Opens in a new tab

CP2103-GM

USB-to-UART bridge, 1Mbps, QFN-28

8201

Effective Inventory

Image for reference only

Manufacturer Part:

CP2103-GM

Package:

QFN-28 (5x5mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The CP2103-GM from Silicon Labs is a USB-to-UART bridge controller supporting 1Mbps data rate with integrated EEPROM in QFN-28 for USB connectivity solutions.

Key Specifications

Package QFN-28 (5x5mm)

Features

  • See datasheet for complete specifications
  • Industry-standard package

Applications

  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
Product Introduction: CP2103-GM Product Introduction

The CP2103-GM from Silicon Labs is a USB-to-UART bridge controller supporting 1Mbps data rate with integrated EEPROM in QFN-28 for USB connectivity solutions.

Working Principle: CP2103-GM Working Principle

The CP2103-GM is a USB 2.0 Full-Speed to UART bridge controller from Silicon Labs in QFN-28 (5x5mm), providing a complete USB-to-serial solution with no external firmware required. The device integrates: (1) USB 2.0 Full-Speed transceiver (12Mbps); (2) USB protocol controller (handles enumeration, SETUP packets, and data transfers); (3) UART with full modem control (TXD, RXD, CTS, RTS, DSR, DTR, DCD, RI); (4) Internal 3.3V regulator (powered from VREGIN); (5) 256-byte transmit and 256-byte receive FIFO buffers; (6) Configurable GPIO pins (GPIO0-2). The device appears as a Virtual COM Port (VCP) on the host PC after installing the Silicon Labs driver. The UART baud rate is programmable from 300bps to 1Mbps. The modem control lines allow hardware flow control (CTS/RTS) and DTR/DSR for device reset and configuration. The GPIO pins can be configured as: LED indicators (TX/RX activity), hardware flow control extensions, or general-purpose I/O. The device supports USB suspend mode: when the host enters suspend, the SUSPEND pin goes HIGH, allowing the external circuit to reduce power consumption. The on-chip EPROM stores USB vendor ID (VID), product ID (PID), serial number, and device description strings, allowing customization without external Flash. The -GM suffix specifies QFN-28, industrial temperature (-40C to +85C). Applications include: USB debug ports, firmware update interfaces, and industrial USB-to-RS-232/RS-485 adapters.

Pin Description: CP2103-GM Pin Definition and Functions
Pin Name Type Function
1 VREGIN Power USB bus power input (4.0-5.25V, powers internal 3.3V regulator)
2 GND Power Ground
3 VBUS Input USB VBUS detect (connects to USB VBUS through 47k resistor)
4-5 D+/D- I/O USB data lines (connect to USB connector with 1.5k pull-up on D+)
6-9 TXD/RXD/CTS#/RTS# I/O UART data and flow control (3.3V CMOS levels)
10-13 DSR#/DTR#/DCD#/RI# I/O UART modem status lines (3.3V CMOS)
14-17 GPIO0-GPIO2/SUSPEND I/O General-purpose I/O / USB suspend indication
18-28 VDD/GND/NC Power 3.3V regulated output / ground / no connect
Application Scenarios: In which products and applications is CP2103-GM used
  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
  • Alternative Models: What chips are recommended as replacements for CP2103-GM
    Manufacturer Part Number Package Notes
    Silicon Labs CP2103-GM QFN-28 Same device, SiLabs brand
    Silicon Labs CP2102N-A02-GQFN24 QFN-24 Newer generation, fewer pins, lower cost
    FTDI FT232RL SSOP-28 USB-to-UART, FTDI brand, more features
    WCH CH340G SOP-16 USB-to-UART, WCH brand, very low cost
    Microchip MCP2200-I/SO SOIC-20 USB-to-UART, Microchip brand

    Recommend Parts

    RK73H1ETTP20R0F

    20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

    Brand: KOA Speer

    Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

    IN STOCK: 33180pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    TPS77001DBVR

    50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

    Brand: TI

    Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

    IN STOCK: 5000pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    TPS61021ADSGR

    3A synchronous boost converter, 1.8-5.5V, VSSOP-8

    Brand: TI

    Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

    IN STOCK: 12398pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    S1MB-13-F

    1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

    Brand: Diodes Inc

    Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

    IN STOCK: 3679pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    ADUM5000ARWZ-RL

    500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

    Brand: ADI

    Package: SOIC-16W (10.3 x 7.5 mm, RW package)

    IN STOCK: 6373pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    ADS830E/2K5

    8-bit 60MSPS high-speed ADC, TSSOP-24

    Brand: TI

    Package: TSSOP-24 (7.8 x 4.4 mm)

    IN STOCK: 9357pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1