Opens in a new tab

TPS563210ADDFR

3A sync buck, 4.5-17V in, D-CAP3, 600kHz, 55/33mΩ FETs, SOT-23-8

9870

Effective Inventory

Image for reference only

Manufacturer Part:

TPS563210ADDFR

Package:

SOT-23-8 (2.9 × 2.8 × 1.0 mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The TPS563210ADDFR is a 3A synchronous step-down converter from Texas Instruments with an input range of 4.5V to 17V. It features 600kHz switching frequency, integrated 55mΩ and 33mΩ MOSFETs, and D-CAP3 control mode for fast transient response without external compensation. Packaged in an 8-pin SOT-23 (DDF) package, it is the higher-current sibling of the TPS562210A.

Key Specifications

Function 3A Synchronous Step-Down Converter
Input Voltage 4.5V to 17V
Output Voltage 0.6V to 7V (adjustable)
Output Current 3A
Switching Frequency 600kHz
HS FET RDS(on) 55mΩ
LS FET RDS(on) 33mΩ
Control Mode D-CAP3 (emulated ripple)
Package 8-pin SOT-23 (2.9 × 2.8 mm)
Operating Temperature -40°C to +125°C (TJ)

Features

  • 3A output with 55mΩ/33mΩ integrated MOSFETs
  • D-CAP3 control mode eliminates external compensation
  • 600kHz switching frequency for compact solution size
  • Auto-skip mode for high light-load efficiency
  • Internal soft start and cycle-by-cycle overcurrent limit
  • Power-good output for supply monitoring

Applications

  • 12V rail POL conversion for processors and FPGAs
  • Networking and telecom equipment
  • Industrial automation controllers
  • Set-top boxes and consumer electronics
  • SSD and storage systems
Product Introduction: TPS563210ADDFR Product Introduction

The TPS563210A is a 3A synchronous step-down converter featuring TI’s D-CAP3 control mode for superior transient response without external compensation. It integrates low-RDS(on) 55mΩ high-side and 33mΩ low-side MOSFETs, achieving high efficiency across the full load range. With a 4.5V to 17V input and 0.6V to 7V adjustable output, it is ideal for point-of-load regulation from 12V or 5V bus architectures. The 600kHz switching frequency and D-CAP3 architecture allow a compact solution with only four external power components.

Working Principle: TPS563210ADDFR Working Principle

The TPS563210A uses TI’s D-CAP3 control mode, an adaptive on-time architecture with emulated internal ripple injection for stability without external compensation. The on-time is proportional to the input voltage to maintain near-constant switching frequency. When the FB pin voltage drops below the 0.6V internal reference, a new on-time pulse initiates. The integrated low-side MOSFET provides synchronous rectification during the off-time, improving efficiency compared to diode rectification. At light loads, auto-skip mode allows the low-side MOSFET to remain off when the inductor current reaches zero, preventing reverse current flow and improving efficiency. Overcurrent protection is implemented via cycle-by-cycle valley current limiting sensed through the low-side MOSFET RDS(on).

Pin Description: TPS563210ADDFR Pin Definition and Functions
Pin Name Type Function
1 VIN Power Input supply voltage (4.5-17V)
2 SW Output Switch node — connect to output inductor
3 GND Power Ground and thermal pad
4 FB Input Feedback — connect resistor divider from output
5 EN Input Enable — high enables the device
6 VREG5 Output Internal 5V LDO output — bypass with capacitor
7 PG Output Power-good open-drain output
8 PGND Power Power ground
Application Scenarios: In which products and applications is TPS563210ADDFR used
  • 12V to 1.0V core power for high-performance FPGAs
  • 5V to 3.3V regulation in networking switches
  • Industrial PLC distributed power architecture
  • SSD controller core and I/O power rails
  • Set-top box SoC power management
Alternative Models: What chips are recommended as replacements for TPS563210ADDFR
Manufacturer Part Number Package Notes
TI TPS562210ADDFR SOT-23-8 2A version of same family
TI TPS54360BDDAR HSOIC-8 3.5A, 60V input buck
Monolithic Power MP2144GD TSOT-23-8 3A buck, 1MHz
Richtek RT6215F SOT-23-8 3A buck, 500kHz
Infineon OPTI-MOS 3 PG-DSO-8 3A buck controller

Recommend Parts

ISO1176TDWR

Isolated RS-485 transceiver, 40Mbps, integrated transformer driver, SOIC-16

Brand: TI

Package: SOIC-16 (DW, wide-body, 10.3 x 10.3 mm)

IN STOCK: 6874pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFB4020PBF

200V N-Channel HEXFET Power MOSFET, 31A, 68 mΩ RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 14149pcs

Cargo cycle: 3-7 Days

The minimum order is 1

NRF52832-QFAA-T

Nordic BLE SoC, ARM Cortex-M4 @ 64MHz, 64KB Flash, 32KB RAM, QFN-48

Package: See datasheet

IN STOCK: 10958pcs

Cargo cycle: 3-7 Days

The minimum order is 1

UCC28740DR

CVCC Flyback Controller, 700V startup, opto feedback, <10mW no-load, SOIC-7

Brand: TI

Package: SOIC-7 (4.9 x 3.9 x 1.75 mm)

IN STOCK: 4840pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MMUN2211LT1G

NPN digital transistor, R1=10kΩ R2=10kΩ, 50V, 100mA, SOT-23-3, pre-biased BRT switch

Brand: Onsemi

Package: SOT-23-3 (TO-236, SC-59)

IN STOCK: 8500pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TMS320F2810PBKA

C2000 Delfino DSP controller, 150MHz, 128KB Flash, BGA-179

Brand: TI

Package: BGA-179 (16 x 16 mm, PBK package)

IN STOCK: 3124pcs

Cargo cycle: 3-7 Days

The minimum order is 1