Opens in a new tab

LT1761ES5-SD#TRPBF

100mA low-noise LDO, adjustable output, 20uVRms noise, 300mV dropout, 20uA Iq, shutdown in SOT-23-5

10710

Effective Inventory

Image for reference only

Manufacturer Part:

LT1761ES5-SD#TRPBF

Package:

SOT-23-5 (2.90 x 1.60 x 1.10 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The LT1761ES5-SD#TRPBF from Analog Devices (Linear Technology) is a 100mA low-noise LDO linear regulator with shutdown in a SOT-23-5 package. The SD suffix denotes the adjustable output version, featuring 20uVRms output noise, 300mV dropout at 100mA, and 20uA quiescent current, making it ideal for noise-sensitive battery-powered applications.

Key Specifications

Output Voltage Adjustable (SD version)
Output Current 100mA
Input Voltage Range 1.8V ~ 20V
Dropout Voltage 300mV (Typical) @ 100mA
Output Noise 20uVRms (Typical, 0.1Hz-100kHz)
Quiescent Current 20uA (Typical)
Shutdown Current <1uA
Shutdown Function Yes (SD pin)
Minimum Output Capacitor 1uF (Ceramic)
Package SOT-23-5 (2.90 x 1.60mm)
Operating Temperature -40°C ~ +125°C

Features

  • Ultra-low 20uVRms output noise for sensitive analog circuits
  • Very low 300mV dropout voltage at full 100mA load
  • 20uA quiescent current extends battery life
  • Shutdown mode draws less than 1uA
  • Stable with only 1uF ceramic output capacitor
  • Wide 1.8V to 20V input voltage range
  • Adjustable output via external resistor divider (SD version)
  • Lead-free TRPBF packaging

Applications

  • RF and wireless receiver power supplies
  • Low-noise ADC/DAC reference supplies
  • Battery-powered instrumentation
  • Portable medical devices
  • Cell phone and PDA power management
Product Introduction: LT1761ES5-SD#TRPBF Product Introduction

The LT1761ES5-SD#TRPBF from Analog Devices (formerly Linear Technology) is a micropower, low-noise LDO linear regulator in a 5-pin SOT-23 package. The SD (adjustable) version allows the output voltage to be set from 1.22V to 20V using an external resistor divider. The device achieves an exceptionally low output noise of 20uVRms over the 0.1Hz to 100kHz bandwidth, making it suitable for powering noise-sensitive RF receivers, high-resolution ADCs, and precision analog circuits. The 300mV dropout voltage at 100mA load enables operation from batteries with minimal voltage headroom. The 20uA quiescent current is among the lowest for any LDO in this performance class, and the shutdown pin reduces supply current to less than 1uA for power-saving modes. The device is stable with just a 1uF ceramic output capacitor, simplifying PCB layout.

Working Principle: LT1761ES5-SD#TRPBF Working Principle

The LT1761ES5-SD uses a PNP pass transistor in a series-pass linear regulator topology. The error amplifier compares the feedback voltage (FB pin) with an internal 1.22V bandgap reference and drives the base of the PNP pass transistor to maintain regulation. The low 300mV dropout is achieved because the PNP transistor operates in saturation, requiring only VCE(sat) of headroom rather than the VGS+VDS of MOSFET-based LDOs. The ultra-low output noise is achieved through an internal RC filter on the bandgap reference that attenuates reference noise before it reaches the error amplifier. The shutdown (SD) pin controls the pass transistor bias; when SD is pulled low, the bias circuitry is disabled and the pass transistor is turned off, reducing supply current to less than 1uA. The output capacitor provides frequency compensation and must be at least 1uF with ESR less than 2 ohms for stability.

Pin Description: LT1761ES5-SD#TRPBF Pin Definition and Functions
Pin Name Function
1 OUT Regulated output voltage
2 GND Ground
3 SD Shutdown control – pull low to disable, high or float to enable
4 FB Feedback input – connect resistor divider from output
5 IN Input supply voltage (1.8V-20V)
Application Scenarios: In which products and applications is LT1761ES5-SD#TRPBF used
  • RF Receiver LNA Power: 20uVRms output noise preserves receiver sensitivity; 1uF ceramic capacitor enables compact RF module layout
  • High-Resolution ADC Reference: Ultra-low noise prevents degradation of 16-24 bit ADC effective resolution; adjustable output matches ADC VREF requirements
  • Portable Medical Instrument: 20uA Iq and sub-1uA shutdown current extend battery life in handheld diagnostic devices
  • Wireless Sensor Node: Wide 1.8-20V input accommodates single-cell Li-ion to 12V industrial supply; shutdown mode for duty-cycled operation
Alternative Models: What chips are recommended as replacements for LT1761ES5-SD#TRPBF
Model Manufacturer Key Difference
LT1761ES5-3.3#TRPBF ADI Fixed 3.3V output version
LT1761ES5-5#TRPBF ADI Fixed 5V output version
LT1761ES5-2.5#TRPBF ADI Fixed 2.5V output version
TPS7A4700RGWR TI 150mA, 3.8uVRms noise, VQFN
ADM7150ARDZ ADI 800mA, 1uVRms noise, SOIC-8

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1