Opens in a new tab

Home » Integrated Circuits ICs » TLV9001SIDBVR

TLV9001SIDBVR

1MHz RRIO CMOS op-amp, 1.8-5.5V, 60µA Iq, SOT-23-5, Texas Instruments

50000

Effective Inventory

Image for reference only

Manufacturer Part:

TLV9001SIDBVR

Package:

SOT-23-5 (DBV) 2.9×2.8mm

Product Categories:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

Product Overview

The Texas Instruments TLV9001SIDBVR is a single-channel, low-power, rail-to-rail input/output (RRIO) operational amplifier optimized for cost-sensitive applications. With a 1MHz unity-gain bandwidth, 60µA quiescent current, and operation from 1.8V to 5.5V, it is ideal for battery-powered and space-constrained designs. The device features an integrated RFI/EMI rejection filter and is unity-gain stable.

Key Specifications

Number of Channels 1 (Single)
Supply Voltage Range 1.8V to 5.5V
Gain-Bandwidth Product 1 MHz (typ)
Slew Rate 2 V/µs (typ)
Input Offset Voltage ±0.4 mV (typ), ±1.6 mV (max)
Offset Drift 0.6 µV/°C (typ)
Quiescent Current 60 µA/ch (typ)
Input Bias Current 5 pA (typ)
Voltage Noise 27 nV/√Hz (typ at 1kHz)
CMRR 95 dB (typ)
Output Current 40 mA (typ)
Capacitive Load Drive 500 pF (direct), higher with resistive output impedance
Operating Temperature -40°C to +125°C
Package SOT-23-5 (DBV), 2.9×2.8mm

Features

  • Rail-to-rail input and output (RRIO) for maximum signal swing
  • Scalable CMOS amplifier family (single/dual/quad versions available)
  • Integrated RFI and EMI rejection filter for noise immunity
  • Unity-gain stable with no phase reversal in overdrive
  • Low input offset voltage: ±0.4mV typical
  • Very low input bias current: 5pA
  • Operation at supply voltages as low as 1.8V
  • Resistive open-loop output impedance for easy capacitive load stabilization
  • Shutdown mode available (TLV9001S variant, <1µA standby)

Applications

  • Sensor signal conditioning
  • Low-side current sensing
  • Active filters
  • Smoke detectors
  • Wearable devices
  • Home appliances and HVAC controls
  • Barcode scanners and POS terminals
  • Photodiode amplifiers
Product Introduction: TLV9001SIDBVR Product Introduction

The Texas Instruments TLV9001SIDBVR is a single-channel, low-power, rail-to-rail input/output operational amplifier in a 5-pin SOT-23 package. Optimized for cost-sensitive applications, it offers 1MHz gain-bandwidth product, 2V/µs slew rate, and only 60µA quiescent current per channel. The CMOS architecture provides low input offset voltage (±0.4mV typ), ultra-low input bias current (5pA), and rail-to-rail common-mode range. An integrated RFI/EMI rejection filter enhances noise immunity in harsh environments. The device operates from 1.8V to 5.5V and is unity-gain stable with resistive open-loop output impedance, enabling direct drive of capacitive loads up to 500pF.

Working Principle: TLV9001SIDBVR Working Principle

The TLV9001 is a CMOS operational amplifier using a folded-cascode input stage with rail-to-rail input common-mode range achieved by two complementary differential input pairs (N-channel and P-channel) operating in parallel. The input stage includes an integrated RFI/EMI filter (low-pass at approximately 80kHz) to reject high-frequency interference before it reaches the sensitive input transistors. The output stage uses a class-AB topology with rail-to-rail output swing, achieving output voltages within millivolts of the supply rails. The resistive open-loop output impedance (rather than inductive) means the amplifier can directly drive capacitive loads without oscillation in most configurations. Unity-gain stability is achieved through internal Miller compensation. No phase reversal occurs under input overdrive conditions, a common failure mode in older CMOS op-amps.

Pin Description: TLV9001SIDBVR Pin Definition and Functions
Application Scenarios: In which products and applications is TLV9001SIDBVR used
Alternative Models: What chips are recommended as replacements for TLV9001SIDBVR

TLV9002 (dual channel, SOIC-8/MSOP-8); TLV9004 (quad channel, SOIC-14/TSSOP-14); TLV9001S (with shutdown, SOT-23-6); OPA376 (TI, lower noise); MCP6001 (Microchip, similar specs); LMV321 (TI/National, lower performance, lower cost)

Recommend Parts

ISO1176TDWR

Isolated RS-485 transceiver, 40Mbps, integrated transformer driver, SOIC-16

Brand: TI

Package: SOIC-16 (DW, wide-body, 10.3 x 10.3 mm)

IN STOCK: 6874pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFB4020PBF

200V N-Channel HEXFET Power MOSFET, 31A, 68 mΩ RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 14149pcs

Cargo cycle: 3-7 Days

The minimum order is 1

NRF52832-QFAA-T

Nordic BLE SoC, ARM Cortex-M4 @ 64MHz, 64KB Flash, 32KB RAM, QFN-48

Package: See datasheet

IN STOCK: 10958pcs

Cargo cycle: 3-7 Days

The minimum order is 1

UCC28740DR

CVCC Flyback Controller, 700V startup, opto feedback, <10mW no-load, SOIC-7

Brand: TI

Package: SOIC-7 (4.9 x 3.9 x 1.75 mm)

IN STOCK: 4840pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MMUN2211LT1G

NPN digital transistor, R1=10kΩ R2=10kΩ, 50V, 100mA, SOT-23-3, pre-biased BRT switch

Brand: Onsemi

Package: SOT-23-3 (TO-236, SC-59)

IN STOCK: 8500pcs

Cargo cycle: 3-7 Days

The minimum order is 1

TMS320F2810PBKA

C2000 Delfino DSP controller, 150MHz, 128KB Flash, BGA-179

Brand: TI

Package: BGA-179 (16 x 16 mm, PBK package)

IN STOCK: 3124pcs

Cargo cycle: 3-7 Days

The minimum order is 1