Opens in a new tab

Home » Integrated Circuits ICs, MOSFETs » IRFL9110TRPBF

IRFL9110TRPBF

-100V -1.7A P-ch MOSFET, 0.6Ohm, SOT-223, 14nC Qg, high-side switch, no charge pump

8493

Effective Inventory

Image for reference only

Manufacturer Part:

IRFL9110TRPBF

Package:

SOT-223 (6.50 x 3.50 x 1.60 mm, surface mount)

Brand:

Product Categories:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The IRFL9110TRPBF from Infineon (formerly IR) is a -100V, -1.7A P-channel power MOSFET in a SOT-223 package. With 0.6 Ohm RDS(on), it provides efficient high-side switching for load control and power management applications.

Key Specifications

VDSS -100 V
ID -1.7 A (at TC=25C)
RDS(on) 0.6 Ohm (max, VGS=-10V)
Gate Charge (Qg) 14 nC (typical)
Power Dissipation 2.5 W (at TA=25C)
Operating Temperature -55C to +175C

Features

  • -100V P-channel for high-side switching without charge pump
  • 0.6 Ohm RDS(on) for efficient load switching at 1.7A
  • SOT-223 compact surface-mount package for space-constrained designs
  • 14nC low gate charge simplifies gate drive requirements
  • 175C maximum junction temperature for rugged operation
  • Simple high-side drive: pull gate to ground for turn-on

Applications

  • High-side load switching in battery-powered systems
  • Power routing and battery disconnect circuits
  • Reverse polarity protection using P-channel configuration
  • Motor and solenoid driver with simplified gate drive
Product Introduction: IRFL9110TRPBF Product Introduction

The IRFL9110TRPBF from Infineon (formerly International Rectifier) is a -100V, -1.7A P-channel power MOSFET in a SOT-223 surface-mount package. The P-channel architecture enables simple high-side switching without the charge pump circuitry required by N-channel MOSFETs, significantly simplifying the gate drive design. To turn on the MOSFET, the gate is pulled to ground (relative to the source connected to the supply), and to turn off, the gate is pulled up to the source voltage. The -100V rating supports direct connection to 48V and lower supply rails with margin for transients. The 0.6 Ohm maximum RDS(on) at VGS=-10V provides efficient conduction at the 1.7A current rating, with power dissipation manageable with standard PCB copper area in the SOT-223 package. The 14nC typical gate charge requires minimal drive current, enabling direct MCU GPIO drive for slow-switching applications. The 175C maximum junction temperature and 2.5W power dissipation rating support operation in demanding environments.

Working Principle: IRFL9110TRPBF Working Principle

The IRFL9110TRPBF is a P-channel vertical power MOSFET. (1) P-Channel Operation: In a P-channel MOSFET, current flows from source (connected to the positive supply) through the channel to drain (connected to the load) when the gate voltage is negative relative to the source. When VGS is below the threshold (typically -2 to -4V), holes form an inversion layer (channel) connecting the source P+ region to the drain P+ region through the N-type body. (2) High-Side Switch: The source is connected to the positive supply rail. When the gate is pulled to ground (VGS = -Vsupply), the MOSFET turns on, connecting the supply to the load. When the gate is pulled to the supply (VGS = 0V), the MOSFET turns off. This eliminates the need for a bootstrap or charge pump circuit that N-channel high-side switches require. (3) RDS(on): The 0.6 Ohm on-resistance is higher than equivalent N-channel devices (due to the lower hole mobility compared to electrons), but the simplified drive circuitry often justifies the trade-off for moderate current applications.

Pin Description: IRFL9110TRPBF Pin Definition and Functions
Pin Name Type Function
1 Gate Input Gate drive input
2 Drain Output Drain (tab, connected to heatsink area)
3 Source Output Source (connects to supply)
4 Drain Output Drain (same as pin 2, tab)
Application Scenarios: In which products and applications is IRFL9110TRPBF used
  • High-side load switching in battery-powered systems without charge pump
  • Power routing and battery disconnect circuits at -100V rating
  • Reverse polarity protection using P-channel configuration in SOT-223
  • Motor and solenoid driver with simplified gate drive from MCU GPIO
Alternative Models: What chips are recommended as replacements for IRFL9110TRPBF
Manufacturer Part Number Package Notes
Infineon IRF9Z34NPBF TO-220 -60V, -12A, higher current
Vishay IRF9Z24NPBF TO-220AB -60V, -12A, through-hole
onsemi FQP3P06 TO-220 -60V, -3.4A, popular
Infineon BSD235P6327HTSA1 SOT-223 -60V, -1.5A, SMD

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1