Opens in a new tab

TPS7A4001DGNR

36V 1A low-noise LDO, 72dB PSRR, 13uVrms noise, adj 1.2-33V, VSSOP-8

3560

Effective Inventory

Image for reference only

Manufacturer Part:

TPS7A4001DGNR

Package:

8-Pin VSSOP PowerPAD (3.0 x 3.0 x 0.9 mm with exposed pad)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The TPS7A4001DGNR is a Texas Instruments 36V, 1A low-noise, high-PSRR low-dropout linear regulator with adjustable output from 1.2V to 33V. It features 72 dB PSRR at 1 kHz, 13 uVrms output noise, 400 mV dropout at 1A, and reverse current protection. Packaged in 8-pin VSSOP PowerPAD rated for -40C to +125C.

Key Specifications

Input Voltage Up to 36 V
Output Current 1 A
Dropout 400 mV at 1 A
PSRR 72 dB at 1 kHz
Noise 13 uVrms
Output Range 1.2 V to 33 V (adj)

Features

  • 36 V maximum input voltage
  • 1 A output current
  • 72 dB PSRR at 1 kHz
  • 13 uVrms output noise
  • Adjustable output 1.2V to 33V
  • 400 mV dropout at 1A
  • Reverse current protection
  • Thermal shutdown and overcurrent

Applications

  • RF and PLL power supply
  • High-precision ADC/DAC supply
  • Post-regulation after DC-DC
  • Test and measurement clean rails
Product Introduction: TPS7A4001DGNR Product Introduction

The TPS7A4001DGNR is a Texas Instruments low-noise, high-PSRR LDO linear regulator capable of sourcing 1 A from up to 36 V input. The adjustable output ranges from 1.2 V to 33 V, set by external resistor divider from the FB pin. With 72 dB PSRR at 1 kHz and 13 uVrms output noise (10 Hz-100 kHz), it provides ultra-clean power for noise-sensitive RF, PLL, and precision converter applications. The 400 mV maximum dropout at 1 A enables efficient regulation from 5V or 3.3V pre-regulators. Reverse current protection blocks parasitic current flow from output to input during power-down. Thermal shutdown and current limiting protect against fault conditions. Packaged in 8-pin VSSOP PowerPAD rated for -40C to +125C.

Working Principle: TPS7A4001DGNR Working Principle

The TPS7A4001 uses a PMOS pass transistor for low dropout and reverse current blocking. The error amplifier compares a fraction of the output voltage (from the external FB divider) with an internal 1.2 V reference, driving the PMOS gate to maintain regulation. The low output noise is achieved through a filtered internal bandgap reference. The high PSRR results from the high open-loop gain of the error amplifier at low frequencies and the output capacitor impedance at high frequencies. The FB pin allows Kelvin sensing for remote load regulation. Reverse current protection detects when VOUT exceeds VIN and disables the pass transistor, preventing current flow back to the input supply.

Pin Description: TPS7A4001DGNR Pin Definition and Functions
Pin Mnemonic Description
1 EN Enable (active high)
2 IN Input supply (up to 36V)
3 NC No connect
4 OUT Regulated output
5 FB Feedback / adjust pin
6 PG Power-good (open drain)
7 GND Ground
8 NC No connect
Application Scenarios: In which products and applications is TPS7A4001DGNR used
  • RF transceiver and PLL VCO supply with 72dB PSRR and 13uVrms noise
  • High-precision ADC/DAC clean supply from 5V/3.3V pre-regulator
  • Test and measurement equipment requiring adjustable 1.2V-33V clean rail
  • Industrial sensor analog supply with reverse current protection
Alternative Models: What chips are recommended as replacements for TPS7A4001DGNR
Model Manufacturer Key Difference
TPS7A4001DCQR TI SOT-223 package version
TPS7A4501DGNR TI 20V, 1.5A version
TPS7A4701DGNR TI Lower noise, 1A, 20V
LT3042 ADI 0.8uVrms, 200mA

Recommend Parts

RK73H1ETTP20R0F

20Ohm +/-1% 0.063W thick film resistor, 0402, +/-100 ppm/C, AEC-Q200

Brand: KOA Speer

Package: 0402 (1005 Metric) 1.0 x 0.5 x 0.35 mm

IN STOCK: 33180pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS77001DBVR

50mA LDO, adjustable 1.2-5.5V out, 35mV dropout, 17µA IQ, SOT-23-5

Brand: TI

Package: SOT-23-5 (2.9 x 1.6 x 1.45 mm)

IN STOCK: 5000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TPS61021ADSGR

3A synchronous boost converter, 1.8-5.5V, VSSOP-8

Brand: TI

Package: VSSOP-8 (3.0 x 3.0 mm, DSG package)

IN STOCK: 12398pcs

Cargo cycle: 3-7 Days

The minimum order is 1

S1MB-13-F

1A 1000V GPP rectifier, 1.1V VF, 3μs trr, SMB/DO-214AA, -65~150°C

Brand: Diodes Inc

Package: SMB / DO-214AA (4.57 x 3.94 x 2.50mm)

IN STOCK: 3679pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADUM5000ARWZ-RL

500mW isolated DC-DC converter, 3.3/5V, SOIC-16W

Brand: ADI

Package: SOIC-16W (10.3 x 7.5 mm, RW package)

IN STOCK: 6373pcs

Cargo cycle: 3-7 Days

The minimum order is 1

ADS830E/2K5

8-bit 60MSPS high-speed ADC, TSSOP-24

Brand: TI

Package: TSSOP-24 (7.8 x 4.4 mm)

IN STOCK: 9357pcs

Cargo cycle: 3-7 Days

The minimum order is 1