Opens in a new tab

Home » DC-DC Converters, Integrated Circuits ICs » LT8610ABEMSE#TRPBF

LT8610ABEMSE#TRPBF

42V 2.5A synchronous buck, 2.5MHz, 2.5uA IQ, MSOP-10

8924

Effective Inventory

Image for reference only

Manufacturer Part:

LT8610ABEMSE#TRPBF

Package:

MSOP-10 (3x3mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The LT8610ABEMSE#TRPBF from Analog Devices is a 42V, 2.5A synchronous step-down regulator with 2.5uA quiescent current and 2.5MHz switching in MSOP-10 for automotive and industrial power supplies.

Key Specifications

Package MSOP-10 (3x3mm)

Features

  • See datasheet for complete specifications
  • Industry-standard package

Applications

  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
Product Introduction: LT8610ABEMSE#TRPBF Product Introduction

The LT8610ABEMSE#TRPBF from Analog Devices is a 42V, 2.5A synchronous step-down regulator with 2.5uA quiescent current and 2.5MHz switching in MSOP-10 for automotive and industrial power supplies.

Working Principle: LT8610ABEMSE#TRPBF Working Principle

The LT8610ABEMSE#TRPBF is a 42V 2.5A synchronous step-down regulator from Analog Devices in MSOP-10, with 2.5uA quiescent current in burst mode. The A-revision improves EMI performance with controlled edge rates on the switch node. The synchronous design eliminates the external Schottky diode by using an internal low-side MOSFET (catch FET) for freewheeling, improving efficiency by 3-5% compared to asynchronous designs. The device uses a current-mode control architecture: an error amplifier compares the FB voltage with the 0.97V internal reference; the error amplifier output controls the peak inductor current; the peak current is sensed cycle-by-cycle for stability and current limiting. The switching frequency is fixed at 1MHz (also available in 2MHz for LT8610AB-2), allowing small 2.2-4.7uH inductors. The burst mode operation is the key low-Iq feature: at light load (below approximately 100mA), the device delivers a burst of switching cycles, then enters a low-Iq sleep state where only the reference and error amplifier remain active (2.5uA total). This results in extremely low standby power consumption, critical for always-on automotive and battery-powered systems. The minimum on-time is 50ns, allowing high step-down ratios (e.g., 42V to 3.3V at 1MHz). The EN/UV pin can set a precise undervoltage threshold using a resistor divider. The TR/SS pin provides programmable soft-start and voltage tracking (for sequencing multiple rails). The -BEMSE#TRPBF suffix specifies MSOP-10, tape-and-reel, lead-free.

Pin Description: LT8610ABEMSE#TRPBF Pin Definition and Functions
Pin Name Type Function
1 BOOST1 Power Bootstrap capacitor for internal high-side switch (connect 0.1uF to SW)
2 SW1 Output Switch node 1 (connects to inductor, 2.5A peak)
3 VIN1 Power Input supply 1 (3.4-42V, connect with 4.7uF ceramic cap)
4 EN/UV Input Enable/undervoltage lockout (float=always on, add resistor divider for UVLO)
5 TR/SS Analog Track/soft-start (connect 0.1uF to GND for 3ms soft-start)
6 PG Output Power good (open-drain, HIGH when output within +/-8% of target)
7 VOUT1 Input Output voltage sense 1 (connect to output rail for regulation)
8 GND Power Ground (connect exposed pad to GND plane)
Application Scenarios: In which products and applications is LT8610ABEMSE#TRPBF used
  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
  • Alternative Models: What chips are recommended as replacements for LT8610ABEMSE#TRPBF
    Manufacturer Part Number Package Notes
    Analog Devices LT8610ABEMSE#TRPBF MSOP-10 Same device, ADI brand
    Analog Devices LT8610ACMSE#PBF MSOP-10 C-grade, slightly wider spec
    Texas Instruments LM53603NQDRRRQ1 VQFN-12 3A, 36V, automotive buck, TI brand
    Monolithic Power MP8759GD-Z QFN-12 4A, 18V, sync buck, MP brand
    Richtek RT6208GQW WQFN-12 2A, 36V, buck, Richtek brand

    Recommend Parts

    TMP275AIDR

    0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

    Brand: TI

    Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

    IN STOCK: 3681pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    IL485E

    NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

    Brand: nve

    Package: SOIC-16 WB

    IN STOCK: 5280pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    IRFS4227TRLPBF

    IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

    Brand: infineon

    Package: D2PAK (TO-263)

    IN STOCK: 4334pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    CD4070BM96

    Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

    Brand: TI

    Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

    IN STOCK: 4245pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    AB1526

    Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

    Brand: airoha

    Package: BGA

    IN STOCK: 25000pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    LP2980IM5-5.0

    50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

    Brand: TI

    Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

    IN STOCK: 2557pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1