Opens in a new tab

IRF4905PBF

P-ch MOSFET, -55V -74A, 20mΩ, TO-220, high-side switch

33428

Effective Inventory

Image for reference only

Manufacturer Part:

IRF4905PBF

Package:

TO-220AB (15.6 x 10.6 x 4.6mm, through-hole, tab=Drain)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The IRF4905PBF from Infineon Technologies is a -55V P-channel HEXFET power MOSFET with 20mΩ on-resistance, -74A continuous drain current, and 200W power dissipation in a TO-220 package — the P-channel complement to the IRF3205 for high-side switching applications.

Key Specifications

Type P-Channel Enhancement MOSFET
Drain-Source Voltage (VDSS) -55V
Continuous Drain Current (ID) -74A @ TC=25°C; -52A @ TC=100°C
Pulsed Drain Current (IDM) -260A
On-Resistance (RDS(on)) 0.020Ω (20mΩ) @ VGS=-10V, ID=-38A
Gate Threshold Voltage (VGS(th)) -2.0V to -4.0V
Forward Transconductance (gfs) 21S typical
Total Gate Charge (Qg) 180nC max (120nC typ @10V per Infineon)
Input Capacitance (Ciss) 3400pF @ VDS=-25V
Turn-On Delay / Rise Time 18ns / 99ns typical
Turn-Off Delay / Fall Time 61ns / 96ns typical
Body Diode Forward Voltage (VSD) -1.6V typical @ IS=-38A
Reverse Recovery Time (trr) 89ns typical
Power Dissipation 200W @ TC=25°C
Thermal Resistance (θJC) 0.75°C/W
Operating Temperature -55°C to +175°C
Package TO-220AB (through-hole, tab=Drain)

Features

  • Ultra-low RDS(on): 20mΩ — low for a P-channel MOSFET
  • -74A continuous drain current
  • Fully avalanche rated
  • 175°C maximum junction temperature
  • High-side switch capability (source to VDD)
  • P-channel — gate pulled LOW turns ON

Applications

  • High-side power switching
  • Battery disconnect / protection
  • Reverse polarity protection
  • Motor H-bridge (P-ch high side + N-ch low side)
  • Load switching in automotive systems
Product Introduction: IRF4905PBF Product Introduction

The IRF4905PBF from Infineon Technologies (formerly International Rectifier) is a -55V P-channel power MOSFET with 20mΩ on-resistance and -74A drain current. As a P-channel device, it excels at high-side switching: the source connects to the positive supply rail, and pulling the gate LOW (below the source by at least 10V) turns the MOSFET ON. This eliminates the need for a bootstrap charge pump that N-channel high-side drivers require, simplifying the gate drive circuit significantly. The 20mΩ RDS(on) is impressive for a P-channel MOSFET (P-channel typically has 2-3× the RDS(on) of an equivalent N-channel due to lower hole mobility), but it’s still 2.5× the 8mΩ of the N-channel IRF3205. At 20A load, the conduction loss is P = I²×RDS(on) = 400×0.02 = 8W — manageable with a moderate heatsink. The IRF4905 is the P-channel complement commonly paired with the IRF3205 (N-channel) in half-bridge and H-bridge motor drive circuits. The PBF suffix denotes the lead-free TO-220 package.

Working Principle: IRF4905PBF Working Principle

The IRF4905PBF is a P-channel enhancement-mode MOSFET. Current flows from source to drain (conventional current) when the gate is pulled LOW relative to the source by at least |VGS(th)| (2-4V). For minimum RDS(on) of 20mΩ, VGS must be at least -10V (i.e., gate is 10V below the source). For a high-side switch with source at +12V: the gate must be pulled to +2V or lower (12V − 10V = 2V) for full enhancement. A simple NPN transistor or N-channel MOSFET can pull the gate to GND (VGS = -12V, well beyond the -10V requirement). To turn OFF, the gate must be pulled up to near the source voltage (VGS ≈ 0V). A pull-up resistor (10kΩ) from gate to source ensures the MOSFET turns off when the NPN driver is off. Important: VGS must never exceed ±20V. In a 24V system, pulling the gate to GND gives VGS = -24V, exceeding the absolute maximum. A Zener clamp (15V Zener between gate and source) is required. The body diode points from source to drain (anode at source), so it conducts when drain voltage exceeds source voltage. In an H-bridge, the body diode serves as a freewheeling path. The 89ns reverse recovery time of the body diode is moderate — adequate for frequencies below 50kHz.

Pin Description: IRF4905PBF Pin Definition and Functions
Pin Name Type Description
1 Gate Input Gate control terminal. Pull Gate BELOW Source to enhance the P-channel MOSFET. Apply VGS < -4V (-10V recommended for lowest RDS(on) of 78mΩ). Maximum VGS rating is ±20V. Gate charge is 120nC typical. Use a gate resistor (10-47Ω) in series to control turn-on dv/dt and reduce ringing.
2 Drain Power Output Drain terminal connected to the load. Rated for -55V VDS and -74A continuous drain current at TC=25°C. The TO-220 tab is electrically connected to Drain. On-resistance is 78mΩ typ at VGS=-10V, ID=-39A. Maximum power dissipation 250W at TC=25°C.
3 Source Power Output Source terminal typically connected to the positive supply rail for high-side P-channel switching. Internal body diode conducts from Drain to Source (opposite direction to N-channel). Ideal for reverse-polarity protection, battery disconnect switches, and high-side load switching up to 55V.

IRF4905PBF pin assignment (TO-220-3, front view, pins down): Pin 1 (left) = Gate, Pin 2 (center) = Drain/Tab, Pin 3 (right) = Source. This is a P-channel MOSFET — Gate must be pulled below Source to turn ON. Common application: Source to VCC, Drain to load, Gate to GND for ON and Gate to VCC for OFF. The tab is connected to Drain. Complementary N-channel: IRF3205 (55V/110A). For surface-mount, use IRF4905SPBF (D2PAK).

Application Scenarios: In which products and applications is IRF4905PBF used
  • High-Side Switch (12V): Source→+12V; Gate→NPN collector (emitter GND); 10kΩ pull-up gate-to-source; Load between drain and GND; MCU→NPN base→gate LOW→MOSFET ON
  • Battery Disconnect: Source→Battery+; Drain→System VCC; Gate pulled LOW by control circuit = battery connected; Gate released = battery disconnected
  • Reverse Polarity Protection: Source→Battery+; Drain→System; Gate→GND; if battery reversed, body diode blocks and MOSFET stays off
  • H-Bridge Motor Drive: IRF4905 (P-ch) on high sides; IRF3205 (N-ch) on low sides; gate drivers for each; bidirectional motor control
  • 24V System (with clamp): 15V Zener gate-to-source; Source→+24V; Gate driver pulls to +9V (VGS=-15V, within limits)
Alternative Models: What chips are recommended as replacements for IRF4905PBF
Model Manufacturer Key Difference Package Specs
IRF9540NPBF Infineon -100V/-19A/0.2Ω, higher voltage, lower current – –
IRF4905SPBF Infineon Same in D2PAK (TO-263) surface-mount – –
IRF3205PBF Infineon N-channel complement, 55V/110A/8mΩ – –
FQP47P06 onsemi -60V/-47A/26mΩ, similar range, TO-220 – –
NDP6020P onsemi -20V/-20A/0.065Ω, logic-level gate, TO-220 – –

IRF4905PBF is a -55V/-74A P-channel MOSFET from Infineon in TO-220. The IRF4905SPBF provides the same in D2PAK surface-mount. The FQP47P06 offers lower 26mΩ RDS(on) at -60V/-47A from ONsemi. The IRFP460 is an N-channel alternative for complementary push-pull designs. The SUM110P06-25 from Vishay provides -60V/-110A with 18mΩ for extreme current applications. The IRF9540NPBF offers -100V/-19A for higher voltage at lower current. For logic-level drive, IRL4905PBF is not available — use FQP47P06 which reaches full enhancement at -5V VGS.

Recommend Parts

IRFS4310ZTRLPBF

IRFS4310ZTRLPBF – 100V N-Channel HEXFET Power MOSFET, 7 mΩ RDS(on), D2PAK (TO-263AB)

Brand: infineon

Package: D2PAK (TO-263AB)

IN STOCK: 11137pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MSASJ105BB5475MFNA01

4.7uF 6.3V X5R MLCC, 0402, Taiyo Yuden

Brand: gigadevice

Package: 0402 (1005 Metric, 1.0 x 0.5 x 0.5 mm)

IN STOCK: 9701pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRF3415PBF

150V N-channel power MOSFET, 43A, 41mΩ RDS(on), TO-220AB package

Brand: infineon

Package: TO-220AB

IN STOCK: 2940pcs

Cargo cycle: 3-7 Days

The minimum order is 1

105017-1001

USB Type-C receptacle connector, 24-pin, SMD

Brand: Amphenol

Package: SMD (8.9 x 7.3 x 3.2 mm, right angle)

IN STOCK: 5335pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRLB3034PBF

IRLB3034PBF – 40V N-Channel StrongIRFET Power MOSFET (Logic Level), 1.7 mΩ (max) @ 10V; 2.0 mΩ @ 4.5V RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 9724pcs

Cargo cycle: 3-7 Days

The minimum order is 1

XC6SLX75-2FGG484I

Spartan-6 LX75 FPGA, 74637 logic cells, 132 DSP, 3096KB BRAM, 408 I/O, FBGA-484 23x23mm, -2 speed, industrial -40~100C, AMD Xilinx

Brand: xilinx

Package: FGG484 (484-ball fine-pitch BGA, 23x23mm body, 1.0mm ball pitch, 22×22 ball array, 6 I/O banks, lead-free)

IN STOCK: 890pcs

Cargo cycle: 3-7 Days

The minimum order is 1