Opens in a new tab

TPS63802DLAR

2A buck-boost converter, 1.3-5.5V in, 1.8-5.2V out, 11uA Iq, HotRod QFN 3x2mm, true shutdown

35015

Effective Inventory

Image for reference only

Manufacturer Part:

TPS63802DLAR

Package:

HotRod QFN-10 (DLA, 3.0 x 2.0 x 0.9 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TPS63802DLAR is a 2A high-efficiency, low-Iq non-inverting buck-boost converter from Texas Instruments. It operates over a wide input voltage range of 1.3V to 5.5V and provides an adjustable output from 1.8V to 5.2V. The device uses a peak current mode control with a 4-switch H-bridge topology, seamlessly transitioning between buck, buck-boost, and boost modes. Packaged in a HotRod QFN (DLA, 3x2mm), it achieves a tiny 21.5mm2 total solution size.

Key Specifications

Topology 4-switch non-inverting buck-boost
Input Voltage Range 1.3V to 5.5V (startup >1.8V)
Output Voltage Range 1.8V to 5.2V (adjustable via resistor divider)
Max Output Current 2A (VIN >= 2.3V, VOUT = 3.3V)
Quiescent Current 11 uA (typical)
Switching Frequency ~2 MHz
Efficiency Up to 95%
Mode Control Auto PFM/PWM or forced PWM
Inductor 0.47 uH (tiny external component)
Min Output Capacitor 22 uF
Protection OVP, OTP, true shutdown, current limit
Package HotRod QFN (DLA, 3x2mm, 10 pins)
Operating Temperature -40C to +125C (junction)

Features

  • Wide 1.3V-5.5V input with seamless buck/boost transitions
  • 11uA ultra-low quiescent current for long battery life
  • 2A output current with only 0.47uH inductor and 22uF capacitor
  • HotRod QFN package minimizes loop inductance for low EMI
  • True shutdown with load disconnect (zero Iout in shutdown)
  • Power save mode (PFM) for highest light-load efficiency
  • Defined 4-cycle buck-boost mode reduces output ripple

Applications

  • System pre-regulator for smartphones and tablets
  • Battery-powered IoT devices (Li-Ion, LiMnO2 cells)
  • POS terminal and EFT power supply
  • Optical module TEC/TEM supply
  • Fingerprint sensor and camera module power
Product Introduction: TPS63802DLAR Product Introduction

The TPS63802DLAR is a 2A high-efficiency buck-boost converter from Texas Instruments, operating from 1.3V to 5.5V input and providing adjustable output from 1.8V to 5.2V. Its 11uA quiescent current enables excellent light-load efficiency for battery-powered systems. The 4-switch H-bridge topology seamlessly transitions between buck, buck-boost, and boost modes with defined mode thresholds and hysteresis to minimize output ripple. The HotRod QFN package (3x2mm) with only a 0.47uH inductor and 22uF output capacitor achieves a total solution size of just 21.5mm2.

Working Principle: TPS63802DLAR Working Principle

The TPS63802DLAR uses a 4-switch non-inverting buck-boost topology with peak current mode control. Four integrated MOSFET switches (Q1-Q4) form an H-bridge between VIN, the inductor, and VOUT. When VIN > VOUT, the converter operates in buck mode (Q1/Q2 switching, Q4 always on, Q3 off). When VIN < VOUT, it operates in boost mode (Q3/Q4 switching, Q1 always on, Q2 off). When VIN is approximately equal to VOUT, the device enters a defined 4-cycle buck-boost mode: TON (boost-charge: Q2+Q3 on, inductor current ramps up), TOFF (buck-discharge: Q1+Q4 on, inductor current ramps down), and TCOM (Q1+Q4 on, VIN connected to VOUT). Mode transitions occur at defined thresholds with hysteresis to prevent oscillation between modes. The 11uA quiescent current is achieved in power-save mode (PFM), where the converter skips switching cycles at light loads to maintain regulation with minimum switching losses. Forced PWM mode can be selected for applications requiring constant switching frequency and minimum output ripple. True shutdown disconnects the load from the input via the switch topology, reducing output current to zero.

Pin Description: TPS63802DLAR Pin Definition and Functions
Pin Name Type Function
1 VIN Power Input voltage (1.3-5.5V)
2 VOUT Power Output voltage (1.8-5.2V)
3 GND Ground Power ground and thermal pad
4 FB Analog Feedback voltage input (VREF = 500mV)
5 EN Digital Enable input (active high, precise threshold)
6 MODE Digital Mode select: Low=PFM/PWM auto, High=forced PWM
7 PG Digital Power-good open-drain output
8 L1 Power Inductor connection (VIN side)
9 L2 Power Inductor connection (VOUT side)
10 AGND Ground Analog ground
Application Scenarios: In which products and applications is TPS63802DLAR used
Application Circuit Role Key Requirement
Li-Ion Powered IoT 3.3V rail from 2.7-4.2V battery Buck-boost, 2A, 11uA Iq, tiny solution
Smartphone Pre-reg System voltage stabilizer 2A, forced PWM, 3x2mm HotRod
POS Terminal Main 3.3V/5V supply from battery 2A, 1.3V min input, true shutdown
Optical Module TEC/TEM driver supply Bidirectional current, forced PWM
EFT Terminal Battery to system power conversion 1.3-5.5V input, 2A, 21.5mm2 solution
Alternative Models: What chips are recommended as replacements for TPS63802DLAR
Model Manufacturer Key Difference
TPS63805DLAR TI Similar, optimized for smallest solution (19.5mm2)
TPS63806DLAR TI 2.5A, optimized for load transients
TPS63020DSJR TI 2.5A buck-boost, older generation, larger package
LTC3533EGN#PBF Analog Devices 2A buck-boost, 2.4-5.5V in, SSOP-16
MAX77827ENJ+T Analog Devices 2A buck-boost, 2.5-5.5V in, WLP

Recommend Parts

RK73B2ATTD100J

10Ohm +/-5% 0.125W thick film resistor, 0805, +/-200 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0805 (2012 Metric) 2.0 x 1.25 x 0.55 mm

IN STOCK: 26435pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPL5010DDCR

Nano-power watchdog timer with power good, SOT-23-6

Brand: TI

Package: SOT-23-6 (2.9 x 1.6 x 1.1 mm, DDC package)

IN STOCK: 12122pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

WS2811

3-channel LED driver IC with built-in oscillator, SOP-8

Brand: Worldsemi

Package: SOP-8 (5.2 x 4.0 mm)

IN STOCK: 7374pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AD9912ABCPZ

1GSPS direct digital synthesizer with 14-bit DAC, LFCSP-64

Brand: ADI

Package: LFCSP-64 (9.0 x 9.0 mm, BCPZ package)

IN STOCK: 3719pcs

Cargo cycle: 3-7 Days

The minimum order is 1