Opens in a new tab

AD8250ARMZ

PGIA, G=1/2/5/10, 10MHz, 98dB CMRR, MSOP-10

2800

Effective Inventory

Image for reference only

Manufacturer Part:

AD8250ARMZ

Package:

10-Lead MSOP (3.0 x 3.0 x 0.85 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The AD8250ARMZ is an Analog Devices 10MHz 20V/us programmable gain instrumentation amplifier with gains of 1, 2, 5, 10, 98dB CMRR at G=10, and 615ns 0.001% settling. Packaged in MSOP-10, -40C to +85C.

Key Specifications

Gain 1, 2, 5, 10 (programmable)
GBW 10 MHz at G=1
SR 20 V/us
CMRR 98 dB min at G=10
Settling 615 ns to 0.001%
Supply +/-5V to +/-15V

Features

  • G=1, 2, 5, 10 programmable gain
  • 10MHz bandwidth at G=1
  • 98dB CMRR at G=10
  • 615ns settling to 0.001%
  • 1.7uV/C offset drift at G=10
  • 10ppm/C gain drift
  • Digital or pin-programmable gain

Applications

  • Data acquisition systems
  • Medical instrumentation
  • Test and measurement
  • ADC driver
Product Introduction: AD8250ARMZ Product Introduction

The AD8250ARMZ is an Analog Devices iCMOS programmable gain instrumentation amplifier (PGIA) in a 10-lead MSOP package. The digitally selectable gains of 1, 2, 5, and 10 make the AD8250 ideal for multi-range data acquisition systems that need to measure signals of widely varying amplitude without external gain-switching components. The gain is set either by two digital control pins (A0, A1) in transparent mode, or by latching the gain via the WR input for register-based control. The 10MHz bandwidth at G=1 and 20V/us slew rate provide fast settling for high-throughput multiplexed data acquisition. The 615ns settling time to 0.001% (16-bit accuracy) makes the AD8250 suitable for driving 16-bit and 18-bit ADCs at high sampling rates. The 98dB minimum CMRR at G=10 rejects common-mode noise from bridge sensors and long cables. The 1.7uV/C maximum offset drift and 10ppm/C maximum gain drift at G=10 provide excellent DC precision over temperature. The +/-5V to +/-15V dual supply supports wide dynamic range for precision measurement. The -110dB THD at 1kHz ensures low distortion for AC measurement applications. Packaged in MSOP-10 rated for -40C to +85C.

Working Principle: AD8250ARMZ Working Principle

The AD8250 uses a three-op-amp instrumentation amplifier architecture with iCMOS precision resistors for gain setting. The input stage consists of two amplifiers that provide high input impedance and pre-amplification according to the selected gain. The gain-setting resistor network is integrated on-chip using iCMOS precision thin-film resistors that are laser-trimmed for accurate gain values (1x, 2x, 5x, 10x) with 10ppm/C maximum gain drift. The output stage is a difference amplifier that converts the differential signal to a single-ended output with high CMRR. The digital gain control selects which internal resistor taps are connected, changing the gain within one clock cycle. In transparent mode (WR high), the gain follows A0/A1 immediately. In latched mode (WR low-to-high transition), the gain setting is stored in an internal register, allowing the control lines to change without affecting the gain until the next latch. The iCMOS process combines high-voltage CMOS for +/-15V operation with precision thin-film resistors for accurate gain and drift performance.

Pin Description: AD8250ARMZ Pin Definition and Functions
Pin Mnemonic Description
1 IN+ Non-inverting input
2 IN- Inverting input
3 VS- Negative supply
4 REF Output reference
5 OUT Output
6 VS+ Positive supply
7 A1 Gain select bit 1
8 /WR Gain latch (active low)
9 A0 Gain select bit 0
10 RG Gain resistor (not used)
Application Scenarios: In which products and applications is AD8250ARMZ used
  • Multi-range data acquisition with programmable G=1/2/5/10 for 16-bit ADC driving
  • Medical ECG/EEG instrumentation with 98dB CMRR and 1.7uV/C offset drift
  • Precision test and measurement with 615ns 0.001% settling for multiplexed channels
  • Bridge sensor interface with G=10 gain and +/-15V wide dynamic range
Alternative Models: What chips are recommended as replacements for AD8250ARMZ
Model Manufacturer Key Difference
AD8251ARMZ ADI G=1/2/4/8 variant
AD8253ARMZ ADI G=1/10/100/1000
PGA280 TI Similar PGIA
LTC6915 ADI Similar programmable gain

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1