Opens in a new tab

BTS70402EPAXUMA1

AEC-Q100 G1 dual 40mΩ smart high-side switch, 3.5A/ch, current sense, ISO 26262-ready, TSDSO-14

4759

Effective Inventory

Image for reference only

Manufacturer Part:

BTS70402EPAXUMA1

Package:

PG-TSDSO-14 (4.9 x 3.9 x 0.95 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The BTS70402EPAXUMA1 is an Infineon PROFET™+2 12V dual-channel smart high-side power switch in PG-TSDSO-14 package. Each channel features 40mΩ on-resistance (typ. 19mΩ at 25°C), 3.5A nominal load current, proportional load current sensing, and comprehensive protection including over-current, over-temperature, and short-circuit diagnostics. AEC-Q100 Grade 1 qualified and ISO 26262-ready.

Key Specifications

Channels 2 (dual high-side switch)
On-Resistance (RDS(on)) 19mΩ typ. (25°C); 36mΩ max. (150°C)
Nominal Load Current (per channel) 3.5A @ TA=85°C
Current Limit Range 34A to 45A (short circuit)
Operating Voltage Range 3.1V to 28V (4.1V switch-on)
Current Sense Ratio (kILIS) 1800 (typical)
Operating Temperature -40°C to +150°C
Qualification AEC-Q100 Grade 1; ISO 26262-ready

Features

  • PROFET™+2 12V family member
  • Dual-channel high-side switch with 19mΩ typ. on-resistance
  • Reverse ON for low power dissipation during reverse battery
  • Proportional load current sense output (kILIS = 1800)
  • Open load detection in ON and OFF state
  • Short circuit to ground and battery detection
  • Over-temperature protection with controlled restart
  • Over-current protection with intelligent restart control
  • Under-voltage shutdown
  • Over-voltage protection with external components
  • Diagnostic enable (DEN) and channel select (DSEL) for SPI-less diagnosis
  • SMART7 technology

Applications

  • ADAS domain controller power distribution
  • Automotive body electronics (lighting, HVAC)
  • Instrument cluster power switches
  • Bulb and LED lamp drivers
  • Automotive relay and fuse replacement
Product Introduction: BTS70402EPAXUMA1 Product Introduction

The BTS70402EPAXUMA1 is an Infineon PROFET™+2 12V dual-channel smart high-side power switch in PG-TSDSO-14 package. Each channel features 19mΩ typical on-resistance, 3.5A nominal load current at 85°C, and proportional current sensing with kILIS=1800. Built on SMART7 technology, it provides over-temperature protection with controlled restart, over-current protection with intelligent restart, open/short load detection, and under-voltage shutdown. AEC-Q100 Grade 1 qualified and ISO 26262-ready, it is ideal for ADAS domain controllers, body electronics, and instrument cluster power distribution.

Working Principle: BTS70402EPAXUMA1 Working Principle

The BTS70402EPAXUMA1 operates as a dual-channel smart high-side power switch. Each channel contains a power DMOS transistor, charge pump, and protection circuitry. The INx pins control the channel on/off state. The charge pump generates a gate voltage above the supply rail to drive the N-channel DMOS, ensuring low RDS(on) even at low battery voltages. The IS pin provides a proportional current sense output: the sense current through IS equals the load current divided by kILIS (1800), allowing the MCU to monitor load current via an external resistor. The DEN and DSEL pins enable diagnosis without SPI: DEN enables the diagnostic output, and DSEL selects which channel’s diagnosis appears on the IS pin. Over-temperature protection uses two mechanisms: absolute over-temperature shutdown for critical conditions, and dynamic over-temperature with controlled restart that reduces duty cycle during thermal stress. Over-current protection trips at 34-45A and uses intelligent restart to prevent MOSFET damage during persistent faults.

Pin Description: BTS70402EPAXUMA1 Pin Definition and Functions
Pin Mnemonic Description
1 GND Ground
2 IN0 Input channel 0 (active high)
3 DEN Diagnostic enable (active high)
4 IS Current sense output (analog)
5 DSEL Diagnosis channel select
6 IN1 Input channel 1 (active high)
7 N.C. Not connected
8-10 OUT0 Output channel 0 (connect together on PCB)
11 N.C. Not connected
12-14 OUT1 Output channel 1 (connect together on PCB)
EP VS Exposed pad (battery supply)
Application Scenarios: In which products and applications is BTS70402EPAXUMA1 used
  • ADAS domain controller dual-channel power distribution with 3.5A per channel and ISO 26262
  • Automotive body lighting module with open/short load detection and current monitoring
  • Instrument cluster power switch with proportional current sense for load health monitoring
  • HVAC blower and valve driver with over-temperature controlled restart
  • Automotive P27W+R5W bulb driver with 34-45A short circuit current limit
Alternative Models: What chips are recommended as replacements for BTS70402EPAXUMA1
Model Manufacturer Key Difference
BTS70015-1EPA Infineon Single channel, 15mΩ, PROFET+2
TPS1H100AQPWPRQ1 TI Single channel, 100mΩ, with SPI
NCV8402 onsemi Single channel, 150mΩ, self-limiting
VN5R003H-E ST Single channel, 3mΩ, VIPower
BTS7040-2ESA Infineon Same function, different package variant

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1