7708 onsemi 4-half-bridge, automotive

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1