Opens in a new tab

TPS549D22RVFT

40A 22V buck, PMBus, stackable, HotRod QFN

1800

Effective Inventory

Image for reference only

Manufacturer Part:

TPS549D22RVFT

Package:

HotRod QFN (7.0 x 5.0 x 1.0 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TPS549D22RVFT is a Texas Instruments 40A 22V synchronous buck converter with integrated MOSFETs, PMBus interface, and stackable current sharing. 500kHz default switching. Packaged in HotRod QFN, -40C to +125C.

Key Specifications

Input Voltage 4.5 V to 22 V
Output Current 40 A
Frequency 200kHz to 1MHz
Interface PMBus / I2C
Accuracy +/-0.5% Vref
Package HotRod QFN

Features

  • 40A output, 22V input
  • Integrated power MOSFETs
  • PMBus digital interface
  • Stackable current sharing
  • +/-0.5% reference accuracy
  • Multi-phase configurable
  • Comprehensive fault protection

Applications

  • Server and data center POL
  • FPGA and ASIC core supply
  • AI accelerator power
  • Telecom 12V bus
Product Introduction: TPS549D22RVFT Product Introduction

The TPS549D22RVFT is a Texas Instruments 40A 22V synchronous step-down converter with integrated power MOSFETs in a HotRod QFN package. The device targets high-current point-of-load (POL) applications in servers, data centers, and telecom equipment where 12V intermediate bus architecture is common. The 40A output capability with integrated MOSFETs eliminates external driver and FET selection, simplifying design and reducing solution size. The PMBus-compliant digital interface enables runtime monitoring and control of output voltage, switching frequency, current limit, and fault status via I2C. Multiple devices can be stacked for current sharing in multi-phase configurations, supporting 80A, 120A, or higher total current. The +/-0.5% reference accuracy over temperature provides tight voltage regulation for advanced processors and FPGAs. The switching frequency is programmable from 200kHz to 1MHz via PMBus or pinstrap, balancing efficiency and solution size. Comprehensive protection includes overcurrent, overvoltage, undervoltage, and thermal shutdown with PMBus fault reporting. The HotRod QFN package with flip-chip die attach minimizes parasitic inductance for clean switch-node waveforms. Packaged in HotRod QFN rated for -40C to +125C.

Working Principle: TPS549D22RVFT Working Principle

The TPS549D22 uses peak current-mode PWM control with integrated high-side and low-side NMOS power FETs. The current-mode control provides fast transient response and cycle-by-cycle peak current limiting. The integrated current sense uses the low-side MOSFET RDS(on) for lossless current sensing, with PMBus-readable current telemetry. The error amplifier compares the FB voltage (or internal DAC output for PMBus-programmed VOUT) with the 0.6V reference, adjusting the peak current command. The PMBus interface (SCL, SDA, SALERT) provides access to configuration registers, status registers, and real-time telemetry (VOUT, IOUT, temperature). Multiple devices share the COMP pin for parallel current-sharing operation, where the error amplifier output of the master device drives all slave COMP pins. The switching frequency is set by PMBus register or an external resistor on the FREQ pin. Adaptive zero-crossing detection prevents negative inductor current at light loads in diode-emulation mode. The boot-refresh circuit maintains the bootstrap capacitor charge during low-duty-cycle conditions.

Pin Description: TPS549D22RVFT Pin Definition and Functions

HotRod QFN with key signals: VIN (power input), VOUT (power output), SW (switch node), BOOT (bootstrap), EN (enable), FB (feedback or VSET), SCL/SDA/SALERT (PMBus), FREQ (frequency set), COMP (current share), PG (power good), CSEL (config select). Refer to datasheet for complete pin map.

Application Scenarios: In which products and applications is TPS549D22RVFT used
  • Server CPU/FPGA core POL 12V to 1.0V at 40A with PMBus monitoring and +/-0.5% accuracy
  • AI accelerator 12V to 0.8V at 80A using two stacked devices for current sharing
  • Data center 12V bus to 3.3V POL with PMBus fault reporting and remote telemetry
  • Telecom 12V intermediate bus converter with 40A output and HotRod QFN thermal performance
Alternative Models: What chips are recommended as replacements for TPS549D22RVFT
Model Manufacturer Key Difference
TPS549B22 TI 25A, similar PMBus
TPS546D24 TI 40A, 16V input
MAX20730 Maxim Similar 20A PMBus
IR38263 Infineon Similar integrated POL

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1