Opens in a new tab

SN65HVD1781DR

70V fault-protected RS-485 transceiver, 3.3-5V, 1Mbps, ±16kV ESD, 320 nodes in SOIC-8

7300

Effective Inventory

Image for reference only

Manufacturer Part:

SN65HVD1781DR

Package:

SOIC-8 (4.90 x 3.90 x 1.75 mm) D-8

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The SN65HVD1781DR from Texas Instruments is a fault-protected RS-485/RS-422 transceiver in an SOIC-8 package. It provides ±70V bus-pin fault protection, ±16kV HBM ESD protection, and operates from 3.3V to 5V supply. With 1/10 unit load, up to 320 nodes can share a single bus. The device supports signaling rates up to 1Mbps and features a low 1µA standby current.

Key Specifications

Bus-Pin Fault Protection ±70V
Signaling Rate Up to 1Mbps
Supply Voltage 3.3V ~ 5V
ESD Protection ±16kV HBM on bus pins
Unit Load 1/10 (up to 320 nodes)
Standby Current 1µA (Maximum)
Operating Current 4mA (Quiescent)
Package SOIC-8 (4.90 x 3.90mm)
Operating Temperature -40°C ~ +125°C

Features

  • ±70V bus-pin fault protection against mis-wiring
  • ±16kV HBM ESD protection on bus pins
  • 3.3V to 5V single supply operation
  • 1/10 unit load for up to 320 transceivers on one bus
  • Failsafe receiver for open, short, and idle bus conditions
  • Low 1µA maximum standby supply current
  • Pin-compatible with industry-standard SN75176

Applications

  • HVAC networks
  • Building automation
  • Industrial networks
  • Security electronics
  • Telecommunication equipment
Product Introduction: SN65HVD1781DR Product Introduction

The SN65HVD1781DR is designed to survive overvoltage faults such as direct shorts to power supplies, mis-wiring faults, connector failures, and cable crushes. The ±70V bus-pin fault protection far exceeds the ±12V common-mode range required by the RS-485 standard. The device combines a differential driver and differential receiver operating from a single 3.3V to 5V supply. It is pin-compatible with the industry-standard SN75176, making it a drop-in upgrade with significantly improved fault tolerance.

Working Principle: SN65HVD1781DR Working Principle

The SN65HVD1781 uses a differential signaling scheme where data is transmitted as a voltage difference between the A and B bus lines. The driver converts single-ended TXD input into differential bus signals, while the receiver converts differential bus signals back to single-ended RXD output. The ±70V fault protection is achieved through robust bus-pin circuitry that can withstand accidental connection to power supplies. The failsafe receiver biases the output high when the bus is open, shorted, or idle (all drivers off), preventing undefined output states. The 1/10 unit load design reduces bus loading to allow 320 transceivers on a single bus.

Pin Description: SN65HVD1781DR Pin Definition and Functions
Pin Name Function
1 R Receiver output (CMOS compatible)
2 /RE Receiver enable (active low)
3 DE Driver enable (active high)
4 D Driver input (CMOS compatible)
5 GND Ground reference
6 A Bus side non-inverting I/O
7 B Bus side inverting I/O
8 VCC Supply voltage (3.3V or 5V)
Application Scenarios: In which products and applications is SN65HVD1781DR used
  • Building Automation Bus: ±70V fault protection survives mis-wiring during building construction and maintenance
  • Industrial Multi-Drop Network: 1/10 unit load allows 320 sensor nodes on a single RS-485 bus segment
  • Security System Interconnect: Failsafe receiver ensures defined state during cable cuts or connector failures
  • 3.3V MCU Interface: 3.3V operation eliminates level shifting when used with modern low-voltage microcontrollers
Alternative Models: What chips are recommended as replacements for SN65HVD1781DR
Model Manufacturer Key Difference
SN65HVD1780DR TI Full-duplex version (separate TX/RX pins)
SN65HVD1782DR TI ±30V fault protection, 10Mbps
THVD1500DR TI 500kbps, lower cost, 3.3-5V
SP3485EN MaxLinear 3.3V, 10Mbps, SOIC-8
ADM3485EARZ ADI 3.3V, 12Mbps, ±15kV ESD

Recommend Parts

ISO1176TDWR

Isolated RS-485 transceiver, 40Mbps, integrated transformer driver, SOIC-16

Brand: TI

Package: SOIC-16 (DW, wide-body, 10.3 x 10.3 mm)

IN STOCK: 6874pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFB4020PBF

200V N-Channel HEXFET Power MOSFET, 31A, 68 mΩ RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 14149pcs

Cargo cycle: 3-7 Days

The minimum order is 1

NRF52832-QFAA-T

Nordic BLE SoC, ARM Cortex-M4 @ 64MHz, 64KB Flash, 32KB RAM, QFN-48

Package: See datasheet

IN STOCK: 10958pcs

Cargo cycle: 3-7 Days

The minimum order is 1

UCC28740DR

CVCC Flyback Controller, 700V startup, opto feedback, <10mW no-load, SOIC-7

Brand: TI

Package: SOIC-7 (4.9 x 3.9 x 1.75 mm)

IN STOCK: 4840pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MMUN2211LT1G

NPN digital transistor, R1=10kΩ R2=10kΩ, 50V, 100mA, SOT-23-3, pre-biased BRT switch

Brand: Onsemi

Package: SOT-23-3 (TO-236, SC-59)

IN STOCK: 8500pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TMS320F2810PBKA

C2000 Delfino DSP controller, 150MHz, 128KB Flash, BGA-179

Brand: TI

Package: BGA-179 (16 x 16 mm, PBK package)

IN STOCK: 3124pcs

Cargo cycle: 3-7 Days

The minimum order is 1