Opens in a new tab

TPS543620RPYR

4-18V/6A sync buck SWIFT, internal comp, 5 freq options, HotRod VQFN-14, 0.5V ref

2893

Effective Inventory

Image for reference only

Manufacturer Part:

TPS543620RPYR

Package:

VQFN-HR-14 (2.5 x 3.0 x 0.9 mm, RPY package)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TPS543620RPYR from Texas Instruments is a 4V to 18V input, 6A synchronous SWIFT step-down converter with internally compensated advanced current mode control in a 14-pin HotRod VQFN package.

Key Specifications

Topology Synchronous Buck (SWIFT)
Input Voltage 4V to 18V
Output Voltage 0.5V to 5.5V (adjustable)
Output Current 6A
Switching Frequency 500kHz / 750kHz / 1MHz / 1.5MHz / 2.2MHz (pin-selectable)
Reference Voltage 0.5V +/-1%
Control Mode Advanced Current Mode (internally compensated)
Synchronous Rectifier Yes (integrated)
Package 14-Pin VQFN-HR (2.5 x 3.0mm, HotRod)
Operating Temperature -40 to +150 C (TJ)

Features

  • 6A output current in compact 2.5x3mm HotRod QFN
  • Internally compensated – no external compensation network
  • 5 frequency options via pin selection (no external resistor)
  • Spread spectrum option for EMI reduction
  • DCS-Control with forced PWM and auto PFM modes
  • Power-good output
  • 2V/line precision reference (0.5V +/-1%)

Applications

  • Point-of-load regulation for FPGAs/processors
  • Industrial 12V/24V to low-voltage conversion
  • Telecom and networking equipment
  • Embedded computing power supplies
Product Introduction: TPS543620RPYR Product Introduction

The TPS543620RPYR from Texas Instruments is a 6A synchronous step-down DC/DC converter from the SWIFT (Switcher With Integrated FET Technology) family, featuring a wide 4V to 18V input range and an adjustable output from 0.5V to 5.5V. The device uses Advanced Current Mode (ACM) control with internal compensation, eliminating the need for external compensation components and simplifying design. The switching frequency can be selected from five options (500kHz, 750kHz, 1MHz, 1.5MHz, or 2.2MHz) via the FSEL pin configuration, allowing designers to optimize efficiency versus solution size without adding external frequency-setting resistors. The HotRod QFN package technology mounts the die with copper pillars directly to the leadframe, eliminating bond wire resistance and inductance for improved efficiency and lower EMI. The integrated high-side and low-side MOSFETs deliver up to 6A continuous output current in a compact 2.5×3.0mm footprint. The device supports both forced PWM mode (for tight output regulation and constant frequency) and auto PFM/PWM mode (for high efficiency at light loads). A spread spectrum option modulates the switching frequency to reduce peak EMI emissions. Protection features include cycle-by-cycle current limit, output overvoltage protection, undervoltage lockout, and thermal shutdown. A power-good (PG) output indicates when the output is within regulation. The 0.5V +/-1% reference voltage enables very low output voltages for modern processors.

Working Principle: TPS543620RPYR Working Principle

The TPS543620RPYR operates as a synchronous buck converter using Advanced Current Mode (ACM) control. Key subsystems include: (1) Advanced Current Mode Control – a proprietary current-mode control scheme with internal Type-III compensation that maintains stability across a wide range of input voltages, output voltages, and inductor values without external compensation components; the emulated current ramp provides robust noise immunity; (2) Integrated Power MOSFETs – the HotRod QFN package directly connects the die to the leadframe through copper pillars, reducing parasitic inductance and resistance; the high-side MOSFET (VIN to SW) and low-side MOSFET (SW to GND) are both integrated; (3) Frequency Selection – the FSEL pin configures the switching frequency among five options; higher frequencies enable smaller inductors but reduce efficiency due to increased switching losses; (4) DCS-Control Topology – the device can operate in forced PWM mode (constant frequency regardless of load) or auto PFM/PWM mode (switches to PFM at light loads for higher efficiency); in PFM mode, the switching frequency decreases with load to minimize switching losses; (5) Protection – cycle-by-cycle current limit (negative and positive); OVP turns on the low-side MOSFET to discharge the output if VOUT exceeds setpoint; thermal shutdown at approximately 165C; UVLO prevents operation below 3.65V input.

Pin Description: TPS543620RPYR Pin Definition and Functions
Pin Name Function
1 VIN Input supply (4V to 18V)
2 SW Switch node (connect to inductor)
3 GND Power ground (thermal pad)
4 BOOT Bootstrap capacitor for high-side gate drive
5 FB Output voltage feedback (resistor divider)
6 EN Enable / UVLO adjust
7 SS Soft-start / spread spectrum select
8 MODE Mode select (FPWM vs auto PFM/PWM)
9 FSEL Frequency select (5 options via resistor to GND)
10 PG Power-good output (open-drain)
11-14 VIN/GND Additional power/ground connections
Application Scenarios: In which products and applications is TPS543620RPYR used
  • FPGA core power: 12V to 0.9V/1.0V at 6A for high-end FPGA core rail
  • Industrial 24V to 5V/3.3V: point-of-load conversion from 12V or 24V bus
  • Embedded computing: 12V input to 1.8V DDR3 memory supply at 6A
  • Telecom board: 5V/12V intermediate bus to low-voltage processor rails
Alternative Models: What chips are recommended as replacements for TPS543620RPYR
Manufacturer Part Number Package Notes
TI TPS543320RPYR VQFN-12 3A version, similar family
TI TPS54520RPYR VQFN-14 5A version, 4.5-17V input
Monolithic Power MPQ4430GQBE-AEC1-Z QFN-16 3.5-36V/3A, automotive
TI TPS62933DRLR VQFN-6 3.8-30V/3A, smaller footprint

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1