Opens in a new tab

LTC3676EUJ#TRPBF

4-channel DC-DC PMIC for i.MX, 2x buck 2.5A, 2x buck 1A, QFN-40

2488

Effective Inventory

Image for reference only

Manufacturer Part:

LTC3676EUJ#TRPBF

Package:

QFN-40 (6x6mm)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The LTC3676EUJ#TRPBF from Analog Devices is a 4-channel PMIC with two 2.5A bucks and two 1A bucks, designed to power i.MX processors in portable devices with I2C control and power sequencing.

Key Specifications

Package QFN-40 (6x6mm)

Features

  • See datasheet for complete specifications
  • Industry-standard package

Applications

  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
Product Introduction: LTC3676EUJ#TRPBF Product Introduction

The LTC3676EUJ#TRPBF from Analog Devices is a 4-channel PMIC with two 2.5A bucks and two 1A bucks, designed to power i.MX processors in portable devices with I2C control and power sequencing.

Working Principle: LTC3676EUJ#TRPBF Working Principle

The LTC3676EUJ#TRPBF is a 4-channel DC-DC PMIC (Power Management IC) from Analog Devices in QFN-40 (6x6mm), designed to power Freescale/NXP i.MX application processors. It integrates: two 2.5A step-down buck regulators (Buck1, Buck2) for core and DDR rails; two 1A step-down buck regulators (Buck3, Buck4) for I/O and peripheral rails; and four 300mA LDO regulators (LDO1-4) for low-noise analog and PLL supplies. Each buck regulator uses constant-on-time (COT) control with valley current mode, providing fast transient response (typical 5us from 10% to 90% load step) essential for processor core rails. The switching frequency is 2.25MHz, allowing small 0.47-2.2uH inductors in 0805 or 1008 footprint. All regulators are programmable via I2C (400kHz), allowing dynamic voltage scaling (DVS): the I2C interface can adjust output voltages in 25mV steps during operation, enabling DVFS (Dynamic Voltage and Frequency Scaling) for power savings. The WAKE pin initiates power-up sequencing: a LOW-to-HIGH transition starts the pre-programmed power-up sequence (Buck1 first, then Buck2, then LDOs). The PGOOD pin indicates all rails are within regulation. Each regulator has independent enable pins (EN1-4) for manual control. The device supports multiple operating states: RUN (all rails active), STANDBY (LDOs only), and SHUTDOWN (all off, 10uA Iq). The I2C registers store configuration, fault status, and voltage settings. The -EUJ suffix specifies QFN-40, and #TRPBF specifies tape-and-reel, lead-free.

Pin Description: LTC3676EUJ#TRPBF Pin Definition and Functions
Pin Name Type Function
1-4 SW1/BOOT1/PVIN1/EN1 I/O/Power Buck1 switch node / bootstrap / input / enable
5-8 SW2/BOOT2/PVIN2/EN2 I/O/Power Buck2 switch node / bootstrap / input / enable
9-12 SW3/BOOT3/PVIN3/EN3 I/O/Power Buck3 switch node / bootstrap / input / enable
13-16 SW4/BOOT4/PVIN4/EN4 I/O/Power Buck4 switch node / bootstrap / input / enable
17-20 LDO1/LDO2/LDO3/LDO4 Output Four linear regulator outputs (1.2V-3.3V)
21-24 VINA/SCL/SDA/WAKE Power/I/O Analog supply / I2C clock / I2C data / wake input
25-40 PGOOD/VFB1-4/GND/Exposed Pad Output/Power Power good / feedback / ground / thermal pad
Application Scenarios: In which products and applications is LTC3676EUJ#TRPBF used
  • Industrial control
  • Consumer electronics
  • Communication equipment
  • Automotive electronics
  • Alternative Models: What chips are recommended as replacements for LTC3676EUJ#TRPBF
    Manufacturer Part Number Package Notes
    Analog Devices LTC3676EUJ#TRPBF QFN-40 Same device, ADI brand
    Analog Devices LTC3675EUJ#PBF QFN-40 3 buck + 3 LDO version, slightly fewer rails
    Texas Instruments TPS65218D0 QFN-48 6-rail PMIC for Sitara, I2C controlled
    Richtek RT5028AGQW QFN-40 4 buck + 4 LDO PMIC for tablet, similar
    NXP PF0100F2AEP BGA-56 Multi-rail PMIC for i.MX, similar complexity

    Recommend Parts

    0751.0505

    Schurter fuse, 0751.0505

    Brand: schurter

    Package: See datasheet

    IN STOCK: 6768pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    TL062CDR

    Low-power JFET-input dual op-amp, 1MHz GBW, 30pA Ibias, SOIC-8, ±3.5V to ±18V

    Brand: TI

    Package: SOIC-8 (3.9 x 4.9 x 1.75mm)

    IN STOCK: 11576pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    P89LPC922FN

    8-bit 80C51 MCU, 8KB Flash, 256B RAM, 20-SSOP

    Brand: NXP

    Package: SSOP-20 (7.2 x 5.3 mm)

    IN STOCK: 12628pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    AC0603JR-070RL

    Chip Resistor, 0Ω (Zero Ohm Jumper), ±5%, 0603 (1608 Metric), 1/10W (100mW)

    Brand: Yageo

    Package: 0603 (1608 Metric)

    IN STOCK: 100000pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    LMR34206FSC5RNXRQ1

    42V 2A sync buck, 5V fixed, 2.2MHz, 18uA Iq, AEC-Q100, SOT-563

    Brand: TI

    Package: SOT-563 (1.6 x 1.2 x 0.55mm)

    IN STOCK: 6500pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1

    AO3402

    30V N-channel trench MOSFET, SOT-23, 4A, RDS(on) 52m ohm max @ 10V, Qg 10nC, 2.5V gate drive capable, -55C to +150C.

    Brand: aosmd

    Package: SOT-23 (2.9 x 1.6 x 1.25mm)

    IN STOCK: 14066pcs

    Cargo cycle: 3-7 Days

    The minimum order is 1