Opens in a new tab

TCS34725FN

RGB color sensor with IR filter, I2C, FN-6

10463

Effective Inventory

Image for reference only

Manufacturer Part:

TCS34725FN

Package:

FN-6 (3.2 x 2.7 x 1.0 mm)

Brand:

Product Categories:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

TCS34725FN Overview

The TCS34725FN is a color light-to-digital converter from AMS (ams-OSRAM) with integrated IR blocking filter, providing RGB+Clear four-channel 16-bit resolution output via I2C interface, in an FN-6 package, suitable for color recognition and color temperature measurement.

Key Features

  • Four channels: RGB + Clear
  • I2C interface (up to 400kHz)
  • 16-bit resolution
  • Built-in IR blocking filter
  • Supply voltage: 2.7V-3.3V
  • Programmable interrupt
Product Introduction: TCS34725FN Product Introduction

The TCS34725FN is a digital RGBC color sensor from ams-OSRAM in a 6-lead FN (2.0 x 2.4 x 0.65 mm) package, featuring an integrated IR-blocking filter for accurate color measurement. It provides 16-bit per channel digital output for red, green, blue, and clear channels using four simultaneous integrating ADCs. With programmable analog gain (1x, 4x, 16x, 60x), programmable integration time from 2.4 ms to 614 ms, and a 3,800,000:1 dynamic range, it operates under diverse lighting conditions. The I2C interface runs at up to 400 kHz, and a programmable interrupt with threshold and persistence filter enables event-driven color monitoring. Supply current is 235 uA active and 2.5 uA in sleep mode at 3.0 V.

Working Principle: TCS34725FN Working Principle

The TCS34725FN integrates a 3 x 4 photodiode array on a single CMOS die, where each photodiode is coated with a specific color filter (red, green, blue, or clear/no filter) and an IR-blocking filter layer that minimizes the infrared spectral component of incoming light. Four independent 16-bit integrating ADCs simultaneously convert the photocurrent from each photodiode channel into digital values. The integration time is programmable in 2.4 ms steps from 2.4 ms to 614 ms, effectively controlling the ADC resolution and sensitivity. Longer integration times provide higher effective resolution for low-light conditions. The programmable analog gain (AGAIN) amplifies the photodiode signals before conversion, with 60x gain enabling detection of extremely low light levels. The I2C interface allows the host MCU to read the 16-bit R, G, B, and Clear channel data registers. A double-buffered data register prevents invalid reads during conversion. The interrupt output can be configured to assert when the Clear channel crosses programmable upper or lower thresholds for a programmable number of consecutive integration cycles (persistence filter), reducing host polling overhead.

Pin Description: TCS34725FN Pin Definition and Functions
Pin Name Description
1 VDD Power supply (2.7 V to 3.6 V)
2 SCL I2C clock input; requires external pull-up resistor
3 GND Ground reference
4 NC No connect; leave floating
5 INT Interrupt output; active-low, open-drain, programmable threshold with persistence
6 SDA I2C serial data; open-drain, requires external pull-up resistor

TCS34725FN uses the FN-6 (Dual Flat No-Lead, 2.0×2.4×0.65mm) package from ams-OSRAM with Pin 1 = VDD, Pin 2 = SCL, Pin 3 = GND, Pin 4 = NC, Pin 5 = INT (interrupt, open-drain), Pin 6 = SDA. Pin 1 is identified by a dot or chamfer on the package corner. The exposed thermal pad on the package bottom is electrically connected to GND and must be soldered to the PCB ground plane. The I2C address is fixed at 0x29 (7-bit) and cannot be changed — only one TCS34725 can exist on a bus without an I2C multiplexer. SCL and SDA require external pull-up resistors (4.7kΩ typical). The INT pin is open-drain and also requires a pull-up resistor. The NC pin should be left floating.

Application Scenarios: In which products and applications is TCS34725FN used
  • Display Backlight Control: Measuring ambient color temperature for automatic display white-point and brightness adjustment
  • RGB LED Calibration: Closed-loop color feedback for consistent LED lighting output in horticulture and stage lighting
  • Product Color Verification: Industrial sorting and quality control of colored products on assembly lines
  • Medical Diagnostics: Colorimetric analysis in point-of-care test strips and fluid analysis instruments
  • Wearable Devices: Ultra-compact color sensing in smartwatches and fitness bands for ambient light adaptation
Alternative Models: What chips are recommended as replacements for TCS34725FN
Model Manufacturer Channels IR Filter Resolution Package
TCS34727 ams-OSRAM RGBC Yes 16-bit FN-6
APDS-9960 Broadcom RGBC+Gesture Yes 16-bit OLGA-8
VEML6040 Vishay RGB No 16-bit CLCC-4
BH1745NUC Rohm RGB Yes 16-bit WLCSP-8
S-5420S0A Seiko RGB No 16-bit PLP-6

TCS34725FN is an RGBC color sensor from ams-OSRAM in DFN-6 (2.0×2.4mm) with IR-blocking filter and I2C interface. The TCS34727 is an automotive-grade variant. TCS3471 provides similar functionality without the RGBC separation. For cost-sensitive designs, TCS3200 offers frequency-output color detection in DIP-8. APDS-9960 from Broadcom provides RGB+gesture detection in a similar small package. VEML6040 from Vishay offers RGBW color sensing with I2C.

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1