Opens in a new tab

BTS5180-2EKA

AEC-qualified dual 180mΩ smart high-side switch, 2A/ch, kILIS=550, PROFET+ 12V, DSO-14-40 EP

0

Effective Inventory

Image for reference only

Manufacturer Part:

BTS5180-2EKA

Package:

PG-DSO-14-40 EP (8.65 x 3.9 x 1.47 mm, exposed pad)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The BTS5180-2EKA is an Infineon PROFET™+ 12V dual-channel smart high-side power switch in a PG-DSO-14-40 EP (exposed pad) package. Each channel features 180mΩ typical on-resistance, 2A nominal load current (1.5A with both channels), proportional load current sensing (kILIS=550), and comprehensive protection including over-temperature, over-current, and short-circuit diagnostics. AEC qualified and built on Smart6 technology.

Key Specifications

Channels 2 (dual high-side switch)
On-Resistance (RDS(on)) Typ 180mΩ @ 25°C; 360mΩ max @ 150°C
Nominal Load Current (1 ch active) 2A @ TA=85°C
Nominal Load Current (2 ch active) 1.5A @ TA=85°C
Operating Voltage Range 5V to 28V
Maximum Supply Voltage 41V
Current Sense Ratio (kILIS) 550 (typical)
Minimum Current Limitation 8A (short circuit)
Standby Current (IS(OFF)) 500nA max @ 25°C
Operating Temperature -40°C to +150°C
Qualification AEC qualified

Features

  • PROFET™+ 12V family member, Smart6 technology
  • Dual-channel high-side switch with 180mΩ typ. on-resistance
  • Proportional load current sense output (kILIS=550)
  • Open load detection in ON and OFF state
  • Short circuit to ground and battery detection
  • Over-temperature protection with restart
  • Over-current protection with intelligent restart
  • Overvoltage protection with external components
  • Undervoltage shutdown
  • Reverse polarity protection with external components
  • 3.3V and 5V compatible logic inputs
  • Diagnostic enable (DEN) and channel select (DSEL)

Applications

  • Automotive lamp drivers (up to 1 x 5W + LEDs)
  • Body electronics power distribution
  • Valve and solenoid drivers
  • Relay and fuse replacement
  • Automotive HVAC actuators
Product Introduction: BTS5180-2EKA Product Introduction

The BTS5180-2EKA is an Infineon PROFET™+ 12V dual-channel smart high-side power switch in a PG-DSO-14-40 EP package. Each channel features 180mΩ typical on-resistance, 2A nominal load current at 85°C, and proportional current sensing with kILIS=550. Built on Smart6 technology, it provides over-temperature protection with controlled restart, over-current protection, open/short load detection, undervoltage shutdown, and reverse polarity protection. AEC qualified for automotive lamp driving (up to 1x5W bulbs and LEDs), valve control, and body electronics power distribution.

Working Principle: BTS5180-2EKA Working Principle

The BTS5180-2EKA operates as a dual-channel smart high-side power switch. Each channel contains a power DMOS transistor, charge pump, and protection circuitry. The INx pins control channel on/off. The charge pump generates a gate voltage above the supply rail to drive the N-channel DMOS, ensuring low RDS(on) even at low battery voltages. The IS pin provides a proportional current sense output: the sense current equals the load current divided by kILIS (550), allowing the MCU to monitor load current via an external resistor. The DEN and DSEL pins control diagnostic output: DEN enables the IS pin, and DSEL selects which channel’s diagnosis appears. Over-temperature protection uses absolute shutdown at 170°C typ. with 20°C hysteresis for controlled restart. Over-current protection trips at 8A min and uses intelligent restart to prevent DMOS damage. The 500nA max standby current minimizes battery drain when channels are off.

Pin Description: BTS5180-2EKA Pin Definition and Functions
Pin Mnemonic Description
1 GND Ground
2 IN0 Input channel 0 (active high)
3 DEN Diagnostic enable (active high)
4 IS Current sense output (analog)
5 DSEL Diagnosis channel select
6 IN1 Input channel 1 (active high)
7 N.C. Not connected
8-10 OUT0 Output channel 0
11 N.C. Not connected
12-14 OUT1 Output channel 1
EP VS Exposed pad (battery supply)
Application Scenarios: In which products and applications is BTS5180-2EKA used
  • Automotive 5W lamp driver with dual-channel switching and open/short load diagnostics
  • Body control module power distribution with proportional current sensing for load health monitoring
  • HVAC valve and actuator driver with over-temperature controlled restart at 180mΩ
  • Automotive LED lamp driver with kILIS=550 current monitoring and short circuit protection
  • Relay replacement with 500nA standby current for energy-efficient ECU design
Alternative Models: What chips are recommended as replacements for BTS5180-2EKA
Model Manufacturer Key Difference
BTS5120-2EKA Infineon 120mΩ, 2.5A, same family
BTS5020-2EKA Infineon 33mΩ, 7A, higher power
BTS70402EPAXUMA1 Infineon PROFET+2, 19mΩ, ISO 26262
TPS1H100AQPWPRQ1 TI Single ch, 100mΩ, SPI
NCV8402 onsemi Single ch, 150mΩ, self-limiting

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1