Opens in a new tab

MIC2026-1YM-TR

Dual 500mA power switch, 300mOhm, current limit, fault flags, SOIC-8

4256

Effective Inventory

Image for reference only

Manufacturer Part:

MIC2026-1YM-TR

Package:

8-SOIC (4.9 x 3.9 x 1.75 mm, YM package)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The MIC2026-1YM-TR from Microchip is a dual-channel power distribution switch with 500mA per channel, current limiting, thermal shutdown, and fault flags in an 8-pin SOIC package.

Key Specifications

Function Dual Channel Power Distribution Switch
Number of Switches 2 (independent)
Input Voltage 2.7V to 5.5V
Switch Current Limit 500 mA (typ per channel)
RDS(on) 300 mOhm (typ @ 5V, per switch)
Enable Input Active high (per channel)
Fault Flag (FLG) Open-drain, active low (per channel)
Undervoltage Lockout 2.5V (typ)
Thermal Shutdown Yes (per switch)
Switching Slew Rate Controlled (reduces EMI)
Package 8-SOIC (3.9mm width)
Operating Temperature -40 to +85 C

Features

  • Two independent 500mA switches in one package
  • 300mOhm RDS(on) per switch
  • Current limiting with thermal shutdown
  • Open-drain fault flag per channel
  • Controlled output slew rate
  • Reverse current blocking
  • Undervoltage lockout

Applications

  • USB dual-port power switching
  • Hot-swap power control
  • Peripheral power management
  • PCMCIA and card-bus switching
Product Introduction: MIC2026-1YM-TR Product Introduction

The MIC2026-1YM-TR from Microchip is a dual-channel integrated high-side power switch optimized for USB and general-purpose power distribution applications. Each of the two independent switches can handle up to 500mA with an on-resistance of 300mOhm (typical at 5V), providing low voltage drop at full load (150mV at 500mA). The device integrates all necessary protection features: current limiting prevents damage from short circuits and overload conditions, thermal shutdown protects against excessive power dissipation, and undervoltage lockout ensures the switches remain off until the supply voltage is adequate. The open-drain fault flag (FLG) for each channel is asserted low during overcurrent, thermal shutdown, or undervoltage conditions, allowing the host MCU to detect and respond to faults. The controlled output slew rate limits inrush current when driving capacitive loads, reducing system-level EMI and preventing supply voltage droop. Reverse current blocking prevents current from flowing from the output back to the input when the switch is off. The -1 suffix indicates the switch enable polarity (active high) and the current limit value. The dual-channel architecture is ideal for two-port USB hub applications where each USB port needs independent power switching and fault detection, all in a single 8-pin SOIC package. The MIC2026 is also suitable for PCMCIA card switching, hot-plug applications, and any system requiring logic-controlled power switching with fault reporting.

Working Principle: MIC2026-1YM-TR Working Principle

The MIC2026-1YM-TR operates as a dual high-side N-channel MOSFET power switch with integrated protection. Key subsystems include: (1) N-Channel MOSFET Switch – each channel uses an N-channel MOSFET with an internal charge pump generating a gate voltage above VIN to fully enhance the switch; the 300mOhm RDS(on) at 5V provides low voltage drop; (2) Current Limiting – each switch has a current-sense circuit that monitors the MOSFET current; when the current exceeds approximately 500mA, the gate drive is reduced to limit the current; the fault flag (FLG) is asserted low to indicate the overcurrent condition; in current limit, the power dissipation (VIN x I_LIMIT, since VOUT is near 0V during a short) can cause thermal shutdown; (3) Thermal Shutdown – each switch has an independent thermal sensor; if the junction temperature exceeds approximately 135C, the switch is turned off and the FLG is asserted; the switch auto-recovers when the temperature drops below the hysteresis threshold; (4) Controlled Slew Rate – the output voltage transition is slew-rate limited during turn-on and turn-off; this limits the dV/dt at the output, reducing inrush current into capacitive loads (I = C x dV/dt) and minimizing EMI from fast edges; (5) Undervoltage Lockout – when VIN drops below approximately 2.5V, both switches are forced off regardless of the EN inputs, preventing operation with insufficient supply voltage; (6) Reverse Current Blocking – when the switch is off, an internal circuit prevents current from flowing from OUT to IN, which would occur through the MOSFET body diode.

Pin Description: MIC2026-1YM-TR Pin Definition and Functions
Pin Name Function
1 OUT1 Switch 1 output
2 GND Ground
3 EN1 Switch 1 enable (active high)
4 FLG1 Switch 1 fault flag (open-drain, active low)
5 FLG2 Switch 2 fault flag (open-drain, active low)
6 EN2 Switch 2 enable (active high)
7 IN Input supply (2.7V to 5.5V, common for both)
8 OUT2 Switch 2 output
Application Scenarios: In which products and applications is MIC2026-1YM-TR used
  • USB 2-port hub: each switch powers one USB port at 500mA with independent enable and fault detection
  • Dual peripheral power: enable/disable two 3.3V peripherals independently with current limiting and fault flags
  • Hot-swap: two pluggable modules each with controlled inrush current via slew-rate limited turn-on
  • Battery sharing: switch between two battery sources or isolate battery sections with reverse current blocking
Alternative Models: What chips are recommended as replacements for MIC2026-1YM-TR
Manufacturer Part Number Package Notes
Microchip MIC2025-1YM-TR SOIC-8 Single-channel version (1A)
TI TPS2064DGNR HVSSOP-8 Dual 500mA, similar function
Microchip MIC2026-2YM-TR SOIC-8 Active-low enable version
onsemi NCP380HMUAJAATXG UDFN-10 Dual 500mA with adj current limit

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1