Opens in a new tab

Home » Gate Driver ICs, Integrated Circuits ICs » MPQ6533GUE-AEC1-C16K-Z

MPQ6533GUE-AEC1-C16K-Z

AEC-Q100 G1 6-40V 3-ch automotive pre-driver, SPI, internal CSA, charge pump, QFN-32

0

Effective Inventory

Image for reference only

Manufacturer Part:

MPQ6533GUE-AEC1-C16K-Z

Package:

QFN-32 (5mm x 5mm) with exposed pad

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The MPQ6533GUE-AEC1-C16K-Z is a Monolithic Power Systems (MPS) AEC-Q100 Grade 1 qualified 6V to 40V three-channel automotive pre-driver IC designed for DC motor drive applications. It drives six external N-channel power MOSFETs and integrates an LDO regulator for gate drive, a charge pump for reverse-battery protection, an internal current-sense amplifier, and comprehensive safety features via SPI interface.

Key Specifications

Supply Voltage Range 6V to 40V
Configuration 3-channel half-bridge pre-driver (drives 6 N-channel MOSFETs)
Gate Drive Current 1A peak source/sink
Interface SPI (16-bit)
Current Sensing Internal amplifier measures LS-FET VDS (no shunt resistor needed)
Charge Pump For external N-channel MOSFET reverse-battery protection
LDO Regulator Integrated for gate drive voltage generation
Duty Cycle 100% supported (internal charge pump for high-side)
Operating Temperature -40°C to +150°C
Qualification AEC-Q100 Grade 1

Features

  • AEC-Q100 Grade 1 qualified for automotive motor drive
  • Integrated LDO regulator for gate drive voltage
  • Charge pump for external N-channel MOSFET reverse-battery protection
  • Internal current-sense amplifier (measures LS-FET VDS, no shunt required)
  • Low-power sleep mode
  • Configurable short-circuit protection (SCP)
  • Adjustable slew rate control
  • Adjustable dead time control
  • Over-temperature (OT) shutdown
  • Under-voltage (UV) warning and shutdown
  • Open and short load detection
  • SPI interface for configuration and diagnostics
  • Fault indication output
  • QFN-32 (5mm x 5mm) package with exposed thermal pad

Applications

  • Automotive DC motor drives (window, wiper, sunroof)
  • Automotive HVAC blower motor control
  • Pump and fan motor pre-driver
  • Industrial BLDC/BLDC motor drives
  • Robotics and automation motor control
Product Introduction: MPQ6533GUE-AEC1-C16K-Z Product Introduction

The MPQ6533GUE-AEC1-C16K-Z is an MPS AEC-Q100 Grade 1 qualified 6V to 40V three-channel automotive pre-driver IC designed for DC motor drive applications. It drives six external N-channel power MOSFETs and integrates an LDO regulator for gate drive voltage generation, a charge pump for external N-channel MOSFET reverse-battery protection, and an internal current-sense amplifier that measures the voltage drop across the low-side MOSFETs—eliminating the need for external shunt resistors. Features include configurable OCP, adjustable dead time and slew rate, open/short load detection, SPI diagnostics, and fault output. Available in QFN-32 (5x5mm) package.

Working Principle: MPQ6533GUE-AEC1-C16K-Z Working Principle

The MPQ6533GUE-AEC1-C16K-Z operates as a three-channel half-bridge pre-driver, controlling six external N-channel MOSFETs arranged in three half-bridge legs. The integrated LDO regulator generates the gate drive voltage for the low-side MOSFETs. The bootstrap capacitors and internal charge pump generate the high-side gate drive voltage, enabling 100% duty cycle operation. An additional charge pump provides gate drive for an external N-channel MOSFET used for reverse-battery protection. The internal current-sense amplifier measures the VDS of the low-side MOSFETs during the on-state, providing current feedback without external shunt resistors. The SPI interface configures dead time, slew rate, OCP thresholds, and reads diagnostic registers. The fault output pin provides hardware fault indication to the MCU.

Pin Description: MPQ6533GUE-AEC1-C16K-Z Pin Definition and Functions
Pin Group Mnemonic Description
1-3 GH1-GH3 High-side gate drive outputs
4-6 SH1-SH3 Switch node (high-side source)
7-9 GL1-GL3 Low-side gate drive outputs
10-12 CSA1-CSA3 Current-sense amplifier outputs
13-18 SPI/CS/CLK/SDI/SDO SPI interface pins
19 nFAULT Fault indication output
20 EN Enable input
21 VCC Internal LDO output (5V)
22 BST_CP Charge pump bootstrap
23 VIN Supply voltage (6-40V)
24-32 GND/PGND Signal and power ground
Application Scenarios: In which products and applications is MPQ6533GUE-AEC1-C16K-Z used
  • Automotive window lift motor drive with 3 half-bridges and SPI diagnostics
  • HVAC blower motor pre-driver with internal CSA eliminating shunt resistors
  • Automotive sunroof/seat motor drive with reverse-battery protection charge pump
  • Industrial BLDC motor controller with adjustable dead time and slew rate
  • Robotics multi-motor drive system with SPI-configurable OCP per channel
Alternative Models: What chips are recommended as replacements for MPQ6533GUE-AEC1-C16K-Z
Model Manufacturer Key Difference
TLE9180DQK Infineon 3-phase half-bridge, internal MOSFET driver, 40V
DRV8703 TI Single H-bridge, PWM+SPI, 45V
NCV7708B onsemi 6-ch half-bridge, integrated FETs, 28V
A4919 Allegro 3-phase MOSFET driver, 60V
MPQ6541 MPS Monolithic 3-phase motor driver, integrated FETs

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1