Opens in a new tab

DRV8432DKDR

Dual H-bridge motor driver, 2x7A, 52.5V, 110mΩ, 500kHz, HSSOP-36 (OBSOLETE)

14743

Effective Inventory

Image for reference only

Manufacturer Part:

DRV8432DKDR

Package:

HSSOP-36 (15.9 x 14.2 mm, with heat slug)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The DRV8432DKDR is a dual full-bridge PWM motor driver from Texas Instruments with up to 2 × 7A continuous output current (2 × 12A peak). It features 110 mΩ RDS(ON) MOSFETs, 52.5V load voltage, 500 kHz switching, and comprehensive protection in a 36-pin HSSOP package with heat slug. (Note: this product has been discontinued.)

Key Specifications

Configuration Dual full-bridge (4 half-bridges)
Continuous Output Current 2 × 7A (dual full-bridge)
Peak Output Current 2 × 12A (dual full-bridge)
Load Voltage (PVDD) 0 V to 52.5 V
Logic Supply (GVDD/VDD) 10.8 V to 13.2 V (12 V nominal)
RDS(ON) (HS + LS) 110 mΩ + 110 mΩ
PWM Frequency Up to 500 kHz
Efficiency Up to 97%
Operating Temperature -40°C to +150°C (junction)
Package HSSOP-36 (DKD), with heat slug

Features

  • High-efficiency power stage up to 97%
  • Low RDS(ON): 110 mΩ per switch at 25°C
  • Up to 52.5V load supply voltage
  • 2 × 7A continuous, 2 × 12A peak output
  • Parallel mode: 14A continuous, 24A peak
  • PWM up to 500 kHz switching frequency
  • Programmable cycle-by-cycle current limit
  • Overcurrent, overtemperature, UVLO, short circuit protection
  • Independent supply and ground per half-bridge
  • Intelligent gate drive with cross-conduction prevention
  • No external snubber or Schottky diode required

Applications

  • Brushed DC and stepper motors
  • Three-phase PMSM motors
  • Robotics and haptic control
  • Actuators and pumps
  • TEC (thermoelectric cooler) drivers
Product Introduction: DRV8432DKDR Product Introduction

The DRV8432 is a high-performance dual full-bridge PWM motor driver from Texas Instruments with an advanced protection system. It features low RDS(ON) MOSFETs (110 mΩ) achieving up to 97% efficiency, enabling smaller power supplies and heatsinks. The DRV8432 supports up to 2 × 7A continuous output current (2 × 12A peak) in dual full-bridge mode, or 14A continuous (24A peak) in parallel mode. It requires two power supplies: 12V for GVDD/VDD and up to 50V for PVDD. The device operates at up to 500 kHz switching frequency and includes programmable cycle-by-cycle current limit, overcurrent, overtemperature, undervoltage, and short circuit protection. Note: This product has been obsoleted by TI; recommended replacements are DRV8462 or DRV8962.

Working Principle: DRV8432DKDR Working Principle

The DRV8432 integrates four half-bridge power stages using N-channel MOSFETs with 110 mΩ RDS(ON) per switch. Each half-bridge has independent PVDD and GND pins, allowing different supply voltages per bridge and enabling current sensing through external shunt resistors. The gate drive circuit uses bootstrap capacitors to drive the high-side NMOS gates, with intelligent timing to prevent cross-conduction. PWM inputs control each half-bridge independently. The M1/M2/M3 pins select the operating mode: dual full-bridge (2 or 4 PWM), parallel full-bridge, or complementary PWM mode. The OC_ADJ pin with an external resistor sets the overcurrent threshold for cycle-by-cycle current limiting. The OTW (overtemperature warning) and FAULT outputs provide real-time status. An internal 3.3V regulator (VREG) powers the digital logic. The thermal pad and heat slug must be properly heatsinked for full-current operation.

Pin Description: DRV8432DKDR Pin Definition and Functions
Pin Name Type Description
1-4 GVDD_B/C/D, NC Power Gate drive supplies
5 PWM_D Input Half-bridge D PWM input
6 RESET_CD Input Reset bridges C and D (active low)
7 PWM_C Input Half-bridge C PWM input
8-10 M1, M2, M3 Input Mode selection pins
11 VREG Power Internal 3.3V regulator filter
12 AGND Power Analog ground
13 GND Power Digital ground
14 OC_ADJ Analog Overcurrent programming resistor
15-18 PWM_B/A, RESET_AB Input Bridge A/B PWM and reset
19-22 OTW, GVDD_B, FAULT Output Status outputs and gate supply
23-36 PVDD/GND/OUT Power Bridge power and outputs
Application Scenarios: In which products and applications is DRV8432DKDR used
  • Brushed DC Motor Drive: Dual full-bridge mode drives two independent DC motors with up to 7A continuous current each
  • Stepper Motor Control: Dual H-bridge configuration supports bipolar stepper motors with 12A peak current
  • Robotics and Haptics: 500 kHz PWM enables precise force and position control in robotic actuators
  • TEC Drivers: Bidirectional current capability and high efficiency suit thermoelectric cooler applications
  • Industrial Actuators: 52.5V load voltage and 97% efficiency support high-power industrial motion systems
Alternative Models: What chips are recommended as replacements for DRV8432DKDR
Model Manufacturer Key Difference Package Specs
DRV8462DDWR TI Direct replacement, improved, in production – –
DRV8962DDWR TI Direct replacement, improved, in production – –
DRV8412DDWR TI 3A version (44-pin HTSSOP) – –
L298N ST 2A per bridge, through-hole, lower cost – –
TMC6140-TA Trinamic 3-phase, similar power range – –

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1