Opens in a new tab

TPL0401B-10QDCKRQ1

128-tap 10k digital pot, I2C, EEPROM, AEC-Q100, SC-70-6

3685

Effective Inventory

Image for reference only

Manufacturer Part:

TPL0401B-10QDCKRQ1

Package:

SC-70-6 (2.0 x 1.25 x 0.95 mm, DCK package)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The TPL0401B-10QDCKRQ1 from Texas Instruments is an automotive-qualified 128-tap single-channel I2C digital potentiometer with 10kOhm end-to-end resistance in a SC-70-6 package.

Key Specifications

Channels 1
Number of Taps 128 (7-bit resolution)
End-to-End Resistance 10 kOhm
Resolution 7 bits
Interface I2C
Memory Type Non-volatile (EEPROM)
Supply Voltage 2.7V to 5.5V
I2C Address 0x50 (A0 pin to GND)
Wiper Current +/-2.5 mA
Temperature Coefficient 35 ppm/C (rheostat mode)
AEC-Q100 Grade 1
Package SC-70-6 (DCK)
Operating Temperature -40 to +125 C

Features

  • AEC-Q100 Grade 1 qualified for automotive
  • Non-volatile EEPROM stores wiper position at power-down
  • I2C interface for digital control
  • 128-tap resolution (7-bit) for fine adjustment
  • 10kOhm end-to-end resistance

Applications

  • Automotive LCD contrast adjustment
  • Power supply voltage margining
  • Sensor calibration offset trim
  • LED brightness control
Product Introduction: TPL0401B-10QDCKRQ1 Product Introduction

The TPL0401B-10QDCKRQ1 from Texas Instruments is an automotive-qualified single-channel 128-tap digital potentiometer with 10kOhm end-to-end resistance and I2C interface. The device uses non-volatile EEPROM to store the wiper position, ensuring the last programmed setting is automatically restored at power-up without requiring re-initialization by the host controller. With 128 taps (7-bit resolution), the device provides fine-grained resistance adjustment suitable for calibration and trimming applications. The I2C interface at address 0x50 (with A0 pin selecting between two possible addresses) allows the wiper position to be read and written by any I2C master. The device operates from 2.7V to 5.5V supply and can handle wiper currents of +/-2.5mA. In potentiometer mode, the device functions as a three-terminal voltage divider with H, L, and W terminals; in rheostat mode (using only W and one terminal), the resistance is programmable from approximately 78 ohms (one tap) to 10kOhms (full scale). The temperature coefficient of 35ppm/C in rheostat mode ensures stable resistance over the automotive temperature range. AEC-Q100 Grade 1 qualification supports operation from -40 to +125C. The compact SC-70-6 package (2.0 x 1.25mm) minimizes board space, enabling digital trim in space-constrained automotive modules.

Working Principle: TPL0401B-10QDCKRQ1 Working Principle

The TPL0401B-10QDCKRQ1 operates as a digitally controlled potentiometer with EEPROM memory. Key subsystems include: (1) Resistor Array – a polysilicon resistor string of 127 equal resistors (approximately 78 ohms each for 10kOhm total) connected between H and L terminals; each node between resistors is selectable by the wiper multiplexer; (2) Wiper Multiplexer – a CMOS switch matrix that connects the W (wiper) terminal to any of the 128 tap points along the resistor string; the selected tap position is determined by the 7-bit register value stored in the volatile wiper register; (3) I2C Interface – a standard-mode I2C slave interface accepts write commands (to change wiper position) and read commands (to read current wiper position) at the device address 0x50 or 0x54 (selected by A0 pin); the interface also provides access to the EEPROM control register for saving the wiper position; (4) Non-Volatile EEPROM – the wiper position can be stored in the EEPROM by writing a specific command sequence; at power-up, the EEPROM contents are automatically loaded into the volatile wiper register, restoring the last saved position; the EEPROM supports a minimum of 50,000 write cycles; (5) Power-On Reset – on initial power-up, the device loads the EEPROM-stored wiper position into the active register; this ensures a known, valid wiper position without requiring I2C communication from the host.

Pin Description: TPL0401B-10QDCKRQ1 Pin Definition and Functions
Pin Name Function
1 A0 I2C address select (connect to GND or VDD)
2 GND Ground
3 H High terminal of resistor (potentiometer mode)
4 L Low terminal of resistor (potentiometer mode)
5 W Wiper terminal (programmable tap point)
6 VDD Power supply (2.7V to 5.5V)
Application Scenarios: In which products and applications is TPL0401B-10QDCKRQ1 used
  • LCD contrast trim: adjust VCOM voltage for optimal display contrast, EEPROM retains setting across power cycles
  • Power supply margining: digitally adjust feedback divider for output voltage calibration in production test
  • Sensor offset calibration: trim bridge offset voltage to zero during manufacturing calibration
  • LED current set: adjust LED driver current set resistor digitally for brightness matching in automotive lighting
Alternative Models: What chips are recommended as replacements for TPL0401B-10QDCKRQ1
Manufacturer Part Number Package Notes
TI TPL0401B-10DCKR SC-70-6 Non-automotive version
Microchip MCP4017T-103E/LT SC-70-6 128-tap, I2C, 10kOhm
ADI AD5171BCP10RMZ MSOP-8 64-tap, I2C, 10kOhm, OTP
TI TPL0401A-10DCKR SC-70-6 100kOhm version

Recommend Parts

TMP275AIDR

0.5C I2C temp sensor, 12-bit, 2.7-5.5V, alert output, 8-SOIC

Brand: TI

Package: 8-SOIC (4.90 x 3.91 x 1.50 mm)

IN STOCK: 3681pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IL485E

NVE IL485E IsoLoop isolated RS-485 transceiver, 2.5kVrms isolation, 35Mbps, 16-SOIC WB

Brand: nve

Package: SOIC-16 WB

IN STOCK: 5280pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFS4227TRLPBF

IRFS4227TRLPBF – 200V N-Channel HEXFET PDP Switch Power MOSFET, 26 mΩ RDS(on), D2PAK (TO-263)

Brand: infineon

Package: D2PAK (TO-263)

IN STOCK: 4334pcs

Cargo cycle: 3-7 Days

The minimum order is 1

CD4070BM96

Quad 2-input XOR gate, 3-18V CMOS, 65ns at 10V, SOIC-14

Brand: TI

Package: SOIC-14 (8.75 x 3.9 x 1.5mm)

IN STOCK: 4245pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AB1526

Bluetooth 5.0 Dual Mode Audio SoC, TWS, AAC, Dual-mic ENC, Integrated Charger, BGA

Brand: airoha

Package: BGA

IN STOCK: 25000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LP2980IM5-5.0

50mA micropower ultra-low-dropout regulator, 5V, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.1 mm)

IN STOCK: 2557pcs

Cargo cycle: 3-7 Days

The minimum order is 1