Opens in a new tab

TPS1101DR

12V N-ch MOSFET switch, 78mOhm, 1.8A, current limit, fault flag, SOIC-8

4916

Effective Inventory

Image for reference only

Manufacturer Part:

TPS1101DR

Package:

SOIC-8 (4.9 x 3.9 x 1.75 mm, D package)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TPS1101DR from Texas Instruments is a 12V N-channel power MOSFET switch with 78mOhm RDS(on), 1.8A current limit, and integrated charge pump for low-voltage logic control in an SOIC-8 package.

Key Specifications

Function N-Channel Power Distribution Switch
Input Voltage (VIN) 2.7V to 12V
RDS(on) 78 mOhm (max @ 5V EN)
Continuous Current 1.8 A (max)
Current Limit 1.9A to 3.5A (typ 2.6A)
Enable Input Active high, CMOS compatible (1.8V logic)
Fault Report (OC) Open-drain output, active low
Rise Time 3.6 ms (typ, soft-start)
Standby Current 0.05 uA (typ, switch off)
Package SOIC-8 (3.9mm width)
Operating Temperature -40 to +85 C

Features

  • Integrated charge pump for low-voltage enable
  • 78mOhm low RDS(on) power switch
  • 1.9-3.5A current limit with thermal shutdown
  • Soft-start to limit inrush current (3.6ms)
  • Open-drain fault flag for overcurrent
  • 0.05uA ultra-low standby current
  • Reverse current blocking

Applications

  • USB power distribution
  • Hot-swap power control
  • Battery-powered load switching
  • Short-circuit protected power paths
Product Introduction: TPS1101DR Product Introduction

The TPS1101DR from Texas Instruments is a 12V N-channel power distribution switch with integrated charge pump, current limiting, and fault reporting in an SOIC-8 package. The device integrates a low-RDS(on) N-channel MOSFET (78mOhm max) with all the necessary control and protection circuitry for high-side power switching applications. The internal charge pump generates the gate drive voltage above VIN, allowing the N-channel MOSFET to be fully enhanced with only 1.8V logic-level enable input, eliminating the need for an external gate drive circuit. The current limit feature (1.9A to 3.5A, typically 2.6A) protects the system from overcurrent and short-circuit conditions by limiting the output current and activating the open-drain fault flag (OC pin). The thermal shutdown circuit disables the switch when the junction temperature exceeds approximately 140C, protecting against sustained overloads. The soft-start feature controls the output voltage rise time to approximately 3.6ms, limiting inrush current into capacitive loads (such as USB bus-powered devices with bypass capacitors). The 0.05uA standby current (switch off) minimizes battery drain in always-connected applications. Reverse current blocking prevents current from flowing from the output back to the input when the switch is off. The TPS1101DR is suitable for USB power distribution, hot-swap power control, battery-powered load switching, and any application requiring a protected, logic-controlled power switch.

Working Principle: TPS1101DR Working Principle

The TPS1101DR operates as a high-side N-channel power MOSFET switch with integrated control and protection. Key subsystems include: (1) N-Channel MOSFET – the main power switch is an N-channel MOSFET between VIN and VOUT; the 78mOhm RDS(on) minimizes voltage drop at full load (Vdrop = I x RDS(on) = 1.8A x 78mOhm = 140mV); (2) Charge Pump – an internal charge pump generates a gate voltage approximately 5V above VIN; this high gate voltage fully enhances the N-channel MOSFET (which requires VGS > VIN for high-side operation); the charge pump allows the enable input to be driven by 1.8V logic while the switch handles up to 12V; (3) Current Limit – a current-sense circuit monitors the MOSFET current; when the current exceeds the limit (1.9-3.5A), the gate drive is reduced to limit the current; the OC (overcurrent) open-drain flag is pulled low to indicate a fault; the current limit and thermal shutdown work together: if the limited current causes excessive power dissipation (V x I = (VIN-VOUT) x I_LIMIT), the junction temperature rises and thermal shutdown activates; (4) Soft-Start – when the enable pin goes high, the output voltage ramps up over approximately 3.6ms; this limits the inrush current into capacitive loads (I = C x dV/dt); without soft-start, the initial current would be limited only by the current limit, potentially stressing the device and the input supply; (5) Reverse Blocking – when the switch is off, the body diode of the N-channel MOSFET would normally conduct if VOUT > VIN; an internal reverse-blocking circuit prevents this current flow.

Pin Description: TPS1101DR Pin Definition and Functions
Pin Name Function
1 VIN Input supply (2.7V to 12V)
2 VIN Input supply (connected internally)
3 EN Enable (active high, 1.8V logic compatible)
4 GND Ground
5 OC Overcurrent fault flag (open-drain, active low)
6 NC No connect
7 VOUT Switched output
8 VOUT Switched output (connected internally)
Application Scenarios: In which products and applications is TPS1101DR used
  • USB power switch: 5V to USB port at 500mA with current limit and OC fault flag to MCU
  • Hot-swap: 12V bus power switch with soft-start limiting inrush into 100uF load capacitor
  • Battery load switch: 3.7V Li-Ion to subsystem at 1A with 0.05uA standby when off
  • Protected power path: 5V rail with current limit and thermal shutdown for pluggable module
Alternative Models: What chips are recommended as replacements for TPS1101DR
Manufacturer Part Number Package Notes
TI TPS1101DVR VSSOP-8 Smaller VSSOP package
TI TPS2034DR SOIC-8 Similar, different current limit range
onsemi NCP380LSNAJAAT1G DFN-8 5.5V/2A load switch with adj current limit
TI TPS22918DBVR SOT-23-6 5.5V/2A load switch, smaller package

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1