Opens in a new tab

DMP2022LSS-13

-20V P-ch MOSFET, -10A, 13mOhm@-10V, 56.9nC Qg, SO-8, AEC-Q101, load switch

4342

Effective Inventory

Image for reference only

Manufacturer Part:

DMP2022LSS-13

Package:

SO-8 / SOP-8 (5.0 x 4.0 x 1.5 mm, 1.27mm pitch, gull-wing)

Product Categories:

Quality Commitment

Shipping & Payment

Service & Packaging

Product Manual

Description

The DMP2022LSS-13 from Diodes Incorporated is a -20 V P-channel enhancement-mode power MOSFET in an SO-8 package. It features 13 mOhm maximum RDS(on) at VGS = -10 V, -10 A continuous drain current, 56.9 nC maximum gate charge at -10 V, and 2.5 W power dissipation. Key features include low threshold voltage (600-770 mV), low input capacitance (2444 pF), AEC-Q101 qualification, and built-in body diode. Operating temperature range is -55C to +150C. The -13 suffix denotes 2500-unit tape-and-reel packaging.

Product Introduction: DMP2022LSS-13 Product Introduction

The DMP2022LSS-13 from Diodes Incorporated is a -20 V P-channel enhancement-mode power MOSFET in an industry-standard SO-8 package with tape-and-reel packaging (2500 units per reel). The DMP2022LSS is also available without the -13 suffix (same device, different packaging format).

The device features ultra-low 13 mOhm maximum RDS(on) at VGS = -10 V, making it one of the lowest RDS(on) P-channel MOSFETs available in the SO-8 package. At VGS = -4.5 V, RDS(on) is 16 mOhm maximum, and at -2.5 V, it is 22 mOhm maximum. This logic-level drive performance enables direct MCU GPIO drive at 2.5 V and above for load-switch applications.

The -10 A continuous drain current rating and -90 A pulsed drain current provide substantial current handling for battery-powered and power-management applications. The 2.5 W power dissipation at 25C ambient (RthJA = 50C/W) requires adequate PCB copper area on the drain pins for thermal management.

The low threshold voltage (600-770 mV max at 250 uA) ensures the device turns on fully with modest gate drive voltage. However, care must be taken in high-temperature applications where off-state leakage can increase significantly with the low threshold.

The DMP2022LSS is AEC-Q101 qualified, making it suitable for automotive applications. An automotive-specific datasheet (DMP2022LSSQ) is available under separate documentation. The device is also halogen-free and antimony-free (green device).

The SO-8 package dedicates pins 1-3 to source, pin 4 to gate, and pins 5-8 to drain, providing low-inductance connections and efficient thermal transfer through the drain pins to the PCB copper.

Working Principle: DMP2022LSS-13 Working Principle

**P-Channel Enhancement MOSFET:** The DMP2022LSS is a P-channel enhancement-mode MOSFET. Current flows from source to drain when the gate-source voltage is negative (VGS < VGS(th)). When VGS is 0 V (gate at source potential), no channel forms and the device is off. Applying a negative VGS creates an inversion layer (P-type channel) between source and drain.

**Trench MOSFET Technology:** The device uses trench gate technology where the gate electrode is formed in vertical trenches etched into the silicon. This maximizes channel width per unit die area, achieving the ultra-low 13 mOhm RDS(on). The 2444 pF input capacitance and 56.9 nC gate charge reflect the large die area needed for this low RDS(on).

**High-Side Switch Advantage:** P-channel MOSFETs are preferred for high-side load switching because the gate can be pulled low relative to the source (connected to VCC) to turn on the device. No bootstrap circuit or charge pump is needed, unlike N-channel high-side switches. This simplifies the gate drive circuit significantly.

**Body Diode:** The inherent body diode from drain to source (anode at drain, cathode at source) has a forward voltage of approximately 0.9-1.2 V. This diode conducts during dead-time in bridge configurations but is not designed for continuous current rectification.

Pin Description: DMP2022LSS-13 Pin Definition and Functions
Pin Name Type Description
1 Source P/G Source terminal; typically connected to VCC rail for high-side switching; 10A continuous; three source pins reduce resistance
2 Source P/G Source terminal (parallel with pins 1, 3); body diode cathode
3 Source P/G Source terminal (parallel with pins 1, 2)
4 Gate I Gate input; VGS(th) 600-770mV; VGS max +/-12V; 56.9nC gate charge@-10V; drive from MCU GPIO through resistor; pull-up to source for off-state
5 Drain O Drain terminal; -20V max VDS; -10A continuous; 13mOhm RDS(on)@-10V; connect to load; primary thermal path; solder to copper pour
6 Drain O Drain terminal (parallel with pins 5, 7, 8); body diode anode
7 Drain O Drain terminal (parallel with pins 5, 6, 8)
8 Drain O Drain terminal (parallel with pins 5, 6, 7)
Application Scenarios: In which products and applications is DMP2022LSS-13 used
Application Description
High-Side Load Switch P-channel high-side switch for 5V/12V power rails; gate pulled to source for off, pulled to GND for on; 13mOhm@-10V gives only 130mV drop at 10A; MCU GPIO drives gate through 10kOhm resistor; AEC-Q101 for automotive use
Battery Disconnect Switch Li-ion battery disconnect in portable devices; -20V rating covers 3S-4S packs (12.6-16.8V); source to battery+, drain to system; 16mOhm@-4.5V from MCU 3.3V GPIO; low IQ when off (gate pulled to source)
Alternative Models: What chips are recommended as replacements for DMP2022LSS-13
Model Manufacturer Compatibility Key Difference
IRLML6401TRPBF Infineon Smaller Package Alternative -12V P-ch; -4.3A; 50mOhm@-4.5V; SOT-23; much lower current; smaller footprint; use for light-load switching
AO3401A Alpha & Omega SOT-23 Upgrade -30V P-ch; -4.3A; 36mOhm@-4.5V; SOT-23; lower RDS(on) and higher voltage in same footprint
Si4435DY Vishay Higher Current Alternative -30V P-ch; -8.5A; 20mOhm@-10V; SO-8; higher voltage rating; Vishay-sourced

Recommend Parts

ISL95855HRTZ-T

IMVP8 3+2+1 phase buck controller, R3 technology, 4.5-25V input, 48-TQFN

Brand: Renesas

Package: 48-TQFN (6×6 mm, exposed pad)

IN STOCK: 2156pcs

Cargo cycle: 3-7 Days

The minimum order is 1

IRFB4019PBF

150V N-Channel HEXFET Power MOSFET, 47A, 34 mΩ RDS(on), TO-220AB

Brand: infineon

Package: TO-220AB

IN STOCK: 2409pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MSP430F247TPMR

TI MSP430 MCU, 16-bit RISC, 92KB Flash, 8KB RAM, 16MHz, LQFP-64

Package: See datasheet

IN STOCK: 13371pcs

Cargo cycle: 3-7 Days

The minimum order is 1

NUC029LAN

ARM Cortex-M0 MCU, 50MHz, 64KB Flash, 4KB SRAM, dual UART/SPI/I2C, LQFP-48

Brand: Nuvoton

Package: LQFP-48 (7.0 x 7.0 x 1.45 mm)

IN STOCK: 12385pcs

Cargo cycle: 3-7 Days

The minimum order is 1

MMUN2211LT1G

NPN digital transistor, R1=10kΩ R2=10kΩ, 50V, 100mA, SOT-23-3, pre-biased BRT switch

Brand: Onsemi

Package: SOT-23-3 (TO-236, SC-59)

IN STOCK: 8500pcs

Cargo cycle: 3-7 Days

The minimum order is 1

PIC32MX795F512L-80I/PF

32-bit PIC32MX MCU with Ethernet/CAN/USB, 80MHz, 512KB Flash, TQFP-100, industrial

Brand: MICROCHIP

Package: TQFP-100 (14 x 14 mm)

IN STOCK: 7912pcs

Cargo cycle: 3-7 Days

The minimum order is 1