Opens in a new tab

OPA333AIDBVR

Precision op-amp, zero-drift, 350kHz, 1.8-5.5V, SOT-23-5

7011

Effective Inventory

Image for reference only

Manufacturer Part:

OPA333AIDBVR

Package:

SOT-23-5 (2.9×1.6mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Other recommendations you may be interested in.

Description

Product Overview

The OPA333AIDBVR from TI is a zero-drift precision op-amp with 350kHz GBW, 10uV max offset, 0.02uV/C drift, and 1.8-5.5V supply in SOT-23-5 for precision measurement.

Key Specifications

Package SOT-23-5 (2.9×1.6mm)

Features

  • See datasheet for complete specifications
  • Industry-standard package

Applications

  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Power management
Product Introduction: OPA333AIDBVR Product Introduction

The OPA333AIDBVR from TI is a zero-drift precision op-amp with 350kHz GBW, 10uV max offset, 0.02uV/C drift, and 1.8-5.5V supply in SOT-23-5 for precision measurement.

Working Principle: OPA333AIDBVR Working Principle

The OPA333AIDBVR is a single zero-drift CMOS operational amplifier from Texas Instruments in SOT-23-5 (actually a SOT-23-8 variant for this part number), operating from 1.8V to 5.5V with 350kHz GBW and 17uA supply current. The zero-drift architecture uses auto-zeroing (chopper stabilization): the input offset voltage is continuously measured and cancelled every clock cycle (typically 8kHz internal chopping frequency). This results in a maximum offset voltage of 10uV over temperature (-40C to +125C) and virtually zero drift (0.05uV/C). The chopper technique also eliminates 1/f flicker noise, giving flat noise density of 55nV/sqrt(Hz) from DC to 400Hz. The input bias current is only 70pA (typical), suitable for high-impedance sensors like pH probes and photodiodes. The rail-to-rail output swings to within 50mV of the rails with a 10k-ohm load. The input common-mode range extends 100mV beyond the rails (RR I/O), a key advantage for single-supply designs. The auto-zeroing process creates small charge injection glitches at the chopping frequency, appearing as 55nV/sqrt(Hz) noise peaks at 8kHz and harmonics. For DC and low-frequency applications, these are negligible; for audio applications, a simple RC filter at 10kHz attenuates them below the noise floor.

Pin Description: OPA333AIDBVR Pin Definition and Functions
Pin Name Type Function
1 V+ Power Positive supply (1.8-5.5V)
2 IN- Input Inverting input
3 IN+ Input Non-inverting input
4 V- Power Negative supply (connect to GND for single-supply)
5 NC – No connect
6 OUT Output Amplifier output (rail-to-rail)
7 V+ Power Positive supply (connect to pin 1)
8 NC – No connect
Application Scenarios: In which products and applications is OPA333AIDBVR used
  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Power management
  • Alternative Models: What chips are recommended as replacements for OPA333AIDBVR
    Manufacturer Part Number Package Notes
    Texas Instruments OPA333AIDCKR SC-70-6 Same device, smaller package
    Analog Devices ADA4528-1ACBZ-R7 SOT-23-5 Zero-drift, 2.2V, ultra-low noise
    Microchip MCP6V01T-E/SN SOIC-8 Zero-drift, 1.8V, RR I/O
    Maxim MAX4238AUT+T SOT-23-6 Zero-drift, 1.8V, ultra-low offset
    Texas Instruments OPA335AIDBVR SOT-23-5 Zero-drift, 2.7V, auto-calibrating

    Recommend Parts

    MCP6S26-I

    6-channel PGA, SPI interface, gains 1-32V/V, 10MHz BW, rail-to-rail, 2.5-5.5V, SOIC-14

    Brand: MICROCHIP

    Package: SOIC-14 (150 mils body width)

    IN STOCK: 6800pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    W25Q80VSSI

    8Mbit Serial Flash, Quad SPI, 104MHz, SOIC-8, 2.7-3.6V

    Brand: Winbond

    Package: SOIC-8 208mil (5.3×8.0mm)

    IN STOCK: 4316pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    MM3Z9V1

    9.1V 200mW Zener diode, SOD-323, onsemi/Diotec

    Brand: ON

    Package: SOD-323 (2.5 x 1.25 x 0.85 mm)

    IN STOCK: 10735pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    AT89S51

    8-bit 8051 MCU, 4KB ISP Flash, 128B RAM, 32 I/O, 2 timers, UART, watchdog timer, dual DPTR, 33MHz, ISP programming, PDIP-40, Atmel AT89S51.

    Package: PDIP-40 / TQFP-44 / PLCC-44

    IN STOCK: 15000pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    GD32F303CBT6

    Cortex-M4 32-bit MCU, 120MHz, 128KB Flash, 32KB SRAM, LQFP-48

    Brand: gigadevice

    Package: LQFP-48 (7x7mm, 0.5mm pitch)

    IN STOCK: 3342pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    MIC5205-3.3YM5-TR

    3.3V 150mA ultra-low-noise LDO, 165mV dropout, 30uVrms noise, SOT-23-5

    Brand: MICROCHIP

    Package: SOT-23-5 (2.9 x 1.6 x 1.1mm)

    IN STOCK: 9858pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1