Opens in a new tab

LM2576SX-ADJ/NOPB

3A step-down switching regulator, adjustable, TO-263-5

6696

Effective Inventory

Image for reference only

Manufacturer Part:

LM2576SX-ADJ/NOPB

Package:

TO-263-5 (10.0 x 8.7 x 4.6 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

LM2576SX-ADJ/NOPB Overview

The LM2576SX-ADJ/NOPB is a SIMPLE SWITCHER series adjustable step-down DC-DC converter from Texas Instruments, with maximum input voltage of 40V, output current of 3A, in a TO-263-5 package. It integrates frequency compensation and a fixed frequency oscillator, greatly simplifying switching power supply design.

Key Features

  • Input voltage range: 4.5V-40V
  • Adjustable output voltage: 1.23V-37V
  • Maximum output current: 3A
  • Switching frequency: 52kHz
  • Standby current: 50uA (typical)
  • Efficiency up to 88%
  • Built-in thermal shutdown and current limiting
Product Introduction: LM2576SX-ADJ/NOPB Product Introduction

The LM2576SX-ADJ/NOPB is a 3 A adjustable step-down switching voltage regulator from Texas Instruments in a TO-263-5 (D2PAK) surface-mount package, providing output voltage adjustable from 1.23 V to 37 V. Operating from a 4 V to 40 V input at a fixed 52 kHz switching frequency, it requires only four external components (inductor, Schottky diode, input capacitor, output capacitor) plus two feedback resistors. Features include 77 percent typical efficiency, TTL-compatible shutdown with 50 uA standby current, cycle-by-cycle current limiting, and thermal shutdown protection. The output voltage tolerance is plus or minus 4 percent over input line and output load conditions.

Working Principle: LM2576SX-ADJ/NOPB Working Principle

The LM2576SX-ADJ/NOPB uses a fixed-frequency pulse-width modulation (PWM) buck converter topology operating at 52 kHz. The internal NPN Darlington power switch connects the input voltage to the output inductor during the on-time, causing inductor current to ramp up. When the switch turns off, the inductor current freewheels through the external Schottky catch diode, delivering stored energy to the output capacitor and load. The output voltage is sensed through an external resistor divider connected to the feedback (FB) pin, which is compared against the internal 1.23 V reference by the error amplifier. The error amplifier controls the PWM duty cycle to maintain the output at the desired voltage (Vout = 1.23 V x (1 + R2/R1)). The cycle-by-cycle current limit monitors switch current and terminates the on-time if it exceeds approximately 4.5 A. The ON/OFF pin allows TTL-level shutdown; pulling it below 1.4 V puts the device in standby mode with 50 uA typical current. Thermal shutdown disables the output switch when the die temperature exceeds approximately 170 C, with automatic recovery after cool-down. The 52 kHz switching frequency is a trade-off between inductor size and switching losses, allowing the use of low-cost standard inductors.

Pin Description: LM2576SX-ADJ/NOPB Pin Definition and Functions
Pin Name Description
1 VIN Input supply (4 V to 40 V); connect 100 uF electrolytic capacitor to GND
2 OUTPUT Switch output; connect to inductor and Schottky catch diode cathode
3 GND Ground; Tab is internally bonded to GND for thermal dissipation
4 FEEDBACK Output voltage feedback; connect resistor divider from VOUT to set output (Vout = 1.23V x (1+R2/R1))
5 ON/OFF Shutdown control; pull below 1.4 V to disable, leave open or pull above 2.4 V for normal operation
Tab GND Thermal tab; solder to PCB copper pour for heat dissipation
Application Scenarios: In which products and applications is LM2576SX-ADJ/NOPB used
  • Adjustable Power Supplies: Lab bench supplies and custom voltage rails from 1.23 V to 37 V with external resistor programming
  • Automotive Down-Conversion: 12 V or 24 V battery to adjustable logic and analog supply rails
  • Industrial 24 V to Variable Output: Programmable power for motor drivers, LED strings, and battery chargers
  • Distributed Power Architecture: Intermediate bus conversion from 48 V or 24 V to point-of-load adjustable voltage
  • Battery Charging: Adjustable constant-voltage charging stage for lead-acid and Li-ion battery packs
Alternative Models: What chips are recommended as replacements for LM2576SX-ADJ/NOPB
Model Manufacturer Iout Vin Vout Frequency Package
LM2576S-ADJ/NOPB Texas Instruments 3 A 4-40 V 1.23-37 V 52 kHz TO-263
LM2596S-ADJ/NOPB Texas Instruments 3 A 4-40 V 1.23-37 V 150 kHz TO-263
LM2576HVSX-ADJ Texas Instruments 3 A 4-60 V 1.23-57 V 52 kHz TO-263
AP1509-K5G-13 BCD Semiconductor 2 A 4.5-40 V 1.23-37 V 150 kHz SOIC-8
LMR33630 Texas Instruments 3 A 3.8-36 V 1.0-24 V 400 kHz QFN/HTSSOP

LM2576SX-ADJ/NOPB is an adjustable 1.23-37V/3A buck regulator from TI in TO-263-5. The LM2576S-ADJ provides the same in TO-263-5 with slightly different part numbering. The LM2596S-ADJ offers 150kHz switching for smaller inductors. The LMR51430 provides modern 500kHz switching in tiny VQFN. The AP1501A-K5G-13A offers lower-cost 3A adjustable in TO-263-5. The LM2676S-ADJ from TI provides 260kHz switching. For higher voltage, LM5005 provides 80V/2.5A buck in HTSSOP-20.

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1