Opens in a new tab

TPS63020DSJR

Buck-boost converter, 1.8-5.5V in, 1.2-5.5V out, 2A, 4A switch, 2.4MHz, 14-VSON

6842

Effective Inventory

Image for reference only

Manufacturer Part:

TPS63020DSJR

Package:

14-VSON (4 x 3 x 0.9 mm, 0.5mm pitch, exposed pad)

Brand:

Product Categories:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TPS63020DSJR from Texas Instruments is a high-efficiency single-inductor buck-boost converter with 4A integrated switches in a 14-pin VSON (4x3mm) package. It supports input voltages from 1.8V to 5.5V and adjustable output voltages from 1.2V to 5.5V, delivering up to 2A output current. With a fixed 2.4MHz switching frequency, synchronous rectification, power-save mode at light loads, and only 25µA quiescent current, it achieves up to 96% efficiency. Features include power-good output, load disconnect during shutdown, and comprehensive protection.

Key Specifications

Topology Buck-Boost (Single Inductor, Non-Inverting)
Input Voltage Range 1.8V to 5.5V
Output Voltage Range 1.2V to 5.5V (Adjustable)
Max Output Current 2A (VIN > 2.5V, VOUT = 3.3V)
Switch Current Limit 4A (typical)
Switching Frequency 2.4 MHz (fixed)
Quiescent Current 25 µA (typical, operating)
Shutdown Current < 1 µA
Efficiency (typical) Up to 96%
Synchronous Rectification Yes (integrated MOSFETs)
Power Good Output Yes (open-drain)
Load Disconnect Yes (during shutdown)
Operating Temperature -40°C to +85°C
Package 14-VSON (4 x 3 x 0.9 mm)

Features

  • Single-inductor buck-boost topology with 4A integrated switches
  • 1.8V to 5.5V input, 1.2V to 5.5V adjustable output
  • Up to 2A output current (VIN > 2.5V, VOUT = 3.3V)
  • Fixed 2.4MHz switching frequency allows small external components
  • Synchronous rectification for high efficiency across load range
  • Power-save mode at light loads with 25µA quiescent current
  • Power-good output (open-drain) for output voltage monitoring
  • Load disconnect during shutdown minimizes battery drain
  • Dynamic current limit with soft-start and short-circuit protection
  • Overvoltage protection, undervoltage lockout, and overtemperature shutdown

Applications

  • Battery-powered portable devices (single-cell Li-Ion, dual-cell AA/AAA)
  • IoT sensors and wireless modules with fluctuating supply rails
  • Supercapacitor backup power systems
  • Single-board computers and portable data terminals
  • Barcode scanners, IP cameras, and video doorbells
Product Introduction: TPS63020DSJR Product Introduction

The TPS63020DSJR from Texas Instruments is a high-efficiency single-inductor buck-boost converter with integrated 4A switches in a compact 14-VSON (4x3mm) package. It operates from 1.8V to 5.5V input and produces an adjustable 1.2V to 5.5V output at up to 2A. With a fixed 2.4MHz switching frequency, synchronous rectification, and power-save mode delivering only 25µA quiescent current, it achieves up to 96% efficiency. Features include power-good output, load disconnect during shutdown, and comprehensive protection, making it ideal for battery-powered and IoT applications.

Working Principle: TPS63020DSJR Working Principle

The TPS63020DSJR uses a single-inductor non-inverting buck-boost topology with four integrated MOSFET switches controlled by an average current-mode PWM controller. When the input voltage is higher than the output, it operates as a buck converter using the high-side buck switch and low-side synchronous rectifier. When the input is lower than the output, it switches to boost mode using the high-side boost rectifier and low-side boost switch. Near the transition point, it alternates between buck and boost cycles using TI’s Buck-Boost Overlap Control, which minimizes the number of classical buck-boost cycles (where all four switches are active) to maximize efficiency. The average current-mode control loop reconstructs the inductor current by measuring the high-side buck MOSFET current and uses a transconductance voltage error amplifier to regulate the output. Power-save mode activates at light loads, reducing switching frequency and quiescent current to 25µA. The dynamic current limit ramps up from 400mA during soft-start, reaching the nominal 4A limit only when the output voltage exceeds 1.2V, providing inherent short-circuit protection.

Pin Description: TPS63020DSJR Pin Definition and Functions
Pin Name Type Function
1 EN Input Enable (HIGH = on, LOW = shutdown)
2 VINA Power Analog supply voltage input
3 PS/SYNC Input Power Save / Synchronization input
4 FB Input Feedback voltage input (set output via resistor divider)
5 NC — No connect
6,7 GND Power Ground (connect to thermal pad)
8 PG Output Power Good (open-drain output)
9 SW2 Power Switch node 2 (boost side)
10 VIN Power Input supply voltage (1.8V to 5.5V)
11 VOUT Power Output voltage (1.2V to 5.5V)
12 SW1 Power Switch node 1 (buck side)
13 COMP Analog Compensation network connection
14 GND Power Ground
Pad PowerPAD Power Thermal pad (connect to GND plane)
Application Scenarios: In which products and applications is TPS63020DSJR used
  • Battery-powered IoT devices with Li-Ion or dual AA cell supplies
  • Supercapacitor backup power for SSDs, meters, and PLCs
  • Portable data terminals and barcode scanners
  • Single-board computers and IP network cameras
  • Wearable electronics with fluctuating battery voltage
Alternative Models: What chips are recommended as replacements for TPS63020DSJR
Manufacturer Part Number Package Notes
Texas Instruments TPS63021DSJR 14-VSON Fixed 3.3V output version
Texas Instruments TPS630250RNCR 10-VSON Adjustable frequency, 3.5A sustained
Monolithic Power MP28167GQW-Z QFN-16 2A, 2.5MHz, similar topology
Analog Devices LTC3127EDD#PBF DFN-10 1.8A, 1.6MHz buck-boost
Texas Instruments TPS630701RNMR VQFN-12 3.5A switch, wider input range

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1