Opens in a new tab

TL082CDT

Dual JFET Op-Amp, 4MHz GBW, 16V/us, SOIC-8

34567

Effective Inventory

Image for reference only

Manufacturer Part:

TL082CDT

Package:

SOIC-8 (4.9 x 3.9 x 1.5 mm, 1.27mm pitch)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TL082CDT from STMicroelectronics is a dual JFET-input operational amplifier with 4MHz GBW, 16V/us slew rate, 6-36V supply, and SOIC-8 package.

Key Specifications

Type Dual JFET-Input Operational Amplifier
Channels 2
Supply Voltage Range 6V to 36V (+/-3V to +/-18V)
Gain Bandwidth Product 4 MHz (typical) @ +/-15V
Slew Rate 16 V/us (typical) @ +/-15V
Input Offset Voltage 3 mV (typical), 10 mV (max)
Input Bias Current 20 pA (typical) @ +/-15V, 25C
Supply Current 1.4 mA (typical) per channel @ +/-15V
CMRR 70 dB (min)
Input Impedance 10^12 Ohm (typical, JFET input)
THD 0.01% (typical) @ +/-15V
Output Short-Circuit Protection Yes
Package SOIC-8 (D suffix)
Operating Temperature 0C to +70C (C grade)

Features

  • Dual JFET-input op-amp with high input impedance
  • 4MHz gain bandwidth product
  • 16V/us slew rate
  • Ultra-low input bias current: 20pA typical
  • Wide common-mode and differential voltage range
  • Internal frequency compensation
  • Output short-circuit protection
  • Latch-up free operation

Applications

  • High-impedance sensor amplifiers
  • Active filters
  • Sample-and-hold circuits
  • Audio signal processing
Product Introduction: TL082CDT Product Introduction

The TL082CDT from STMicroelectronics is a dual JFET-input general-purpose operational amplifier in an SOIC-8 surface-mount package. The device incorporates well-matched high-voltage JFET and bipolar transistors in a monolithic integrated circuit, combining the ultra-low input bias current of JFET technology (20pA typical) with the output drive capability of bipolar circuitry. The 4MHz gain bandwidth product and 16V/us slew rate support a wide range of analog signal processing applications from DC to moderate frequencies. The 10^12 Ohm input impedance and 20pA input bias current make the TL082 ideal for high-impedance sensor interfaces where input loading must be minimized. The wide supply voltage range of 6V to 36V (single or dual supply) provides flexibility for various power supply configurations. The internal frequency compensation eliminates the need for external compensation components. The output short-circuit protection and latch-up free operation ensure robustness in fault conditions. The C suffix indicates the commercial temperature range (0C to 70C), D denotes SOIC-8 package, and T indicates tape and reel packaging.

Working Principle: TL082CDT Working Principle

The TL082CDT uses a JFET-input differential pair followed by a bipolar gain stage and output stage. The input stage consists of two matched P-channel JFETs that provide the extremely low input bias current (20pA typical) because the gate junction is reverse-biased, drawing only leakage current. The JFET differential pair converts the differential input voltage into a differential current that drives the bipolar second stage. The bipolar gain stage provides the voltage gain (typically 100dB open-loop) through an active load configuration. The output stage is a Class AB push-pull bipolar emitter follower with short-circuit current limiting, capable of sourcing and sinking approximately 20mA into a load. The internal 30pF compensation capacitor rolls off the open-loop gain at -20dB/decade starting at approximately 10Hz, crossing unity gain at 4MHz (the gain bandwidth product). The 16V/us slew rate is determined by the maximum current available to charge the compensation capacitor (SR = I/Ccomp). The JFET input structure provides the wide common-mode voltage range up to the positive supply rail, since the JFETs can withstand the full supply voltage on their gates.

Pin Description: TL082CDT Pin Definition and Functions
Pin Name Type Function
1 1OUT Output Amplifier 1 output
2 1IN- Input Amplifier 1 inverting input
3 1IN+ Input Amplifier 1 non-inverting input
4 VCC- Power Negative supply / ground
5 2IN+ Input Amplifier 2 non-inverting input
6 2IN- Input Amplifier 2 inverting input
7 2OUT Output Amplifier 2 output
8 VCC+ Power Positive supply
Application Scenarios: In which products and applications is TL082CDT used
  • Piezo sensor charge amplifier with 10^12 Ohm input impedance and 20pA bias current preventing sensor discharge
  • Active bandpass filter with 4MHz GBW and 16V/us slew rate for audio signal processing at +/-15V
  • High-impedance buffer for pH electrode with JFET input preventing loading of the high-source-impedance sensor
Alternative Models: What chips are recommended as replacements for TL082CDT
Manufacturer Part Number Package Notes
ST TL082ACDT SOIC-8 Extended temp (-40 to 105C)
TI TL082CPWR TSSOP-8 TI version, smaller package
onsemi TL082CDR2G SOIC-8 Direct equivalent
TI TL072CDR SOIC-8 Lower noise JFET dual op-amp
TI OPA2134PA DIP-8 Bipolar-input, audio-grade upgrade

Recommend Parts

IRFS4310ZTRLPBF

IRFS4310ZTRLPBF – 100V N-Channel HEXFET Power MOSFET, 7 mΩ RDS(on), D2PAK (TO-263AB)

Brand: infineon

Package: D2PAK (TO-263AB)

IN STOCK: 11137pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MSASJ105BB5475MFNA01

4.7uF 6.3V X5R MLCC, 0402, Taiyo Yuden

Brand: gigadevice

Package: 0402 (1005 Metric, 1.0 x 0.5 x 0.5 mm)

IN STOCK: 9701pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRF3415PBF

150V N-channel power MOSFET, 43A, 41mΩ RDS(on), TO-220AB package

Brand: infineon

Package: TO-220AB

IN STOCK: 2940pcs

Cargo cycle: 3-7 Days

The minimum order is 1

105017-1001

USB Type-C receptacle connector, 24-pin, SMD

Brand: Amphenol

Package: SMD (8.9 x 7.3 x 3.2 mm, right angle)

IN STOCK: 5335pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRLB3034PBF

IRLB3034PBF – 40V N-Channel StrongIRFET Power MOSFET (Logic Level), 1.7 mΩ (max) @ 10V; 2.0 mΩ @ 4.5V RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 9724pcs

Cargo cycle: 3-7 Days

The minimum order is 1

XC6SLX75-2FGG484I

Spartan-6 LX75 FPGA, 74637 logic cells, 132 DSP, 3096KB BRAM, 408 I/O, FBGA-484 23x23mm, -2 speed, industrial -40~100C, AMD Xilinx

Brand: xilinx

Package: FGG484 (484-ball fine-pitch BGA, 23x23mm body, 1.0mm ball pitch, 22×22 ball array, 6 I/O banks, lead-free)

IN STOCK: 890pcs

Cargo cycle: 3-7 Days

The minimum order is 1