Opens in a new tab

ADM7170ACPZ-5.0-R7

500mA CMOS LDO, 5.0V fixed, 5uVrms noise, 42mV dropout

10886

Effective Inventory

Image for reference only

Manufacturer Part:

ADM7170ACPZ-5.0-R7

Package:

LFCSP-8 (3.0 x 3.0 x 0.73 mm, w/ EP)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

ADM7170ACPZ-5.0-R7 Overview

The ADM7170ACPZ-5.0-R7 is a 500mA ultralow noise, high PSRR LDO regulator from Analog Devices with fixed 5.0V output, 94dB PSRR at 1kHz, only 3.8uV RMS output noise, in an LFCSP-8 package, suitable for RF and precision analog power supply.

Key Features

  • Fixed output voltage: 5.0V
  • Output current: 500mA
  • Dropout: 200mV at 500mA
  • PSRR: 94dB at 1kHz
  • Output noise: 3.8uV RMS
  • Supply voltage: 2.3V-6.5V
Product Introduction: ADM7170ACPZ-5.0-R7 Product Introduction

The ADM7170ACPZ-5.0-R7 is a 500 mA, ultralow noise CMOS LDO from Analog Devices with a fixed 5.0 V output and an input range of 2.3 V to 6.5 V. It delivers 5 uVrms output noise (100 Hz to 100 kHz), 60 dB PSRR at 100 kHz, and an ultra-fast 1.5 us transient response for load steps from 1 mA to 500 mA. The very low dropout of 42 mV at 500 mA enables efficient regulation from a 5.25 V input rail. Housed in a compact 3 mm x 3 mm LFCSP-8 with exposed pad, it requires only a 4.7 uF ceramic output capacitor.

Working Principle: ADM7170ACPZ-5.0-R7 Working Principle

The ADM7170ACPZ-5.0-R7 uses a PMOS pass transistor controlled by a high-bandwidth error amplifier. The amplifier compares the output sense voltage with an internal precision 5.0 V bandgap reference. Any deviation drives the PMOS gate to restore regulation within 1.5 us for large load transients. The CMOS architecture ensures ground current remains at 0.7 mA (no-load) independent of output current, unlike bipolar LDOs where ground current scales with load. The SENSE pin enables remote output voltage sensing at the load point. The SS pin allows programmable soft-start via an external capacitor to limit inrush current. The precision enable (EN) circuit has a 1.2 V threshold with 40 mV hysteresis, enabling deterministic power sequencing. Overcurrent protection and thermal shutdown safeguard the device under fault conditions.

Pin Description: ADM7170ACPZ-5.0-R7 Pin Definition and Functions
Pin Name Description
1 VOUT Regulated 5.0 V output; connect 4.7 uF ceramic capacitor to GND
2 VOUT Regulated output (duplicate for current capacity)
3 SENSE Output voltage sense feedback; connect to load point for remote sensing
4 SS Soft-start control; connect capacitor to GND for programmable ramp time
5 EN Enable input; precision 1.2 V threshold for supply sequencing
6 GND Ground reference
7 VIN Input supply (5.1 V to 6.5 V recommended)
8 VIN Input supply (duplicate)
EP GND Exposed thermal pad; solder to PCB ground plane
Application Scenarios: In which products and applications is ADM7170ACPZ-5.0-R7 used
  • 5 V Analog Rail: Ultra-clean supply for precision op-amps, ADC reference buffers, and sensor signal chains
  • RF Front-End Power: Low-noise LNA, mixer, and PLL supply in wireless transceivers up to 6 GHz
  • USB-Powered Devices: Regulating 5 V USB bus to a clean 5 V rail with minimal dropout
  • Test Equipment: Low-noise supply for oscilloscope front-ends and spectrum analyzer LO stages
  • Medical Instrumentation: Battery-powered diagnostic equipment requiring low-noise analog supplies
Alternative Models: What chips are recommended as replacements for ADM7170ACPZ-5.0-R7
Model Manufacturer Vout Iout Noise Package
ADM7170ACPZ-3.3-R7 Analog Devices 3.3 V 500 mA 5 uVrms LFCSP-8
LT3042 Analog Devices Adj 200 mA 0.8 uVrms DFN-12
TPS7A4700 Texas Instruments Adj 1 A 3.8 uVrms VSON-10
ADM7150ACPZ-5.0-R7 Analog Devices 5.0 V 800 mA 1.0 uVrms LFCSP-8
NCP511 onsemi 5.0 V 300 mA 8 uVrms DFN-6

ADM7170ACPZ-5.0V-R7 is a 500mA ultralow noise CMOS LDO from Analog Devices with 5µVrms noise, 60dB PSRR at 100kHz, and 1.5µs fast transient response in 3x3mm LFCSP-8. The family includes 1.8V, 3.3V, and 5.0V fixed-output variants with identical performance. For higher current, ADM7150 provides 800mA with 1.0µVrms noise. For adjustable output, ADM7170ACPZ offers programmable voltage. The TPS7A7001 from TI is a competitive 1A low-noise LDO alternative.

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1