Opens in a new tab

SN74HC541N

Octal buffer/driver, 3-state, 2 OE pins, HC CMOS 2-6V, PDIP-20

9500

Effective Inventory

Image for reference only

Manufacturer Part:

SN74HC541N

Package:

PDIP-20 (24.33 x 6.35 x 5.08mm, 2.54mm pitch, through-hole)

Brand:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The SN74HC541N is an octal buffer/line driver with 3-state outputs from Texas Instruments, featuring output enable and HC CMOS technology in a 20-pin PDIP package.

Key Specifications

Number of Channels 8 (octal buffer)
Logic Family HC (High-speed CMOS)
Supply Voltage 2V to 6V
Output Type 3-state (high-impedance when disabled)
Output Enable 2 active-low OE pins (OE1, OE2)
Propagation Delay 18ns max at 5V
Output Drive ±6mA at 5V
Input Type Standard CMOS
Polarity Non-inverting
Operating Temperature -40°C to +85°C
Package PDIP-20 (24.33 x 6.35mm)

Features

  • 8-bit non-inverting buffer with 3-state outputs
  • Dual active-low output enable (both must be low to enable)
  • Wide 2V to 6V operating voltage
  • High-impedance outputs when disabled
  • HC CMOS low power consumption
  • Directly drives bus lines
  • Suitable for driving heavy capacitive loads

Applications

  • Bus driver and buffer
  • Memory address driver
  • Clock driver and buffer
  • Microprocessor I/O port isolation
  • General-purpose logic buffer
Product Introduction: SN74HC541N Product Introduction

The SN74HC541N from Texas Instruments is an octal buffer and line driver with 3-state outputs and dual active-low output enable pins in a 20-pin PDIP through-hole package. The device provides non-inverting buffering of 8 data lines. The two output enable pins (OE1 and OE2) are both active-low; both must be low to enable the outputs. When either OE pin is high, all outputs enter the high-impedance state, allowing connection to shared bus lines. The HC (High-speed CMOS) technology provides 2V to 6V operating voltage range with low quiescent current. The ±6mA output drive at 5V can drive moderate capacitive loads on bus lines. The N suffix denotes the PDIP-20 through-hole package.

Working Principle: SN74HC541N Working Principle

The SN74HC541N contains eight identical non-inverting buffer elements with a common output enable control. Each buffer passes the input signal to the output without inversion. The output enable logic ANDs the two active-low OE pins: when both OE1 and OE2 are low, the outputs follow the inputs (after the propagation delay). When either OE1 or OE2 is high, all eight outputs enter the high-impedance (3-state) state, effectively disconnecting the buffer from the bus. This allows multiple buffers to share a common bus without contention, as only one buffer is enabled at a time. The non-inverting nature preserves the original signal polarity, making the device suitable for address and data bus buffering where signal integrity must be maintained.

Pin Description: SN74HC541N Pin Definition and Functions
Pin Name Type Description
1 OE1 Input Output enable 1 (active low)
2-9 1A-8A Input Data inputs (8 bits)
10 GND Power Ground
11-18 8Y-1Y Output Data outputs (8 bits, 3-state)
19 OE2 Input Output enable 2 (active low)
20 VCC Power Supply (2V to 6V)

SN74HC541N uses the PDIP-20 package: VCC at Pin 20, GND at Pin 10. Eight non-inverting buffer/line drivers: inputs on Pins 2-9, outputs on Pins 18-11. Two active-low output enable controls: OE1=Pin 1, OE2=Pin 19. Both enables must be LOW for outputs to be active; either enable HIGH forces all outputs to high impedance. The dual-enable architecture allows simple expansion to wider bus widths. Unlike the 74HC245 transceiver, the 541 is unidirectional (input to output only) with 3-state outputs. Output drive capability is ±6mA at 5V. For bidirectional version, use SN74HC245N. For inverting buffer, use SN74HC540N (same pinout, inverted outputs).

Application Scenarios: In which products and applications is SN74HC541N used
  • Bus Driving: 3-state outputs connect to shared address/data buses; dual OE allows independent enable from two controllers
  • Memory Interface: Drives memory address lines with sufficient fan-out for multiple memory chips
  • Clock Buffer:

    Non-inverting buffer distributes clock signals without phase inversion

  • I/O Isolation: High-impedance mode isolates MCU pins from bus during reset or debug
  • Logic Level: 2V-6V range bridges between 3.3V and 5V systems (check VCC compatibility)
Alternative Models: What chips are recommended as replacements for SN74HC541N
Model Manufacturer Key Difference Package Supply
74HC541D TI/Nexperia CMOS version with wide 2-6V supply range, lower power consumption and higher noise immunity SOIC-20 2-6V CMOS
74HC541N TI/Nexperia Through-hole DIP version of HC family for prototyping and repair DIP-20 2-6V CMOS
74HCT541D TI/Nexperia CMOS with TTL-compatible input levels, ideal for mixing with LS devices at 5V SOIC-20 4.5-5.5V TTL-in
74HCT541N TI/Nexperia Through-hole DIP version of HCT family for prototyping and repair DIP-20 4.5-5.5V TTL-in
74LVC541D TI/Nexperia Low-voltage CMOS for 1.65-3.6V modern logic with 24mA output drive and bus-hold inputs SOIC-20 1.65-3.6V CMOS
74LVC541N TI/Nexperia Through-hole DIP version of LVC family for prototyping and repair DIP-20 1.65-3.6V CMOS

The 74541 is a Octal Buffer/Driver with 3-State Output. Family variants span from the original LS TTL (5V only) to modern LVC/AUP (down to 0.8V). HC and HCT versions offer 2-6V CMOS operation with HCT providing TTL-compatible input thresholds for mixed 5V systems. CD4000-series equivalents offer the widest 3-18V supply range at the cost of lower switching speed. DIP packages (N suffix) are through-hole; SOIC (D suffix) and TSSOP are surface-mount.

Recommend Parts

0751.0505

Schurter fuse, 0751.0505

Brand: schurter

Package: See datasheet

IN STOCK: 6768pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TL062CDR

Low-power JFET-input dual op-amp, 1MHz GBW, 30pA Ibias, SOIC-8, ±3.5V to ±18V

Brand: TI

Package: SOIC-8 (3.9 x 4.9 x 1.75mm)

IN STOCK: 11576pcs

Cargo cycle: 3-7 Days

The minimum order is 1

P89LPC922FN

8-bit 80C51 MCU, 8KB Flash, 256B RAM, 20-SSOP

Brand: NXP

Package: SSOP-20 (7.2 x 5.3 mm)

IN STOCK: 12628pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AC0603JR-070RL

Chip Resistor, 0Ω (Zero Ohm Jumper), ±5%, 0603 (1608 Metric), 1/10W (100mW)

Brand: Yageo

Package: 0603 (1608 Metric)

IN STOCK: 100000pcs

Cargo cycle: 3-7 Days

The minimum order is 1

LMR34206FSC5RNXRQ1

42V 2A sync buck, 5V fixed, 2.2MHz, 18uA Iq, AEC-Q100, SOT-563

Brand: TI

Package: SOT-563 (1.6 x 1.2 x 0.55mm)

IN STOCK: 6500pcs

Cargo cycle: 3-7 Days

The minimum order is 1

AO3402

30V N-channel trench MOSFET, SOT-23, 4A, RDS(on) 52m ohm max @ 10V, Qg 10nC, 2.5V gate drive capable, -55C to +150C.

Brand: aosmd

Package: SOT-23 (2.9 x 1.6 x 1.25mm)

IN STOCK: 14066pcs

Cargo cycle: 3-7 Days

The minimum order is 1